Federal Aviation Administration March 2022 – Federal Register Recent Federal Regulation Documents

The FAA is superseding Airworthiness Directive (AD) 2022-05- 09, which applied to certain MARS A.S. emergency parachutes. AD 2022- 05-09 required removing emergency parachutes with certain manufacture dates or serial numbers from service. Since the FAA issued AD 2022-05- 09, the European Union Aviation Safety Agency (EASA) superseded its mandatory continuing airworthiness information (MCAI) to correct an unsafe condition on this aviation product. The MCAI identifies the unsafe condition as the length of the ripcord between the pins being too long, which could cause a malfunction of the emergency parachute. This AD retains the actions required by AD 2022-05-09 and expands the applicability.

The FAA proposes to adopt a new airworthiness directive (AD) for certain Leonardo S.p.a. Model AB139 and AW139 helicopters. This proposed AD was prompted by a large crack detected on the tail gearbox (TGB) fitting during a scheduled inspection and the determination that certain TGB fittings are required to be inspected by the use of a borescope. This proposed AD would require a one-time borescope inspection of certain part-numbered TGB fittings, and depending on the inspection results, removing the affected part from service and replacing with an airworthy part, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.

The FAA proposes to adopt a new airworthiness directive (AD) for certain CFM International, S.A. (CFM) LEAP-1A model turbofan engines. This proposed AD was prompted by reports of two in-flight shutdowns (IFSDs) and subsequent investigation by the manufacturer that revealed cracks in the high-pressure turbine (HPT) rotor stage 1 blades. This proposed AD would require initial and repetitive borescope inspections (BSIs) of the HPT rotor stage 1 blades and HPT stator stage 1 nozzle set. Depending on the results of the BSIs, this proposed AD would require either additional BSIs at reduced intervals or replacement of the HPT rotor stage 1 blades or HPT stator stage 1 nozzle set. This proposed AD would also require sending the inspection results to CFM if any unserviceable finding is found. The FAA is proposing this AD to address the unsafe condition on these products.

This action proposes to amend United States Area Navigation (RNAV) route T-228 in the vicinity of Cape Newenham, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.

The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 777 airplanes. This proposed AD was prompted by reports of discrepancies between the center wing tank (CWT) fuel quantity, as indicated by the fuel quantity indicating system (FQIS), and the refueling truck uploaded fuel amount, followed by certain engine-indicating and crew-alerting system (EICAS) messages. This proposed AD would require installing new software in the fuel quantity processor unit (FQPU), or replacing the FQPU with one that includes new software, depending on airplane configuration; and doing a software version check and FQPU operational check. This proposed AD would also prohibit the installation of certain FQPUs on certain airplanes. The FAA is proposing this AD to address the unsafe condition on these products.

This notice contains a summary of a petition seeking relief from specified requirements of Federal Aviation Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion nor omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This notice contains a summary of a petition seeking relief from specified requirements of Federal Aviation Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion nor omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval for a new information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on October 25, 2021. The deadline for submission of public comments expired on December 27, 2021. No public comments were provided. The Department of Transportation (DOT or Department) further invites public comments about our intention to request the Office of Management and Budget's (OMB) approval for an information collection for the Department's Airport Concession Disadvantaged Business Enterprise (ACDBE) program. The DOT has the important responsibility of ensuring that firms competing for concession opportunities are not disadvantaged by unlawful discrimination. The DOT's most important tool for meeting this requirement has been its ACDBE program which is regulated by 49 CFR part 23 (ACDBE regulation) and is mandated by 49 U.S.C. 47107(e), originally enacted in 1987 and amended in 1992. The information collections described in this notice are necessary to maintain successful implementation of the ACDBE program, as it helps ensure recipients that receive Federal financial assistance from the Airport Improvement Program (AIP) of the Federal Aviation Administration (FAA) do not discriminate in the provision of opportunities for disadvantaged business enterprises in airport concessions. We are required to publish this notice in the Federal Register by the Paperwork Reduction Act of 1995, Public Law 104-13 (PRA).

The FAA announces the special class airworthiness criteria for the Flirtey Inc. Model Flirtey F4.5 unmanned aircraft (UA). This document sets forth the airworthiness criteria the FAA finds to be appropriate and applicable for the UA design.

The FAA announces the special class airworthiness criteria for the Wingcopter GmbH Model 198 US unmanned aircraft (UA). This document sets forth the airworthiness criteria the FAA finds to be appropriate and applicable for the UA design.

The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 747-100, 747-100B, 747-100B SUD, 747-200B, 747-200C, 747-200F, 747-300, 747-400, 747-400D, and 747-400F series airplanes. This AD was prompted by a determination that radio altimeters cannot be relied upon to perform their intended function if they experience interference from wireless broadband operations in the 3.7-3.98 GHz frequency band (5G C-Band), and a recent determination that during takeoff, approach, landings, and go-arounds, as a result of this interference, certain airplane systems may not properly function, resulting in increased flightcrew workload while on approach with the flight director, autothrottle, or autopilot engaged, which could result in reduced ability of the flightcrew to maintain safe flight and landing of the airplane. This AD requires revising the limitations and operating procedures sections of the existing airplane flight manual (AFM) to incorporate specific operating procedures for takeoff, instrument landing system (ILS) approaches, non-precision approaches, and go-around and missed approaches, when in the presence of 5G C-Band interference as identified by Notices to Air Missions (NOTAMs). The FAA is issuing this AD to address the unsafe condition on these products.

