Federal Aviation Administration December 16, 2016 – Federal Register Recent Federal Regulation Documents

Qualification, Service, and Use of Crewmembers and Aircraft Dispatchers; Related Aircraft Amendment
Document Number: 2016-30211
Type: Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
This rule allows air carriers to seek a deviation from the flight simulation training device (FSTD) requirements for related aircraft proficiency checks. As a result, this rule will eliminate an inconsistency that currently permits carriers that have obtained FAA approval to modify the FSTD requirements for related aircraft differences training, but not for corresponding proficiency checks. In doing so, it corrects an inadvertent omission from the Qualification, Service, and Use of Crewmembers and Aircraft Dispatchers final rule.
Notice of Release From Quitclaim Deed and Grant Assurance Obligations at Reno Stead Airport, Reno, Washoe County, Nevada
Document Number: 2016-30210
Type: Notice
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
The Federal Aviation Administration (FAA) proposes to rule and invites public comment on the application for a land release of approximately 0.58 acres of airport property and associated 15-foot- wide access easement owned by Reno Stead Airport, Reno, Washoe County, Nevada from the airport use provisions of the Grant Agreement Assurances since the land is not needed for airport purposes. The subject property is located approximately 0.5 miles from the Reno Stead Airport and has no identified airport-related purpose. The airport will be compensated for the fair market value of the released property. Reuse of the property will not interfere with the airport or its operation, thereby protecting the interests of civil aviation.
Airworthiness Directives; Rolls-Royce plc Turbofan Engines
Document Number: 2016-30065
Type: Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Rolls-Royce plc (RR) RB211-Trent 875-17, RB211-Trent 877-17, RB211- Trent 884-17, RB211-Trent 884B-17, RB211-Trent 892-17, RB211-Trent 892B-17, and RB211-Trent 895-17 turbofan engines. This AD requires machining and inspecting parts related to the high-pressure compressor (HPC) and replacing HPC parts found defective. This AD was prompted by inspection of RR Trent 800 engines returned from service that revealed flame erosion and axial cracking on the stage 3 disk rim of the HPC stage 1-4 rotor disks shaft. We are issuing this AD to correct the unsafe condition on these products.
Airworthiness Directives; International Aero Engines AG Turbofan Engines
Document Number: 2016-30064
Type: Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain International Aero Engines AG (IAE) V2522-A5, V2524-A5, V2527-A5, V2527E-A5, V2527M-A5, V2530-A5, V2533-A5, V2525-D5, V2528-D5, and V2531-E5 turbofan engines. This AD was prompted by nine in-flight shutdowns (IFSDs) that resulted from premature failure of the No. 3 bearing. This AD requires inspections and corrective actions for bearing damage. This AD also requires removal of the No. 3 bearing from service at the next engine shop visit. We are issuing this AD to correct the unsafe condition on these products.
Airworthiness Directives; Airbus Airplanes
Document Number: 2016-30038
Type: Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Airbus Model A319, A320, and A321 series airplanes. This AD requires repetitive general visual inspections for broken battery retaining rods and replacement if necessary. We are issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Airplanes
Document Number: 2016-30036
Type: Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Airbus Model A319-115 and -132 airplanes, and Model A320-214, -232, and -233 airplanes. This AD requires revising the airplane flight manual (AFM) to include information that introduces a fuel limitation for certain types of fuel and a fuel gravity feed ceiling procedure for airplanes equipped with jet pumps. This AD was prompted by a report indicating that certain modified airplanes do not have electrical ground wires on the fuel level sensing control unit (FLSCU), which adversely affects gravity feeding operation. We are issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc. Airplanes
Document Number: 2016-29815
Type: Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model BD-700-1A10 and BD-700-1A11 airplanes. This AD requires an inspection for discrepancies of the attachment points of the links between the engine rear mount assemblies, and corrective actions if necessary. This AD was prompted by a report indicating that during maintenance, an engine mount pin was found backed out of the rear mount link, and the associated retaining bolt was also found fractured. We are issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Airplanes
Document Number: 2016-29676
Type: Proposed Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We propose to adopt a new airworthiness directive (AD) for all Airbus Model A321 series airplanes. This proposed AD was prompted by a determination from fatigue testing on the Model A321 airframe that cracks could develop in the cabin floor beam junction at certain fuselage frame locations. This proposed AD would require repetitive inspections for cracking in the cabin floor beam junction at certain fuselage frame locations, and repair if necessary. We are proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc. Airplanes
Document Number: 2016-29671
Type: Proposed Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc. Model DHC-8-400 series airplanes. This proposed AD was prompted by reports of interruptions in the airstair door operation. This proposed AD would require repetitive inspections and modification of the handrail hardware. We are proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; The Boeing Company Airplanes
Document Number: 2016-29670
Type: Proposed Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We propose to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 airplanes. This proposed AD was prompted by a report indicating that during an airplane inspection in production, the variable frequency starter generator (VFSG) power feeder cables were found to contain terminal lugs incorrectly installed common to terminal blocks located in the wing front spar. This proposed AD would require a general visual inspection of the wings, section 16, terminal lugs at the terminal power block of the VFSG power feeder cable for correct installation and if required, applicable corrective actions. We are proposing this AD to address the unsafe condition on these products.
