Federal Aviation Administration October 2009 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for certain Piper Aircraft, Inc. (Piper) PA-28, PA-32, PA-34 and PA-44 series airplanes. This proposed AD would require an inspection of the control wheel shaft for both the pilot and copilot sides and, if necessary, replacement of the control wheel shaft. This proposed AD results from two field reports of incorrectly assembled control wheel shafts. We are proposing this AD to detect and correct any incorrectly assembled control wheel shafts. This condition, if left uncorrected, could lead to separation of the control wheel shaft, resulting in loss of pitch and roll control.

The FAA is revising an existing airworthiness directive (AD), which applies to all Boeing Model 747-100, 747-100B, 747-100B SUD, 747- 200B, 747-200C, 747-200F, 747-300, 747SR, and 747SP series airplanes. That AD currently requires revising the FAA-approved maintenance program by incorporating new airworthiness limitations (AWLs) for fuel tank systems to satisfy Special Federal Aviation Regulation No. 88 requirements. That AD also requires the initial inspection of certain repetitive AWL inspections to phase in those inspections, and repair if necessary. This AD clarifies the intended effect of the AD on spare and on-airplane fuel tank system components. This AD results from a design review of the fuel tank systems. We are issuing this AD to prevent the potential for ignition sources inside fuel tanks caused by latent failures, alterations, repairs, or maintenance actions, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.

We are adopting a new airworthiness directive (AD) for Bell Helicopter Textron Canada (Bell) Model 407 and 427 helicopters. This AD results from a mandatory continuing airworthiness information (MCAI) AD issued by the aviation authority of Canada. The MCAI AD states that, during a preflight check, it was observed that the swashplate link assembly bearing had moved in the lever race, making contact with the swashplate support. The MCAI also states that further investigation revealed that the bearing had not been staked correctly during manufacture. That condition, if not detected, could result in failure of a bearing, failure of the swashplate link assembly, and subsequent loss of control of the helicopter.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for certain Boeing Model 767-200, -300, -300F, and -400ER series airplanes. This AD requires an inspection to determine if certain motor operated valve actuators for the fuel tanks are installed, and related investigative and corrective actions if necessary. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to prevent an ignition source inside the fuel tanks, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.

We are adopting a new airworthiness directive (AD) for certain Boeing Model 747 airplanes and certain Boeing Model 757-200, -200PF, and -300 series airplanes. This AD requires replacing the control switches of the forward, aft, and nose cargo doors of Model 747 airplanes; and requires replacing the control switches of cargo doors 1 and 2 of Model 757 series airplanes. This AD results from reports of problems associated with the uncommanded operation of cargo doors. We are issuing this AD to prevent injuries to persons and damage to the airplane and equipment.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: During acceleration up to One Engine Inoperative (OEI) 30-second rating, one event of flight loss of full automatic control occurred on an Arriel 2S1 engine. The selection of OEI 30-second rating on engine 1 was triggered by the automatic detection of an OEI situation further to a transient deceleration of engine 2. The transient deceleration of engine 2 was caused by the untimely reset of its DECU. Once this reset was completed, engine 2 resumed its nominal operation. Afterwards the aircraft then continued its flight safely with its engine 1 operating in manual control mode. The loss of full automatic control of engine 1 was caused by loss of steps of the stepper motor controlling the fuel metering valve inside the Hydromechanical Unit (HMU). It has been found that high accelerations, notably up to OEI 30-second rating, increase the risk of loss of steps of the HMU stepper motor. Therefore, this event has led to the consideration of the following unsafe condition at aircraft level: In- flight loss of full automatic control of the engine induced by the loss of steps of the stepper motor during acceleration up to OEI 30-second rating, further to an actual OEI situation on the other engine (such as a power loss event).

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

This action establishes Class E Airspace at Nantucket Memorial Airport, Nantucket, MA, by establishing Class E Surface airspace designated as an extension to Class D airspace. This action will encompass the new Standard Instrument Approach Procedures (SIAPs) and enhance the safety and management of Instrument Flight Rules (IFR) around the Nantucket Memorial Airport, MA.

