Federal Aviation Administration November 2018 – Federal Register Recent Federal Regulation Documents

We are adopting a new airworthiness directive (AD) for Leonardo S.p.A. (Leonardo) Model AW189 helicopters. This AD requires replacing the tail plane lower fitting with an improved tail plane lower fitting. This AD was prompted by reports of cracks on the tail plane fittings of Model AW189 helicopters. The actions of this AD are intended to correct an unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for all CFM International S.A. (CFM) LEAP-1B21, LEAP-1B23, LEAP-1B25, LEAP-1B27, LEAP-1B28, LEAP-1B28B1, LEAP-1B28B2, LEAP-1B28B2C, LEAP-1B28B3, LEAP- 1B28BBJ1, and LEAP-1B28BBJ2 turbofan engines with a certain high- pressure turbine (HPT) stator case (HPT cases) installed. This AD requires removal of affected HPT cases from service and their replacement with a part eligible for installation. This AD was prompted by the discovery of a quality escape at a manufacturing facility involving unapproved welds on HPT cases. We are issuing this AD to address the unsafe condition on these products.

This notice contains a summary of a petition seeking relief from specified requirements of Federal Aviation Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-100-1A10 airplanes. This proposed AD was prompted by a report that certain split ball bearings used in main landing gear (MLG) side brace actuator assemblies are manufactured from material that does not meet the required material properties. This proposed AD would require an inspection of the left and right MLG side brace actuator assembly and, if necessary, replacement of the split ball bearing. We are proposing this AD to address the unsafe condition on these products.

This action proposes to amend Area Navigation (RNAV) Route T- 333 in the western United States. The modification is necessary due to the planned decommissioning of Priest, CA, VOR navigation aid (NAVAID), which provides navigation guidance for portions of affected ATS route V-485. The decommissioning has rendered portions of V-485 unusable and amending T-333 will overcome affected portions of V-485. The Priest, CA, VOR is being decommissioned as part of the FAA's VOR Minimum Operational Network (MON) program.

This action proposes to amend Class E airspace extending upward from 700 feet above the surface at Marion County Regional Airport, Flippin, AR, and Baxter County Airport, Mountain Home, AR, which is contained within the Flippin, AR, airspace legal description. The FAA is proposing this action as the result of the decommissioning of the Flippin VHF omnidirectional range (VOR) navigation aid, which provided navigation information for the instrument procedures at these airports, as part of the VOR Minimum Operational Network (MON) Program. The geographic coordinates of the Marion County Regional Airport and name of Baxter County Airport would also be updated to coincide with the FAA's aeronautical database.

We are adopting a new airworthiness directive (AD) for all Fokker Services B.V. Model F28 airplanes. This AD was prompted by reports that filters, which are integral to certain T-unions in the landing gear hydraulic control system, disconnected from their housing and, in some cases, migrated. This AD requires replacing certain T- unions with an integral filter with T-unions without an integral filter. We are issuing this AD to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for all The Boeing Company Model 747-8 and 747-8F series airplanes. This AD was prompted by a report that flightcrew oxygen masks did not function as designed during flight testing. This AD requires an inspection to determine if certain oxygen masks/regulators are installed, and replacement if necessary. We are issuing this AD to address the unsafe condition on these products.

In accordance with the Federal Civil Penalties Inflation Adjustment Act Improvements Act of 2015, this final rule provides the 2018 inflation adjustment to civil penalty amounts that may be imposed for violations of certain DOT regulations. This rule also finalizes the National Highway Traffic Safety Administration's and the Office of the Secretary's catch-up inflation adjustment interim final rules required by the same Act.

The FAA is considering a proposal to change 131.227 acres of airport land from aeronautical use to non-aeronautical use and to authorize the sale of airport property located at Indianapolis International Airport, Indianapolis, Indiana. The aforementioned land is not needed for aeronautical use. The 131.227 acres is located along High School Road between Sam Jones Expressway to the south and the CSX railroad to the north. The land formerly served as parking areas for Indianapolis International Airport. The proposed use of the property is to be used for corporate development.

This action modifies Class E airspace extending up to 700 feet above the surface at Lac Qui Parle County Airport, Madison, MN, to accommodate new standard instrument approach procedures for instrument flight rules (IFR) operations at the airport. The FAA is taking this action due to the decommissioning of the Madison non-directional radio beacon (NDB) and cancellation of the associated approach. This enhances the safety and management of IFR operations at the airport.

This action establishes Class E surface airspace at Dothan Regional Airport, Dothan, AL. The Class E surface airspace is established for the safety of aircraft landing and departing the airport when the air traffic control tower is closed. Also, this action amends Class D airspace by updating the airport's name and geographic coordinates, as well as replacing the outdated term `Airport/Facility Directory' with `Chart Supplement'. Additionally, the geographic coordinates of the airport and Wiregrass VORTAC are adjusted in the associated Class E airspace to match the FAA's aeronautical database; as well as removing the part-time status of the airspace for Class E airspace designated as an extension to a Class D surface area. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations at this airport.

We propose to adopt a new airworthiness directive (AD) for MDHI Model 369A, 369D, 369E, 369FF, 369H, 369HE, 369HM, 369HS, 500N, and 600N helicopters. This proposed AD would require inspecting each main rotor blade (MRB) for a crack. This proposed AD is prompted by reports of cracked MRBs. The actions of this proposed AD are intended to address an unsafe condition on these helicopters.

