Department of Transportation 2021 – Federal Register Recent Federal Regulation Documents

The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320-211, -212, -214, -216, -231, -232, and - 233 airplanes; and Model A321-111, -112, -131, -211, -212, -213, -231, and -232 airplanes. This AD was prompted by a report that during re- engineering of galley G5, a 9G forward full scale qualification test was performed, and the door of the waste compartment opened before the required load was reached. This AD requires modifying the waste compartment door of each affected galley, as specified in a European Aviation Safety Agency (EASA) AD, which is incorporated by reference The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 and 787-9 airplanes. This AD was prompted by reports that shimming requirements were not met during the assembly of certain structural joints, which can result in reduced fatigue thresholds and cracking of the affected structural joints. This AD requires repetitive inspections for cracking of certain areas of the aft wheel well bulkhead (AWWB) body chord and AWWB side fitting and failsafe straps, and repair of any cracking found. The FAA is issuing this AD to address the unsafe condition on these products.

This action amends the Class E airspace at Monmouth Municipal Airport, Monmouth, IL, contained within the Galesburg, IL, airspace legal description. This action is the result of an airspace review caused by the decommissioning of the Galesburg very high frequency (VHF) omnidirectional range (VOR) as part of the VOR Minimal Operational Network (MON) Program.

The FAA is adopting a new airworthiness directive (AD) for certain Leonardo S.p.a. Model AW109SP helicopters. This AD was prompted by reports of an ineligible hydraulic pump being installed on Model AW109SP helicopters. This AD requires inspecting each hydraulic pump for damage and, depending on the inspections results, removing parts from service and accomplishing other corrective actions. This AD also requires removing certain parts from service before they exceed their life limits. The corrective actions are required to be accomplished as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain MD Helicopters Inc. (MDHI), Model 369D, 369E, 369F, 369FF, 369H, 369HE, 369HM, 369HS, 500N, and 600N helicopters. This AD was prompted by a report of a spiral crack in the pilot-to-copilot tail rotor torque tube (torque tube). This AD requires a one-time visual and recurring borescope inspections of the torque tube and depending on the results, removing the torque tube from service. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain Learjet Inc. (Learjet) Model 45 airplanes. This AD was prompted by reports of corrosion found on the upper surface of the lower center wing mid spar splice plate. This AD requires repetitively inspecting the center wing area for corrosion and deterioration of protective treatments, removing any corrosion, and treating any deteriorated areas. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA proposes to adopt a new airworthiness directive (AD) for all Schempp-Hirth Flugzeugbau GmbH Model Ventus-2a and Ventus-2b gliders. This proposed AD was prompted by mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as severe corrosion on the inboard flaperon actuation push rods and ball bearing connecting the flaperon push rod to the bell crank inside the wing. This proposed AD would require inspecting the affected parts of the flaperon control in the wings and taking corrective actions if necessary. The FAA is proposing this AD to address the unsafe condition on these products.

This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPS) and associated Takeoff Minimums and Obstacle Departure procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

The Office of the Secretary of Transportation invites the public to comment on the draft DOT Strategic Framework, which includes draft strategic goals and strategic objectives to accomplish each strategic goal. The strategic goals and strategic objectives will be included in the U.S. Department of Transportation (DOT) Strategic Plan for fiscal years (FY) 2022-2026.

This action establishes Class E airspace extending upward from 700 feet above the surface for Fulton Airport, Fulton, KY, to accommodate new area navigation (RNAV) global positioning system (GPS) standard instrument approach procedures (SIAPs) serving this airport. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations in the area.

This notice announces the availability of the proposed standardized curricula for instructor and check pilot qualifications for certain air carriers. This curriculum may be delivered by FAA- certificated training centers. The FAA invites public comment.

FMCSA announces its decision to exempt eight individuals from the vision requirement in the Federal Motor Carrier Safety Regulations (FMCSRs) to operate a commercial motor vehicle (CMV) in interstate commerce. They are unable to meet the vision requirement in one eye for various reasons. The exemptions enable these individuals to operate CMVs in interstate commerce without meeting the vision requirement in one eye.

This action proposes to establish Class E surface airspace to accommodate Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedures (SIAPs) serving Ocean Reef Club Airport. This action also proposes to amend Class E airspace extending upward from 700 feet above the surface for Ocean Reef Club Airport by updating the geographic coordinates of the airport and correcting the descriptor by replacing AL with FL. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations in the area.

The FAA is adopting a new airworthiness directive (AD) for certain De Havilland Aircraft of Canada Limited Model DHC-8-401 and - 402 airplanes. This AD was prompted by reports of loss of hydraulic fluid and annunciation of the check fire detect light. This AD requires doing a detailed visual inspection for chafing and proper clearance of the left-hand (LH) and right-hand (RH) main landing gear (MLG) primary zone advanced pneumatic detector (APD) sensing lines, the hydraulic tube assemblies, and the surrounding structure, and doing all applicable corrective action. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA proposes to adopt a new airworthiness directive (AD) for DG Flugzeugbau GmbH Model DG-1000T gliders and Schempp-Hirth Flugzeugbau GmbH Model Duo Discus T gliders with a Solo Kleinmotoren GmbH Solo Model 2350C or 2350D engine installed. This proposed AD was prompted by mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as failure of the bearing of the upper pulley of the belt driven reduction gear resulting in separation of the propeller from the engine. This proposed AD would require replacing a certain hex-nut and would establish a lift limit for the ball bearing assembly. The FAA is proposing this AD to address the unsafe condition on these products.

