Federal Aviation Administration March 2010 – Federal Register Recent Federal Regulation Documents

This action proposes to amend Class E airspace at Manila, AR. Decommissioning of the Manila non-directional beacon (NDB) at Manila Municipal Airport has made this action necessary for the safety and management of Instrument Flight Rules (IFR) operations at the airport.

We propose to adopt a new airworthiness directive (AD) for the products listed above that would supersede an existing AD. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA proposes to rule and invites public comment on the application to impose and use PFC revenue at Los Angeles International Airport, under the provisions of the Aviation Safety and Capacity Expansion Act of 1990 (Title IX of the Omnibus Budget Reconciliation Act of 1990) (Pub. L. 101-508) and Part 158 of the Federal Aviation Regulations (14 CFR part 158).

The Federal Aviation Administration (FAA) is making minor technical changes to a final rule published in the Federal Register on December 12, 2007. That final rule required holders of design approvals to make damage tolerance data for repairs and alterations to fatigue critical airplane structure available to operators. After issuing the final rule, the FAA determined that further changes were needed to clarify the applicability of certain provisions and the compliance time of another provision.

This action proposes to revise Class E airspace at Wainwright, AK. The amendment of four Standard Instrument Approach Procedures (SIAPs), and the development of one Obstacle Departure Procedure (ODP) at Wainwright Airport have made this action necessary to enhance safety and management of Instrument Flight Rules (IFR) operations.

This action proposes to establish Class E airspace at Kemmerer Municipal Airport, Kemmerer, WY, to accommodate new Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedures (SIAPs) at the airport. This action would enhance the safety and management of Instrument Flight Rules (IFR) operations at the airport.

This action proposes to amend Class D and E airspace at Victorville, CA. Additional Class D airspace is needed for Instrument Flight Rules (IFR) operations at Southern California Logistics Airport that would allow aircraft operations outside Class D at Adelanto Airport. This action is necessary for the safety and management of Instrument Flight Rules (IFR) aircraft utilizing both airports. This action also would note the airport name change.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for certain Hawker Beechcraft Corporation Model G58 airplanes. This AD requires inspecting the installation of stand-off hardware between the heater fuel line and the heater over-temperature sensor wires and also brake reservoir tubing and the heater fuel pump wiring for minimum clearance and installing acceptable stand-off hardware if stand-off hardware is missing or inadequate. This AD results from reports received of a power wire shorting out on the brake reservoir tube. We are issuing this AD to detect and correct inadequate clearance of the brake reservoir tubing and the heater fuel pump wiring, which could result in chafing and shorting out of the electrical wiring and chafing of the tubing carrying flammable fluids. This condition could lead to a fire in the nose wheel well.

The FAA invites public comments about our intention to request the Office of Management and Budget (OMB) to approve a current information collection. This information collection is required for compliance with the final rule that codifies special flight rules and airspace and flight restrictions for certain operations in the Washington, DC Metropolitan Area. OMB has granted this collection a six-month clearance expiring in August, 2010, in order for FAA to provide clarifying details about the collection methods; this notice is to correspond with an immediate resubmission to OMB for full three-year clearance.

The FAA proposes to supersede an existing airworthiness directive (AD) for certain Turbomeca Arriel 1B, 1D, 1D1, and 1S1 turboshaft engines. That AD requires initial and repetitive relative position checks of the gas generator 2nd stage turbine blades on Turbomeca Arriel 1B (that incorporate Turbomeca Modification (mod) TU 148), Arriel 1D, 1D1, and 1S1 turboshaft engines that do not incorporate mod TU 347. That AD also requires initial and repetitive replacements of 2nd stage turbines on Arriel 1B, 1D, and 1D1 engines. This proposed AD would require lowering the repetitive threshold for relative position checks on Arriel 1B engines. This proposed AD would also require lowering the initial and repetitive thresholds for replacement of 2nd stage turbines on Arriel 1B, 1D, and 1D1 engines. This proposed AD results from reports of new cases of failures of 2nd stage turbine blades since we issued AD 2008-07-01. We are proposing this AD to prevent the failure of 2nd stage turbine blades, which could result in an uncommanded in-flight engine shutdown, and a subsequent forced autorotation landing or accident.