These special conditions are issued for the Bombardier Model CL-600-2B16 (CL-605) airplane. This airplane, as modified by Rockwell Collins Aerospace & Electronics, Inc., will have an Enhanced Flight Vision System (EFVS). The EFVS is a novel or unusual design feature which consists of a head-up display (HUD) system modified to display forward-looking infrared (FLIR) radar imagery. The airworthiness regulations applicable to pilot compartment view do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

This establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

The FAA is revising an existing airworthiness directive (AD), which applies to all Airbus Model A310 airplanes. That AD currently requires revising the Airworthiness Limitations Section of the Instructions for Continued Airworthiness to incorporate new limitations for fuel tank systems. This AD clarifies the intended effect of the AD on spare and on-airplane fuel tank system components. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to prevent the potential of ignition sources inside fuel tanks, which, in combination with flammable fuel vapors caused by latent failures, alterations, repairs, or maintenance actions, could result in fuel tank explosions and consequent loss of the airplane.

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

We are superseding an existing airworthiness directive (AD) for the products listed above. That AD currently requires initial and repetitive inspections of the low-pressure (LP) turbine discs stage 2 and stage 3 for corrosion, on certain serial number engines. This AD requires the same actions, but extends the applicability to additional engine serial numbers. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is adopting a new airworthiness directive (AD) for General Electric Company (GE) CF6-80C2 series turbofan engines with certain thrust reverser ballscrew gearbox assembly adjustable-length end actuators installed. This AD requires initial visual inspections and repetitive replacements of the \3/8\-inch rod-ends installed on the thrust reverser ballscrew gearbox assembly adjustable-length end actuators. This AD also allows an optional terminating action to those repetitive replacements. This AD also requires initial visual inspections and replacements, if necessary, of the other hardware connecting the thrust reverser transcowls to the engine. This AD results from reports of four failures of rod-ends on certain thrust reverser ballscrew gearbox assembly adjustable-length end actuators, leading to partial or complete separation of the transcowl from the engine and airplane during thrust reversal. We are issuing this AD to prevent loss of asymmetric thrust and thrust control.

The FAA proposes to supersede an existing airworthiness directive (AD) for Rolls-Royce plc (RR) RB211 Trent 700 series turbofan engines. That AD currently requires initial and repetitive borescope inspections of the high pressure-and-intermediate pressure (HP-IP) turbine internal and external oil vent tubes for coking and carbon buildup, and cleaning or replacing the vent tubes if necessary. This proposed AD would require the same actions, but would add additional inspections of the vent flow restrictor. This proposed AD results from further analysis that the cleaning of the vent tubes required by AD 2007-02-05 could lead to loosened carbon fragments, causing a blockage downstream in the vent flow restrictor. We are proposing this AD to prevent internal oil fires due to coking and carbon buildup that could cause uncontained engine failure and damage to the airplane.

This action proposes to establish a high altitude area navigation (RNAV) route, designated Q-37, extending between the Pueblo, CO, very high frequency omnidirectional range/tactical air navigation (VORTAC) navigation aid and the Fort Stockton, TX, VORTAC. The new route would provide pilots and air traffic controllers with an efficient alternative route around potentially constrained airspace during convective weather events in west Texas.

This action establishes Class E airspace at Noorvik, AK to provide adequate controlled airspace to contain aircraft executing Standard Instrument Approach Procedures (SIAPs). Two SIAPs are being developed for the Robert (Bob) Curtis Memorial Airport at Noorvik, AK. Additionally, one textual Obstacle Departure Procedure (ODP) is being developed. This action establishes Class E airspace upward from 700 feet (ft.) above the surface at Robert (Bob) Curtis Memorial Airport, Noorvik, AK.

This notice advises interested persons that the FAA is conducting workshops to develop an aircraft noise impacts research roadmap. The roadmap is intended to advance our scientific knowledge in

The FAA is issuing this notice to advise the public of a meeting of RTCA Special Committee 216: Aeronautical Systems Security.

This action proposes to make a revision to the alignment of high altitude RNAV route Q-108, which currently extends between the GADAY and CLAWZ waypoints (WP) in Florida. The FAA is proposing this action to enhance the efficiency of the National Airspace System in the northern Florida area.