Federal Aviation Administration January 2015 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc. Model CL-600-2C10 (Regional Jet Series 700, 701, & 702), CL-600-2D15 (Regional Jet Series 705), and CL-600-2D24 (Regional Jet Series 900) airplanes. This proposed AD was prompted by a determination that no instructions for continued airworthiness exist for the nose landing gear (NLG) alternate extension actuator of the NLG alternate release system. This proposed AD would require revising the maintenance or inspection program, as applicable, to incorporate a new airworthiness limitation task for the NLG alternate extension actuator. We are proposing this AD to prevent failure of the NLG alternate release system and, if the normal NLG extension system also fails, failure of the NLG to extend, and consequent damage to the airplane and injury to occupants.

The FAA is issuing this notice to advise the public of the first meeting of the RTCA Special Committee 233, Addressing Human Factors/Pilot Interface Issues for Avionics.

The FAA published a document in the Federal Register of December 5, 2014, concerning request for comments on the release of land at Eufaula Municipal Airport under the provisions of Section 125 of the Wendell H. Ford Aviation Investment Reform Act for the 21st Century (AIR 21). The document contained the incorrect state.

We are adopting a new airworthiness directive (AD) for all Airbus Model A318, A319, A320, and A321 series airplanes. This emergency AD was sent previously to all known U.S. owners and operators of these airplanes. This AD requires revising the airplane flight manual to advise the flightcrew of emergency procedures for abnormal Alpha Protection (Alpha Prot). This AD was prompted by a report of Angle of Attack (AoA) probes jamming on an in-service Airbus Model A321 airplane. Jamming of the two AoA probes during climb is attributed to water freezing under the AoA vane slinger, and led to activation of the Alpha Prot while the Mach number increased, which resulted in an airplane pitch down per design. We are issuing this AD to ensure that the flightcrew has procedures to counteract the pitch down order due to abnormal activation of the Alpha Prot. An abnormal Alpha Prot, if not corrected, could result in loss of control of the airplane.

We are superseding Airworthiness Directive (AD) 2011-09-11, for certain The Boeing Company Model 777-200 and -300 series airplanes. AD 2011-09-11 required repetitive inspections for hydraulic fluid contamination of the interior of the strut disconnect assembly; repetitive inspections for discrepancies of the interior of the strut disconnect assembly, if necessary; repetitive inspections of the exterior of the strut disconnect assembly for cracks, if necessary; corrective action if necessary; and an optional terminating action for the inspections. This new AD adds, for certain airplanes, an inspection of the side and top cover plates to determine if all cover plate attach fasteners have been installed, and installing any missing fasteners including doing an inspection for damage, and repair if necessary. This AD was prompted by reports of side and top cover plates installed with missing fastener bolts, which results in an unsealed opening on the system disconnect assembly. We are issuing this AD to detect and correct hydraulic fluid contamination, which can cause cracking of titanium parts in the system disconnect assembly; and also to detect and correct missing fasteners, which results in unsealed openings on the system disconnect assembly. Both unsafe conditions can compromise the engine firewall and result in fire hazards for both the engine compartment and the strut.

We are adopting a new airworthiness directive (AD) for all Dassault Aviation Model FAN JET FALCON and FAN JET FALCON SERIES C, D, E, F, and G airplanes. This AD was prompted by our determination of the need for a revision to the airplane airworthiness limitations to introduce changes to the maintenance requirements and airworthiness limitations. This AD requires revising the maintenance or inspection program, as applicable, to incorporate a new airworthiness limitations section. We are issuing this AD to prevent reduced structural integrity of the airplane.

We are adopting a new airworthiness directive (AD) for certain ATRGIE Avions de Transport R[eacute]gional Model ATR42-500 airplanes, and Model ATR72-212A airplanes. This AD was prompted by a report that, during an inspection of an airplane on the production line, interference was detected between the electrical harness and a bonding lead due to an incorrect installation of the affected bonding lead. This AD requires a detailed inspection for damage or incorrect routing of the bonding lead routing above the 120VU shelf, and if any damage or incorrect routing is found, repairing damage or modifying the bonding lead routing. We are issuing this AD to detect and correct installation of the bonding lead, which could cause arcing and chafing, and could possibly result in an uncontrolled fire.

This notice contains a summary of a petition seeking relief from specified requirements of Title 14, Code of Federal Regulations (14 CFR). The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of the FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This notice contains a summary of a petition seeking relief from specified requirements of Title 14 of the Code of Federal Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This notice contains a summary of a petition seeking relief from specified requirements of Title 14 of the Code of Federal Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

We are adopting a new airworthiness directive (AD) for Airbus Helicopters (previously Eurocopter France) Model EC155B1 and AS 365 N3 helicopters with a certain automated flight control system (AFCS) and with a Garmin global positioning system (GPS) installed. This AD requires revising the Rotorcraft Flight Manual (RFM) to prohibit using the autopilot coupled with a Localizer/Instrument Landing System (LOC/ ILS) or Very High Frequency Omnidirectional Range (VOR) approach. This AD is prompted by a report of unpredictable and unexpected roll oscillations during coupled LOC or VOR approaches.This condition, if not corrected, could result in loss of helicopter control.