This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: Due to their position on the airplane, fuel fire shut-off valve actuators P/N [part number] 9409122 are susceptible to freezing, which has an adverse effect on the operation of the valve. Also, due to various causes, the failure rate of [fuel fire shut-off valve] actuator P/N 9409122 is higher than expected. Failure or freezing of the actuator may prevent the flight crew to close the fuel fire shut-off valve in case of an engine fire. Due to their position on the aeroplane, fuel crossfeed valve actuators P/N 9409122 are susceptible to freezing, which has an adverse effect on the operation of the valve. This condition, if not corrected, may generate fuel asymmetry alerts when a valve remains in the open position after being selected closed. It may also prevent the flight crew from correcting a fuel asymmetry when a valve remains in the closed position after being selected open. One event was reported where, due to such problems, the flight crew shut down an engine in-flight and diverted the aircraft. [D]ue to their position on the aircraft, ice may form on actuators P/N 9409122 installed on fuel crossfeed valves and fuel fire shut-off valves. Tests revealed that the ice can prevent the actuator and thus the valve from operating in flight (frozen stuck).

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for certain Model 747-100, 747-200B, 747-300, and 747SR series airplanes. This AD requires installation of a closeout panel and moisture curtains for the main equipment center. This AD results from a report of water contamination in the electrical and electronic units in the main equipment center. We are issuing this AD to prevent the malfunction of one or more electrical and electronic units in the main equipment center, which could adversely affect the airplane's continued safe flight.

The FAA invites public comments about our intention to request the Office of Management and Budget (OMB) to approve a current information collection. Title 49 U.S.C. 44703(h) mandates that all U.S. air carriers operating under 14 CFR parts 121 or 135, and all U.S. air operators under 14 CFR part 125, and certain others, request and receive certain training, safety, and testing records before extending a firm offer of employment to an individual who is applying to their company as a pilot.

The FAA invites public comments about our intention to request the Office of Management and Budget (OMB) to approve a current information collection. Part A of Subtitle VII of the Revised Title 49 United States Code authorizes the issuance of regulations governing the use of navigable airspace. 14 CFR Part 125 prescribes requirements for leased aircraft, Aviation Service Firms, and Air Travel.

The Federal Aviation Administration (FAA) announces its determination that the noise exposure maps submitted by City of Chandler, for Chandler Municipal Airport under the provisions of 49 U.S.C. 47501 et seq. (Aviation Safety and Noise Abatement Act) and 14 CFR part 150 are in compliance with applicable requirements.

The FAA is issuing this notice to advise the public of a meeting of RTCA Special Committee 217: Joint with EUROCAE WG-44 Terrain and Airport Mapping Databases.

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

The FAA is replacing Special Federal Aviation Regulation 100-1 (SFAR 100-1), with SFAR 100-2 that continues to allow Flight Standards District Offices (FSDOs) to accept expired flight instructor certificates and inspection authorizations for renewals from U.S. military and civilian personnel (U.S. personnel) who are assigned outside the United States in support of U.S. Armed Forces operations. SFAR 100-2 also continues to allow FSDOs to accept expired airman written test reports for certain practical tests from U.S. personnel who are assigned outside the United States in support of U.S. Armed Forces operations. This action is necessary to avoid penalizing U.S. personnel who are unable to meet the regulatory time limits of their flight instructor certificate, inspection authorization, or airman written test report because they are serving outside the United States in support of U.S. Armed Forces operations. The effect of this action is to give U.S. personnel who are assigned outside the United States in support of U.S. Armed Forces operations extra time to meet certain eligibility requirements in the current rules.

We propose to adopt a new airworthiness directive (AD) for the products listed above that would supersede an existing AD. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI for EMBRAER Model ERJ 170 describes the unsafe condition as: It has been found the occurrence of an engine in-flight shutdown caused by the LPCV [low pressure check valves] failing to close due to excessive wear, which leads to the concern that such fault may be present in both engines of a given aircraft. The MCAI for EMBRAER Model ERJ 190 describes the unsafe condition as: An occurrence of an uncommanded engine in-flight shutdown (IFSD) was reported, which was caused by an ERJ 170 defective LPCV. The valve failed to close due to excessive wear. Despite there were no IFSD related to LPCV failure, some ERJ 190 valves were inspected and presented cracks due to low cycle fatigue. Since this failure mode also might lead to an engine in-flight shutdown and since both engines of the airplane have the same valves, there is a possibility of an occurrence of a dual engine IFSD due to LPCV failure.

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: It has been evidenced by test that the tightening torque settings on the Rolls Royce Trent 500 and Trent 700 forward (FWD) and aft (AFT) engine mount link pin retention bolts have always been higher than the design value. These bolts retain the washers that maintain the engine mount vertical load pins in position. If bolts, as a consequence of the over-torque, fail and move away, it would lead to loss of the vertical load pins, which could result in loss of the primary and/or secondary load path of the forward and/or aft engine mount which could potentially lead to engine separation.

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.