Federal Aviation Administration 2008 – Federal Register Recent Federal Regulation Documents

This action proposes to modify the existing Class E airspace at Reno/Tahoe International Airport, Reno, NV. Additional controlled airspace is necessary to accommodate aircraft using the Localizer (LOC) Z Runway 16R approach at Reno/Tahoe International Airport, Reno, NV. The FAA is proposing this action to enhance the safety and management of aircraft operations at Reno/Tahoe International Airport, Reno, NV.

The FAA proposes to rule and invites public comment on the release of land at the Ellington Field under the provisions of Section 125 of the Wendell H. Ford Aviation Investment Reform Act for the 21st Century (AIR 21).

The FAA is making available the EA and FONSI/ROD for Proposed Northeast Cargo Area Improvements at Chicago O'Hare International Airport. The EA was prepared in accordance with the National Environmental Policy Act (NEPA) of 1969, as amended, FAA Orders 1050.1E, ``Environmental Impacts: Policies and Procedures'' and FAA Order 5050.4B, ``NEPA Implementing Instructions for Airport Actions''. The FONSI/ROD contains FAA's findings that no significant environmental impacts would result from the project and contains all needed approvals for the action to proceed. Point of Contact: Ms. Amy Hanson, Environmental Protection Specialist, CHI-603, Federal Aviation Administration, Chicago Airport District Office, 2300 East Devon Avenue, Des Plaines, IL 60018. Telephone number: 847-294-7354.

This action establishes Class D airspace and Class E airspace at Lone Star Executive Airport, Conroe, TX. Establishment of an air traffic control tower at Lone Star Executive Airport has made this action necessary for the safety of Instrument Flight Rule (IFR) operations at the airport. Class D airspace will revert to a Class E Surface Area during periods when the control tower is not operating. This action also corrects the radials used to define the airspace.

This action establishes Class E airspace at South Texas International Airport, Edinburg, TX. Addition of Standard Instrument Approach Procedures (SIAPs) have made this action necessary for the safety of Instrument Flight Rule (IFR) operations at the airport.

This action changes the using agency of Restricted Area 4806W (R-4806W), Las Vegas; 4807 (R-4807 A & B), Tonopah; and 4809 (R-4809) Tonopah, NV, from ``U.S. Air Force, Commander, Tactical Fighter Weapons Center, Nellis AFB, NV'' to ``USAF Warfare Center, Nellis AFB, NV''. The FAA is taking this action in response to a request from the United States Air Force to reflect an administrative change of responsibility for the restricted area. This action does not change any boundaries, times of designation, or activities conducted in the restricted airspace area.

This action codifies special flight rules and airspace and flight restrictions for certain aircraft operations in the Washington, DC Metropolitan Area. The FAA takes this action in the interest of national security. This action is necessary to enable the Department of Homeland Security (DHS) and the Department of Defense (DOD) to effectively execute their respective constitutional and Congressionally-mandated duties to secure, protect, and defend the United States.

We propose to adopt a new airworthiness directive (AD) for certain Hawker Beechcraft Corporation (HBC) Models 1900, 1900C, and 1900D airplanes. This proposed AD would require a one-time visual inspection and repetitive ultrasonic inspections of the left and right main landing gear (MLG) actuators for leaking and/or cracks with replacement of the actuator if leaking and/or cracks are found. This proposed AD results from reports of leaking and cracked actuators. We are proposing this AD to detect and correct leaking and cracks in the MLG actuators, which could result in loss of hydraulic fluid. This condition could lead to an inability to extend or lock down the landing gear, which could result in a gear up landing or a gear collapse on landing.

The FAA is issuing this notice to advise the public of a third meeting of RTCA Special Committee 213, Standards for Air Traffic Data Communication Services.

This action establishes Class E Airspace at Clewiston, FL. Airspace is needed to support new Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedures (SIAPs) that have been developed for Airglades Airport. As a result, controlled airspace extending upward from 700 feet Above Ground Level (AGL) is needed to contain the SIAP and for Instrument Flight Rule (IFR) operations at the airport. The operating status of the airport will change from Visual Flight Rules (VFR) to include IFR operations concurrent with the publication of the SIAP. This action enhances the safety and airspace management of Airglades Airport, Clewiston, FL.