The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus Helicopters Model AS332L2 and EC225LP helicopters. This proposed AD was prompted by a report of loss of tightening torque on the nut that attaches the tail gear box (TGB) bevel wheel. This proposed AD would require repetitive inspections (measurements) of the angular clearances of the TGB, and, depending on the findings, replacement of the TGB with a serviceable TGB, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). This proposed AD would also provide terminating action for certain repetitive inspections. The FAA is proposing this AD to address the unsafe condition on these products.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The FAA Regional Administrators' Offices and the FAA Noise Ombudsman will use the information voluntarily reported, on the occasion of a complaint, by the public in the FAA Noise Portal to prepare responses to their noise complaints or inquiries. The required FAA Noise Portal fields represent the minimum amount of information the FAA needs to address the public's noise complaint or question and includes: Name, email, address or cross street and a description of the noise complaint or inquiry. It is important to know the person's name and email address to respond and track the complaint. The FAA will not respond to the same complaint from the same person more than once. The address or cross street is needed for the FAA to determine potential sources of the aircraft noise issues as most people complain about aircraft in the vicinity of their residence. The description is used to provide additional details for the FAA to better address the complaint or question.

This action amends the Columbus, Port Columbus International Airport, OH, Class C airspace description to update the airport name and airport reference point (ARP) information to match the FAA's aeronautical database. Additionally, minor administrative edits to the legal description title and header information are made for readability. This action does not change the boundaries, altitudes, or operating requirements of the Class C airspace area.

In accordance with the Paperwork Reduction Act of 1995 (44 U.S.C. chapter 35, as amended) this notice announces that DOT is submitting a request to the Office of Management and Budget (OMB) for renewal of OMB Control Number 2138-0041 covering Airline Service Quality Performance, On-time Performance, and Mishandled Baggage reports that the largest U.S. air carriers file with DOT under part 234 of title 14, Code of Federal Regulations (CFR). On August 11, 2021, the Director, Office of Airline Information (OAI), published a Federal Register notice announcing DOT's intent to renew the information collections and providing a 60-day comment period regarding the information collections. See 86 FR 44137. DOT did not receive any comments in response to the August 11, 2021 notice. This notice announces an additional 30 days of public comment.

The recently enacted Bipartisan Infrastructure Law invests in the deployment of electric vehicle (EV) charging infrastructure as one of many important ways to confront the climate crisis. Through a National Electric Vehicle Formula Program (EV Charging Program), the law provides funding to States to strategically deploy EV charging infrastructure and to establish an interconnected network to facilitate data collection, access, and reliability. The law also establishes a discretionary grant program for Charging and Fueling Infrastructure (Charging and Fueling Infrastructure Program) to strategically deploy publicly accessible EV charging infrastructure and hydrogen, propane, and natural gas fueling infrastructure along designated alternative fuel corridors or in certain other locations that are accessible to all drivers of such vehicles. The law directs DOT, in coordination or consultation with the Department of Energy (DOE), to develop guidance for both programs. Through this notice, FHWA invites public comments to inform the development of the guidance. FHWA is especially interested in comments suggesting ways that the guidance could promote equity in the deployment of EV charging infrastructure under these programs.

The Surface Transportation Board (Board) is accepting for consideration the application filed on October 29, 2021 (Application), by Canadian Pacific Railway Limited (Canadian Pacific), Canadian Pacific Railway Company (CPRC), and their U.S. rail carrier subsidiaries, Soo Line Railroad Company (Soo Line), Central Maine & Quebec Railway US Inc., Dakota, Minnesota & Eastern Railroad Corporation, and Delaware & Hudson Railway Company, Inc. (collectively, CP) and Kansas City Southern and its U.S. rail carrier subsidiaries, The Kansas City Southern Railway Company (KCSR), Gateway Eastern Railway Company, and The Texas Mexican Railway Company (Tex Mex) (collectively, KCS) (CP and KCS collectively, Applicants). The Application seeks Board approval for the acquisition of control by Canadian Pacific, through its indirect, wholly owned subsidiary Cygnus Merger Sub 2 Corporation (Cygnus Merger Sub 2 Corp.), of Kansas City Southern, and through it, of KCSR and its railroad affiliates, and for the resulting common control by Canadian Pacific of its U.S. railroad subsidiaries, and KCSR and its railroad affiliates. This proposal is referred to as the Transaction. The Board finds that the Application is complete as it contains all information required by the Board's regulations. Accordingly, the Application is accepted. The Board adopts a procedural schedule for consideration of the Application.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. This collection involves FAA Form 8400-3, Application for an Airman Certificate and/or Rating, (for flight engineer and flight navigator) and applications for approval of related training courses that are submitted to FAA for evaluation. The information collection is necessary to determine applicant eligibility for flight engineer or flight navigator certificates. This collection is also necessary to determine training course acceptability for those schools training flight engineers or navigators.

The FAA is adopting a new airworthiness directive (AD) for Airbus Helicopters Model EC 155B and EC155B1 helicopters. This AD was prompted by the failure of a main gearbox (MGB) second stage planet gear. This AD requires replacing the MGB, or as an alternative, replacing the epicyclic reduction gear module for certain serial numbered planet gear assemblies installed on the MGB. This AD also requires inspecting the MGB magnetic plugs and MGB filter for particles, and for certain serial-numbered planet gear assemblies, inspecting the oil sump for particles. Depending on the outcome of these inspections, this AD requires further inspections and replacing certain parts. This AD also prohibits installing certain parts. The FAA is issuing this AD to address the unsafe condition on these products.