This rule establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

This rule amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

The FAA is issuing this notice to advise the public of a meeting of RTCA Special Committee 217Aeronautical Databases being held jointly with EUROCAE WG-44Aeronautical Databases.

The FAA proposes to amend the reciprocal waivers of claims regulations so that customers would waive claims against all the customers involved in a launch or reentry, including those signing a different set of reciprocal waivers. Also, customers of any customer contracting directly with a licensee or permittee would not have to sign a waiver directly with the licensee or permittee, other customers, or the FAA. The FAA also proposes to add an appendix to provide permittees with an example of a Waiver of Claims and Assumption of Responsibility for Permitted Activities with No Customer. The proposed rule would incorporate the reciprocal waiver of claims requirements in the regulatory text, ensure that customers would waive claims against all other customers involved in a launch or reentry, including those signing different reciprocal waivers, reduce the need for licensees and permittees to request a partial waiver of the reciprocal waiver of claims requirements and for the FAA to process those requests, and provide a reciprocal waiver template for permittees with no customers, reducing the need for the FAA to assist such a permittee in drafting its cross waivers.

The FAA publishes a monthly notice, as appropriate, of PFC approvals and disapprovals under the provisions of the Aviation Safety and Capacity Expansion Act of 1990 (Title IX of the Omnibus Budget Reconciliation Act of 1990) (Pub. L. 101-508) and Part 158 of the Federal Aviation Regulations (14 CFR part 158). This notice is published pursuant to paragraph d of Sec. 158.29.

We are revising an earlier proposed airworthiness directive (AD) for certain Airmotive Engineering Corp. (AEC) replacement parts manufacturer approval (PMA) cylinder assemblies marketed by Engine Components International Division (ECi). These cylinder assemblies are used on all Continental Motors, Inc. (CMI) model 520 and 550 reciprocating engines, and on all other CMI engine models approved for the use of model 520 and 550 cylinder assemblies, such as the CMI model 470 when modified by supplemental type certificate (STC). The NPRM proposed to require initial and repetitive inspections, replacement of cracked cylinder assemblies, and replacement of cylinder assemblies at reduced times-in-service. The NPRM also proposed to prohibit the installation of affected cylinder assemblies into any engine. The NPRM was prompted by reports of multiple cylinder head-to-barrel separations and cracked and leaking aluminum cylinder heads. This supplemental NPRM (SNPRM) modifies the schedule for removal of the affected cylinder assemblies, adds that overhauled affected cylinder assemblies be removed within 80 hours, eliminates a reporting requirement, and removes the requirement for initial and repetitive inspections. We are proposing this SNPRM to prevent failure of the cylinder assemblies, which could lead to failure of the engine, in-flight shutdown, and loss of control of the airplane. We are reopening the comment period to allow the public the chance to comment on the proposed changes to the NPRM.

This notice contains a summary of a petition seeking relief from specified requirements of Title 14 of the Code of Federal Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This notice contains a summary of a petition seeking relief from specified requirements of Title 14 of the Code of Federal Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

The FAA proposes to replace the Orders limiting scheduled operations at John F. Kennedy International Airport (JFK), limiting scheduled operations at Newark Liberty International Airport (EWR), and limiting scheduled and unscheduled operations at LaGuardia Airport (LGA). The Orders are scheduled to expire when this proposed rule becomes effective but not later than October 29, 2016. This proposal is intended to provide a longer-term and comprehensive approach to slot management at JFK, EWR, and LGA. The FAA proposes to maintain the limits on scheduled and unscheduled operations in place under the Orders, limit unscheduled operations at JFK and EWR, and require use of an allocated slot 80% of the time for the same flight or series of flights to retain historic precedence. The FAA also proposes five alternatives for a secondary market that would allow carriers to buy, sell, lease, and trade slots. The DOT proposes to review certain slot transfer transactions for significant anti-competitive effects and harms to the public interest. Finally, the FAA proposes minor miscellaneous amendments to remove inapplicable references in the High Density Rule.

We propose to adopt a new airworthiness directive (AD) for GA 8 Airvan (Pty) Ltd Model GA8-TC320 airplanes. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as missing required engine mount fire seal washers, which could reduce the engine retention capability in the event of a fire. We are issuing this proposed AD to require actions to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain GROB-WERKE Models G115EG and G120A airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as a defective starter solenoid. We are issuing this AD to require actions to address the unsafe condition on these products.

The FAA is issuing this notice to advise the public that a meeting of the Federal Aviation Administration Air Traffic Procedures Advisory Committee (ATPAC) will be held to review present air traffic control procedures and practices for standardization, revision, clarification, and upgrading of terminology and procedures.