National Highway Traffic Safety Administration – Federal Register Recent Federal Regulation Documents

General Motors, LLC (GM) has determined that certain model year 2013 Chevrolet Malibu passenger cars manufactured between June 21, 2011 and July 24, 2012, do not fully comply with paragraphs S3.1.4.1 (a) and (b) of Federal Motor Vehicle Safety Standard (FMVSS) No. 102, Transmission Shift Position Sequence, Starter Interlock, and Transmission Braking Effect. GM has filed an appropriate report dated August 3, 2012, pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports.

This notice provides NHTSA's finding with respect to three requests from the North Carolina Department of Transportation, Governor's Highway Safety Program (NCGHSP) to waive the Buy America requirement. NHTSA finds that a non-availability waiver of the Buy America requirement is inappropriate for the purchase of seven different models of child safety seats because there are comparable products produced in the United States. In addition, NHTSA finds that a non-availability waiver is appropriate for NCGHSP to purchase e- citation printers, and HP printer cartridges and imaging drums because there are no comparable products produced domestically.

Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections. This document describes an existing collection of information for motor vehicle tire and rim labeling requirements for which NHTSA intends to seek renewed OMB approval. The Federal Register notice with a 60-day comment period was published on November 25, 2014 (79 FR 70274).

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below is being forwarded to the Office of Management and Budget (OMB) for review and comments. A Federal Register Notice with a 60-day comment period soliciting comments on the following information collection was published on December 5, 2014, 79 FR 72243-72244.

Harley-Davidson Motor Company, Inc. (Harley-Davidson) has determined that certain MY 2015 Harley-Davidson model XG500 and model XG750 motorcycles do not fully comply with speedometer markings as specified in table 3, footnote 4, of Federal Motor Vehicle Safety Standard (FMVSS) No. 123, Motorcycle Controls and Displays. Harley- Davidson has filed an appropriate report dated September 3, 2014, pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below is being forwarded to the Office of Management and Budget (OMB) for review and comments. A Federal Register Notice with a 60-day comment period soliciting comments on the following information collection was published on November 25, 2014, 79 FR 70275-70276.

Toyota Motor Engineering & Manufacturing North America, Inc., on behalf of Toyota Motor Corporation and certain Toyota manufacturing entities (collectively referred to as ``Toyota'') have determined that specific model year (MY) 2013-2014 Toyota vehicles do not fully comply with paragraph S4 of Federal Motor Vehicle Safety Standard (FMVSS) No. 302, Flammability of Interior Materials. Toyota has filed an appropriate report dated January 29, 2014 as amended on February 20, 2014 pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports.

NHTSA seeks comments on the economic impact of its regulations on small entities. As required by Section 610 of the Regulatory Flexibility Act, we are attempting to identify rules that may have a significant economic impact on a substantial number of small entities. We also request comments on ways to make these regulations easier to read and understand. The focus of this notice is rules that specifically relate to passenger cars, multipurpose passenger vehicles, trucks, buses, trailers, motorcycles, and motor vehicle equipment.

Custom Glass Solutions Upper Sandusky Corporation (Custom Glass), a subsidiary of Guardian Industries Corporation, has determined that certain laminated glass panes, other than windscreens, do not fully comply with paragraph S6 of Federal Motor Vehicle Safety Standard (FMVSS) No. FMVSS 205, Glazing Materials. Custom Glass has filed an appropriate report dated September 17, 2013, pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports.

In accordance with NHTSA's 2011-2013 Priority Plan and the Moving Ahead for Progress in the 21st Century Act (MAP-21), this document proposes to amend Federal Motor Vehicle Safety Standard (FMVSS) No. 225, ``Child restraint anchorage systems,'' to improve the ease of use of the lower anchorages of child restraint anchorage systems and the ease of use of tether anchorages. This document also proposes changes to FMVSS No. 213, ``Child restraint systems,'' to amend labeling and other requirements to improve the ease of use of child restraint systems with a vehicle anchorage system. This NPRM proposes rulemaking on these and other requirements to increase the correct use of child restraint anchorage systems and tether anchorages, and the correct use of child restraints, with the ultimate goal of reducing injuries to restrained children in motor vehicle crashes.

Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatements of previously approved collections. This document describes the collection of information for which NHTSA intends to seek OMB approval.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below has been forwarded to the Office of Management and Budget (OMB) for review and comment. The ICR describes the nature of the information collections and their expected burden.