Amendment of Class D Airspace for St. Petersburg, FL
Document Number: 2016-29634
Type: Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
This action amends the ceiling of the Class D Airspace area at St. Petersburg-Clearwater International Airport, St. Petersburg, FL. This would allow the Tampa International Airport Air Traffic Control Tower (ATCT) to carry out Letter of Agreement procedures between St. Petersburg Air Traffic Control Tower and Tampa Terminal Radar Approach Control (TRACON) for the safety and management of standard instrument approach procedures (SIAPs), and for Instrument Flight Rule (IFR) operations in the area.
IFR Altitudes; Miscellaneous Amendments
Document Number: 2016-29429
Type: Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.
Airworthiness Directives; The Boeing Company Airplanes
Document Number: 2016-29251
Type: Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 airplanes. This AD was prompted by reports of the accumulation of very fine particle deposits in the power control unit (PCU) electro-hydraulic servo valves (EHSVs) used in the flight control system; this accumulation caused degraded performance due to reduced EHSV internal hydraulic supply pressures, resulting in the display of PCU fault status messages from the engine indication and crew alerting system (EICAS). This AD requires installing markers to limit the hydraulic system fluid used to a specific brand, doing hydraulic fluid tests of the hydraulic systems, replacing hydraulic system fluid if necessary, and doing all applicable related investigative and corrective actions. We are issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Airplanes
Document Number: 2016-29249
Type: Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We are superseding Airworthiness Directive (AD) 2014-13-12 for all Airbus Model A318, A319, A320, and A321 series airplanes. AD 2014- 13-12 required identifying the part number and serial number of each passenger oxygen container, replacing the oxygen generator manifold of any affected oxygen container with a serviceable manifold, performing an operational check of the manual mask release, and doing corrective actions if necessary. This new AD retains the requirements of AD 2014- 13-12, and requires replacing the oxygen generator manifold of any affected DAe oxygen container with a serviceable manifold. This AD was prompted by reports of silicon particles inside the oxygen generator manifolds, which had chafed from the mask hoses during installation onto the generator outlets. We are issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Airplanes
Document Number: 2016-28802
Type: Proposed Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We are revising an earlier proposal to supersede Airworthiness Directive (AD) 2011-17-09 for all Airbus Model A330-200, -200 Freighter, and -300 series airplanes; and AD 2012-25-12 for all Airbus Model A330-200 and -300 series airplanes. The notice of proposed rulemaking (NPRM) proposed to require revising the maintenance or inspection program, as applicable, to incorporate new or revised airworthiness limitation requirements. The NPRM was prompted by revisions to certain airworthiness limitations items (ALI) documents, which specify more restrictive instructions and/or airworthiness limitations. This action revises the NPRM by proposing to require revising the maintenance or inspection program, as applicable, to incorporate more restrictive, instructions and/or airworthiness limitations that the manufacturer has recently issued. We are proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Fokker Services B.V. Airplanes
Document Number: 2016-28669
Type: Proposed Rule
Date: 2016-12-16
Agency: Federal Aviation Administration, Department of Transportation
We propose to supersede Airworthiness Directive (AD) 2012-22- 15 for all Fokker Services B.V. Model F28 Mark 0070 and Mark 0100 airplanes. AD 2012-22-15 currently requires revising the maintenance program to incorporate the limitations, tasks, thresholds, and intervals specified in certain revised Fokker maintenance review board (MRB) documents. Since we issued AD 2012-22-15, we received new revisions of airworthiness limitations items (ALI) documents, which introduce new and more restrictive maintenance requirements and airworthiness limitations. This proposed AD would require revising the maintenance or inspection program to incorporate new maintenance requirements and airworthiness limitations. We are proposing this AD to prevent the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.