This action revises the Class E Airspace at Summerville Airport (SXL); Summerville, WV to provide for adequate controlled airspace for those aircraft using Instrument Approach Procedures to the airport. The Nicholas NDB has been decommissioned and all reference to the NDB in the Summerville Class E5 airspace description is being removed. Additionally, the FAA determined that the Class E airspace should be revised to provide the appropriate controlled airspace for the Instrument Approach Procedures to SXL. This action will enhance the safety and airspace management around the Summerville Airport.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for all Boeing Model 747-100, 747-100B, 747-100B SUD, 747-200B, 747-200C, 747- 200F, 747-300, 747-400, 747-400D, 747-400F, and 747SR series airplanes. This AD requires repetitive inspections for cracks or fractures of the forward end attachment and the forward lower flange of the flap tracks of the trailing edge flaps, and corrective actions if necessary. For certain airplanes, this AD would also require modifying the fail-safe links of the main carriage. This AD results from a detailed structural analysis of the flap attach structural and fail-safe components, accomplished as a result of a dynamic stability and control analysis, which could not demonstrate continued safe flight and landing of the airplane after the loss of a trailing edge flap. We are issuing this AD to detect and correct cracks or fractures of the primary structural and fail-safe load paths of the inboard and outboard trailing edge flaps, which could result in the loss of a flap during takeoff or landing, reducing flightcrew ability to maintain the safe flight and landing of the airplane.

We are revising an earlier proposed airworthiness directive (AD) for all Boeing Model 707 airplanes and Model 720 and 720B series airplanes. The original NPRM would have required performing an operational test of the engine fuel suction feed of the fuel system, and other related testing if necessary. The original NPRM resulted from a report of in-service occurrences of loss of fuel system suction feed capability, followed by total loss of pressure of the fuel feed system. This action revises the original NPRM by reducing the compliance time for low-utilization airplanes, and including corrective actions that were inadvertently omitted from certain sections. The corrective actions are replacing the o-rings if any leakage is found in the couplings, and replacing the fuel line if any leakage is found in the fuel line. We are proposing this supplemental NPRM to detect and correct failure of the engine fuel suction feed capability of the fuel system, which could result in multi-engine flameout, inability to restart the engines, and consequent forced landing of the airplane.

This action proposes to remove, rename and expand the Class E airspace areas serving Guam International Airport, Anderson AFB and Saipan Island. Additionally, this proposed action would revoke the Saipan Island Class E surface area since it is no longer required, and expand other controlled airspace areas to protect aircraft conducting instrument approaches to Saipan International Airport. The FAA is proposing these actions to enhance the safety and management of aircraft operations in the vicinity of the Northern Mariana Islands.

We propose to revise Airworthiness Directive (AD) 2006-08-08, which applies to certain Air Tractor, Inc. (Air Tractor), Models AT- 400, AT-401, AT-401B, AT-402, AT-402A, and AT-402B airplanes. AD 2006- 08-08 currently requires you to repetitively eddy current inspect the wing lower spar cap in order to reach the safe life and, for certain Models AT-402A and AT-402B airplanes and those that incorporate or have incorporated Marburger Enterprises, Inc. (Marburger), winglets, lowers the safe life for the wing lower spar cap. Since we issued AD 2006-08- 08, we have received information to update inspection intervals for the Models AT-401B, AT-402A, and AT-402B airplanes based on a revised damage tolerance analysis. Consequently, this proposed AD would not only retain the actions of AD 2006-08-08, but would reduce the number of repetitive inspections for all affected Model AT-401B airplanes and certain Models AT-402A and AT-402B airplanes. We are proposing this AD to prevent fatigue cracks from occurring in the wing lower spar cap before the originally established safe life is reached. Fatigue cracks in the wing lower spar cap, if not detected and corrected, could result in wing separation and loss of control of the airplane.

This establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

The FAA is withdrawing a previously published Notice of Intent to Request Revision From the Office of Management and Budget of a Currently Approved Information Collection Activity that proposed to extend without change the approved information collection titled ``Washington, DC Metropolitan Area Special Flight Rules'' (OMB Control Number 2120-0706). We are withdrawing the document because, while the collection activity has approval from the Office of Management and Budget, approval and publication of the final rule is still pending.

This action proposes to revise Class D and E airspace at King Salmon, AK. Nine Standard Instrument Approach Procedures (SIAPs), and a textual Obstacle Departure Procedure (ODP) are being amended for the King Salmon Airport at King Salmon, AK. Adoption of this proposal would result in revision of Class D and E airspace upward from the surface, and from 700 feet (ft.) and 1,200 ft. above the surface at the King Salmon Airport, King Salmon, AK.

These special conditions are issued for the Airbus A318, A319, A320, and A321 series airplanes. These airplanes, as modified by L2 Consulting Services, will have a novel or unusual design feature associated with Astronautics electronic flight bags which use lithium battery technology. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

The FAA proposes to rule and invite public comment on the release of land at the Killeen-Skylark Field under the provisions of Section 125 of the Wendell H. Ford Aviation Investment Reform Act for the 21st Century (AIR 21).

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The minimum performance standard (MPS) for Personnel Parachute Assemblies and Components contained in Appendix 1 of technical standard order (TSO)-C23e is substantially different from the version submitted for public comment. As such, this notice announces the cancellation of TSO-C23e.