In accordance with the procedures in 49 CFR part 555, Toyota Motor North America, Inc. (Toyota) petitioned the agency for a temporary exemption from one portion of FMVSS No. 305 that requires manufacturers to maintain a certain level of electrical isolation (or reduce the voltage below specified levels) of high voltage electrical components in an electric vehicle (EV) in the event of a crash. Toyota states that their forthcoming fuel cell vehicle (FCV) models cannot meet this requirement due to certain design characteristics innate to FCVs. Toyota is instead using alternative strategies to help ensure that occupants and first responders are protected in the event of a crash. After reviewing Toyota's petition and the comments received, the agency has decided to grant the petition. The agency has determined that Toyota's petition for exemption would facilitate the development or field evaluation of a low-emission motor vehicle and would not unreasonably reduce the safety level of that vehicle.

The FHWA and NHTSA are extending the comment period for a notice and request for comment which was published on November 28, 2014, at 79 FR 70914. The original comment period is set to close on December 29, 2014. The extension is based on concern expressed by the American Association of State Highway and Transportation Officials (AASHTO) that the December 29 closing date does not provide sufficient time to review and provide comprehensive comments on the notice. The FHWA and NHTSA recognize that others interested in commenting may have similar concerns and agrees that the comment period should be extended. Therefore, the closing date for comments is changed to February 15, 2015, which will provide stakeholders interested in commenting additional time to discuss, evaluate, and submit responses to the docket.

China Manufacturers Alliance, LLC (CMA) and Double Coin Holdings, Ltd (DCHL) have determined that certain Double Coin and Dynatrac brand truck & bus radial replacement tires that were imported by CMA and manufactured by DCHL do not fully comply with paragraph S6.5 of Federal Motor Vehicle Safety Standard (FMVSS) No. 119, New Pneumatic Tires for Motor Vehicles with a GVWR of More Than 4,536 Kilograms (10,000 Pounds) and Motorcycles. CMA and DCHL filed an appropriate report dated June 17, 2014, pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports.

Michelin North America, Inc. (MNA) has determined that certain Michelin Pilot Street Radial replacement motorcycle tires, do not fully comply with paragraph S6.5(f) of Federal Motor Vehicle Safety Standard (FMVSS) No. 119, New Pneumatic Tires for Motor Vehicles with a GVWR of More Than 4,536 kilograms (10,000 pounds) and Motorcycles. MNA has filed an appropriate report dated July 3, 2014, pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below has been forwarded to the Office of Management and Budget (OMB) for review and comment. The ICR describes the nature of the information collections and their expected burden. The Federal Register Notice soliciting public comment on the ICR, with a 60-day comment period was published on September 26, 2014, at 79 FR 58029.

This notice solicits public comments on continuation of the requirements for the collection of information on safety standards. Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections. This document describes a collection of information on nine Federal motor vehicle safety standards (FMVSSs) and two regulations, for which NHTSA intends to seek OMB approval. The information collection pertains to requirements that specify certain description, instructions and safety precautions regarding items of motor vehicle equipment must appear in the vehicle owner's manual.

This notice provides NHTSA's finding that a waiver of the Buy America requirements is appropriate for the purchase of Nania Baby Ride infant car seats by the Maryland Highway Safety Office (MHSO), using Federal grant funds. NHTSA finds that a non-availability waiver of the Buy America requirements is appropriate for the purchase of these infant car seats using Federal highway safety grant funds because there are no suitable products produced in the United States.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below has been forwarded to the Office of Management and Budget (OMB) for review and comment. The ICR describes the nature of the information collection and the expected burden. The Federal Register Notice with a 60-day comment period was published on June 30, 2014 (79 FR 36865-36867).

The Department of Transportation (DOT) invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections.

This document proposes to amend Federal Motor Vehicle Safety Standards (FMVSSs) Nos. 122 and 123, to allow the use of an internationally recognized symbol as the antilock brake system (ABS) malfunction telltale. Although the use of the symbol complies with the FMVSS No. 122 requirement that the letters ``ABS'' indicate a malfunction, the height of the letters ``ABS'' within the standardized malfunction symbol on many motorcycles do not comply with the letter height requirement in FMVSS No. 122. We also are proposing a technical change to correct a mistake in the 2012 final rule adopting FMVSS No. 122.

Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections. This document describes an existing collection of information for 49 CFR part 574, Tire Identification and Recordkeeping, for which NHTSA intends to seek renewed OMB approval.

Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections. This document describes one collection of information for which NHTSA intends to seek OMB approval.

This document grants in full the Mazda Motor Corporation's (Mazda) petition for an exemption of the (confidential) vehicle line in accordance with 49 CFR part 543, Exemption from Vehicle Theft Prevention Standard. This petition is granted because the agency has determined that the antitheft device to be placed on the line as standard equipment is likely to be as effective in reducing and deterring motor vehicle theft as compliance with the parts-marking requirements of 49 CFR part 541, Federal Motor Vehicle Theft Prevention Standard (Theft Prevention Standard). Mazda also requested confidential treatment for specific information in its petition. The agency will address Mazda's request for confidential treatment by separate letter.