In accordance with the Paperwork Reduction Act of 1995, the FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew information collection. The collection involves Aviation Maintenance Technician School (AMTS) applicants and certificate holders. The information to be collected will be used to ensure AMTS applicants and certificate holders meet the requirements of part 147 prior to being certificated, and on an ongoing basis following FAA certification.

This action amends low altitude United States Area Navigation (RNAV) route, T-208 in support of the South-Central FL Metroplex Project. Other route changes that were proposed in the NPRM are being deferred to a later date.

This action amends the descriptions of Area Navigation (RNAV) routes Q-140 and Q-812 by changing the spelling of one waypoint (WP) in the descriptions of the routes. The geographic position of the WP remains unchanged.

This action establishes Class E airspace extending upward from 700 feet above the surface for Dewitt Municipal Airport/Whitcomb Field, Dewitt, AR to accommodate area navigation (RNAV) global positioning system (GPS) standard instrument approach procedures (SIAPs) serving this airport. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations in the area.

This action amends Class D airspace and Class E airspace extending upward from 700 feet above the surface for Lawrenceville, GA. This action updates the airport's name in both the Class D and E airspace to Gwinnett County/Briscoe Field. In addition, this action amends the Class D airspace by creating an extension to the southwest. The Class E airspace extending upward from 700 feet above the surface is amended by increasing the radius and eliminating the extension to the east. Also, this action eliminates the Gwinnett Non-directional Beacon (NDB) from the legal description. This action also makes an editorial change replacing the term Airport/Facility Directory with the term Chart Supplement in the legal descriptions of the Class D airspace. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations in the area.

The FAA is adopting a new airworthiness directive (AD) for certain Airbus Helicopters Deutschland GmbH (AHD) Model MBB-BK 117 C-2 and MBB-BK 117 D-2 helicopters. This AD was prompted by a report of erroneous or partial installation of the seat belt restraint system. This AD requires inspecting certain seats, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain Honda Aircraft Company LLC (Honda) Model HA-420 airplanes. This AD was prompted by a report of in-flight smoke and fire that initiated from the windshield heat power wire braid. This AD requires incorporating temporary revisions into the airplane flight manual (AFM) and the quick reference handbook (QRH) that modify procedures for windshield heat operation until the affected windshield assemblies are replaced. The FAA is issuing this AD to address the unsafe condition on these products.

This action proposes to revoke Colored Federal airway Red 51 (R-51) due to the decommissioning of the Sumner Strait, AK, (SQM) Non- Directional Beacon (NDB).

The FAA is superseding Airworthiness Directive (AD) 2022-02-02 which applied to certain Bell Textron Inc. (type certificate previously held by Bell Helicopter Textron Inc.) Model 204B, 205A, 205A-1, 205B, 210, and 212 helicopters with a certain main rotor hub strap pin (pin) installed. AD 2022-02-02 required removing certain outboard pins from service and prohibited installing them on any helicopter. This AD expands the applicability to all affected pins, regardless if they are outboard or inboard. This AD also requires inspecting the removed pin for any deformation and if it is deformed, removing the mating strap fitting (fitting) from service. This AD was prompted by the discovery that AD 2022-02-02 inadvertently limited its applicability to only outboard pins when, in fact, all pins are subject to the unsafe condition and the determination that a deformed pin may have damaged the fitting. The FAA is issuing this AD to address the unsafe condition on these products.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The collection involves soliciting feedback from airmen on service quality of Aeromedical Certification Services. The information to be collected will be used to inform improvements in Aeromedical Certification Services.

This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPS) and associated Takeoff Minimums and Obstacle Departure procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

This action establishes Class E airspace extending upward from 700 feet above the surface to accommodate Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedures (SIAPs) serving Iuka Airport, Iuka, MS. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations in the area.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 777-200 and -300 series airplanes. This AD was prompted by reports of three incidents involving in-flight fan blade failures on certain Pratt & Whitney engines (``fan blades'' are also known as ``1st-stage low-pressure compressor (LPC) blades'' these terms are used interchangeably in this AD). This AD requires installation of debris shields on the thrust reverser (T/R) inner wall at the left and right sides of the lower bifurcation, inspection of the fan cowl doors for moisture ingression, repetitive functional checks of the hydraulic pump shutoff valves to ensure they close in response to the fire handle input, and corrective actions if necessary. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 777-200 and -300 series airplanes. This AD was prompted by reports of three incidents involving in-flight fan blade failures on certain Pratt & Whitney engines (``fan blades'' are also known as ``1st-stage low- pressure compressor (LPC) blades''these terms are used interchangeably in this AD). This AD requires modifying the engine inlet to withstand fan blade failure event loads. The FAA is issuing this AD to address the unsafe condition on these products.