Pipeline and Hazardous Materials Safety Administration March 2006 – Federal Register Recent Federal Regulation Documents
Results 1 - 11 of 11
Pipeline Safety: Request for Waiver; Rockies Express Pipeline
The Rockies Express Pipeline LLC (Rockies Express) has requested a waiver of compliance from the pipeline safety regulation that prescribes the design factor to be used in the design formula for steel pipe. The waiver will allow Rockies Express to operate at hoop stresses up to 80 percent specified minimum yield strength (SMYS) in Class 1 locations.
Pipeline Safety: Request for Waiver; Alliance Pipeline L.P.
Alliance Pipeline L.P. (APL) requested a waiver of compliance for the U.S. portion of its pipeline system in Class 1 and Class 2 locations to operate its pipeline at stress levels up to 80 percent of the pipeline's specified minimum yield strength (SMYS), and increase the design factor for its compressor station piping. APL also requested relief from the hydrostatic testing requirements for its compressor station piping and pressure relieving and limiting station equipment requirements.
Pipeline Safety: Request for Waiver; Maritimes & Northeast Pipeline, L.L.C.
Maritimes & Northeast Pipeline, L.L.C. (M&N) requests a waiver of compliance for the U.S. portion of its pipeline system in Class 1, 2, and 3 locations to operate at stress levels up to 80 percent; 67 percent; and 56 percent respectively, of the pipeline's specified minimum yield strength (SMYS).
Office of Hazardous Materials Safety; Notice of Application for Special Permits
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Materials Regulations (49 CFR Part 107, Subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular special permit is requested is indicated by a number in the ``Nature of Application'' portion of the table below as follows: 1Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft.
Office of Hazardous Materials Safety; Notice of Applications for Modification of Special Permit
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. This notice is abbreviated to expedite docketing and public notice. Because the sections affected, modes of transportation, and the nature of application have been shown in earlier Federal Register publications, they are not repeated here. Request of modifications of special permits (e.g. to provide for additional hazardous materials, packaging design changes, additional mode of transportation, etc.) are described in footnotes to the application number. Application numbers with the suffix ``M'' denote a modification request. There applications have been separated from the new applications for special permits to facilitate processing.
Hazardous Materials: Revision of Requirements for Carriage by Aircraft
This final rule amends the requirements in the Hazardous Materials Regulations (HMR) for the transportation of hazardous materials by aircraft. This final rule clarifies the applicability of part 175; clarifies the exceptions from regulation for operator equipment and supplies, special aircraft operations, and passengers and crewmembers; revises separation distances for the shipment of radioactive materials by cargo aircraft; and updates the regulations to comply with security requirements for explosive special permits. These changes are being made to finalize outstanding petitions for rulemaking, convert certain special permits into regulations, and promote international harmonization, where appropriate.
Pipeline Safety: Request for Waiver; Dominion Transmission, Inc.
Dominion Transmission, Inc. (DTI) requested a waiver of compliance from the pipeline safety regulation that requires each liquefied natural gas (LNG) facility constructed after March 31, 2000 to comply with the American National Standards Institute and National Fire Protection Association (ANSI/NFPA) standard for low-pressure welded storage containers.
Pipeline Safety: Grant of Waiver; Duke Energy Gas Transmission Company
Duke Energy Gas Transmission Company (DEGT) petitioned the Pipeline and Hazardous Materials Safety Administration (PHMSA) for a waiver of compliance with 49 CFR 192.611, which requires natural gas pipeline operators to confirm or revise the maximum allowable operating pressure of a pipeline after a change in class location. DEGT requested the waiver for certain segments of its natural gas pipeline located in Tennessee and Kentucky that have changed, and for segments that may change from Class 1 to Class 2 in the future. Under the pipeline safety regulations, class location indicates the population density near a pipeline. As the population along a pipeline increases, the class location increases. DEGT proposed to conduct a set of alternative risk control activities, in lieu of pipe replacement or pressure reduction, on all the segments requested in the waiver.
Gas Gathering Line Definition; Alternative Definition for Onshore Lines and New Safety Standards
This action adopts a consensus standard to distinguish onshore gathering lines from other gas pipelines and production operations. In addition, it establishes safety rules for certain onshore gathering lines in rural areas and revises current rules for certain onshore gathering lines in nonrural areas. Operators will use a new risk-based approach to determine which onshore gathering lines are subject to PHMSA's gas pipeline safety rules and which of these rules the lines must meet. PHMSA intends this action to reduce disagreements over classifications of onshore gathering lines, increase public confidence in the safety of onshore gathering lines, and provide safety rules consistent with the risks of onshore gathering lines.
Request for Public Comments and Office of Management and Budget (OMB) Approval of an Existing Information Collection (2137-0610)
This notice requests public participation in the Office of Management and Budget (OMB) approval process for the renewal of an existing PHMSA information collection. In compliance with the Paperwork Reduction Act of 1995, this notice announces that the Information Collection Request (ICR) described below has been forwarded to OMB for extension of the currently approved collection. The ICR describes the nature of the information collection and the expected burden. PHMSA published a Federal Register Notice soliciting comments on the following information collection and received none. The purpose of this notice is to allow the public an additional 30 days from the date of this notice to submit comments.
Office of Hazardous Materials Safety; Notice of Delays in Processing of Special Permit Applications
In accordance with the requirements of 49 U.S.C. 5117(c), PHMSA is publishing the following list of special permit applications that have been in process for 180 days or more. The reason(s) for delay and the expected completion date for action on each application is provided in association with each identified application.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