We are removing Airworthiness Directive (AD) 93-14-19, which applied to certain The Boeing Company Model 767-200 and -300 series airplanes. AD 93-14-19 required inspections for disbonding of the trailing edge wedge of the leading edge slat; and repair, if necessary. We issued AD 93-14-19 to prevent the loss of a trailing edge wedge, which could result in reduced maneuver margins, reduced speed margins to stall, and unexpected roll before stall warning, all of which would adversely affect the controllability of the airplane. Since we issued AD 93-14-19, an updated stability and control analysis showed that the worst-case scenario of a trailing edge wedge disbond in-flight would not adversely affect the controllability of the airplane. Accordingly, AD 93-14-19 is removed.

We are adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-200 Freighter series airplanes, Model A330-200 and -300 series airplanes, and Model A340-200 and -300 series airplanes. This AD was prompted by defects found during production tests of ram air turbine (RAT) units; investigation revealed that the defects were due to certain RAT hydraulic pumps having an alternative manufacturing process of the pump pistons. This AD requires replacing any defective RAT hydraulic pump with a serviceable part and re- identifying the RAT module part number. We are issuing this AD to address the unsafe condition on these products.

We propose to adopt a new airworthiness directive (AD) for certain Dassault Aviation Model FAN JET FALCON, and FAN JET FALCON SERIES C, D, E, F, and G airplanes. This proposed AD was prompted by a determination that new or more restrictive airworthiness limitations and maintenance requirements are necessary. This proposed AD would require revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations and maintenance requirements. We are proposing this AD to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for all Airbus SAS Model A318 and A319 series airplanes; Model A320-211, A320- 212, A320-214, A320-216, A320-231, A320-232, and A320-233 airplanes; and Model A321-111, A321-112, A321-131, A321-211, A321-212, A321-213, A321-231, and A321-232 airplanes. This AD was prompted by reports of missing assembly hardware on the trimmable horizontal stabilizer actuator (THSA). This AD requires repetitive inspections and checks of the lower and upper THSA attachments and applicable related investigative and corrective actions; a one-time inspection of the THSA lower attachment and replacement as applicable; and, for certain airplanes, activation of the electrical load sensing device (ELSD) and concurrent modifications. We are issuing this AD to address the unsafe condition on these products.

These special conditions are issued for the Textron Aviation Inc. (Textron) Model 560XL, formerly known as, prior to July 29, 2015, the Cessna Model 560XL. This airplane, as modified by Garmin International (Garmin), will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. This design feature is Garmin G5000 avionics that allow internal connection to previously isolated data networks, which are connected to systems that perform functions required for the safe operation of the airplane. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on July 31, 2018. The collection involves FAA Form 5280-1, Application for Airport Operating Certificate. Every airport that wants to become a certificated airport must complete this form, as well as provide a draft Airport Certification Manual (ACM). In addition, currently certificated airports must maintain their ACM, as well as keep and maintain records related to training, self-inspection, and other requirements. These records allow the FAA to verify compliance with regulation safety and operational requirements to ensure that the airports meet the minimum safety requirements, which in turn enhances the safety of the flying public.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on September 19, 2018. Airworthiness Directives are regulations issued to require corrective action to resolve an unsafe condition in aircraft, engines, propellers, and appliances. Reports of inspections are often needed when emergency corrective action is taken to determine if the action was adequate to correct the unsafe condition. The respondents are aircraft owners and operators.

This action establishes Class E surface airspace at Tyndall Air Force Base, (AFB), FL, for the safety of aircraft landing and departing the airport when the air traffic control tower is closed. Also, this action amends Class D airspace by updating the geographic coordinates of this airport, as well as replacing the outdated term ``Airport/Facility Directory'' with ``Chart Supplement''. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations at this airport.

The FAA is correcting an airworthiness directive (AD) that published in the Federal Register. That AD applies to certain Bombardier, Inc., Model DHC-8-300 series airplanes. As published, a service information citation is incorrect. This document corrects the error. In all other respects, the original document remains the same.

We propose to adopt a new airworthiness directive (AD) for Airbus Helicopters Deutschland GmbH (Airbus Helicopters) Model MBB-BK 117 C-2 helicopters. This proposed AD would require establishing or reducing the life limit of various parts. This proposed AD is prompted by recalculations. The actions of this proposed AD are intended to address an unsafe condition on these products.

We propose to adopt a new airworthiness directive (AD) for certain Pratt & Whitney Division (PW) PW4158 turbofan engines. This proposed AD was prompted by several reports of high cycle fatigue (HCF) cracks found in the fuel nozzle supply manifold. This proposed AD would require replacement of the affected fuel nozzles and fuel nozzle manifold supply assemblies with parts eligible for installation. This proposed AD would also require installation of new brackets and clamps on the fuel supply manifold assemblies. We are proposing this AD to address the unsafe condition on these products.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on October 9, 2018. The collection involves return to the Civil Aviation Aircraft Registry of information relating to the release of a lien that has been recorded with the Registry. Regulations provide for establishing and maintaining a system for the recording of security conveyances affecting title to, or interest in U.S. civil aircraft, as well as certain specifically identified engines, propellers, or spare parts locations, and for recording of releases relating to those conveyances. Federal Aviation Regulations establish procedures for implementation. Regulations describe what information must be contained in a security conveyance in order for it to be recorded with FAA. The convention on the International Recognition signatory, prevents, by treaty, the export of an aircraft and cancellation of its nationality marks if there is an outstanding lien recorded. The Civil Aviation Registry must have consent or release of lien from the lienholder prior to confirmation/cancellation for export.