Department of Transportation 2017 – Federal Register Recent Federal Regulation Documents

This document grants in full the Ford Motor Company's (Ford) petition for exemption of the EcoSport vehicle line in accordance with 49 CFR part 543, Exemption from the Theft Prevention Standard. This petition is granted because the agency has determined that the antitheft device to be placed on the line as standard equipment is likely to be as effective in reducing and deterring motor vehicle theft as compliance with the parts-marking requirements of 49 CFR part 541, Federal Motor Vehicle Theft Prevention Standard (Theft Prevention Standard). Ford also requested confidential treatment for specific information in its petition. While official notification granting or denying its request for confidential treatment will be addressed by separate letter, no confidential information provided for purposes of this document has been disclosed.

Autoliv, Inc. (Autoliv), on behalf of Autoliv B.V. & CO. KG, has determined that certain Autoliv seat belt assemblies do not fully comply with Federal Motor Vehicle Safety Standard (FMVSS) No. 209, Seat Belt Assemblies. Autoliv filed a noncompliance report dated December 1, 2016. Autoliv also petitioned NHTSA on December 23, 2016, for a decision that the subject noncompliance is inconsequential as it relates to motor vehicle safety.

We propose to adopt a new airworthiness directive (AD) for Airbus Helicopters (Airbus) Model AS332L2 and EC225LP helicopters. This proposed AD would require inspections of the main rotor (M/R) blade attachment pins (attachment pins). This proposed AD is prompted by a report of three cracked attachment pins. The proposed actions are intended to detect and prevent an unsafe condition on these products.

The FAA proposes to rule and invites public comment on the release of land at Walnut Ridge Regional Airport under the provisions of Section 125 of the Wendell H. Ford Aviation Investment Reform Act for the 21st Century (AIR 21).

These special conditions are issued for the Embraer S.A. (Embraer) Model ERJ 190-300 series airplanes. These airplanes will have novel or unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. These design features are electrical and electronic systems that perform critical functions, the loss of which could be catastrophic to the airplane. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for these design features. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

The Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

The Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

The Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

The Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

We are adopting a new airworthiness directive (AD) for Airbus Helicopters Deutschland GmbH (Airbus Helicopters) Model MBB-BK117 C-2 helicopters. This AD requires inspecting the pilot collective wiring harness and was prompted by a report that the heat-shrinkable sleeve prevented the twist grip on the collective from being fully engaged during a flight test. The actions of this AD are intended to prevent an unsafe condition on these products.

We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL-215-6B11 (CL-415 Variant) airplanes. This proposed AD was prompted by a report indicating that an oxygen bottle was found loose while the clamp strap was in the locked position. This proposed AD would require modification of the clamp strap and installation of additional shims, as applicable, to the flight crew's oxygen bottle retaining structures. We are proposing this AD to address the unsafe condition on these products.

These special conditions are issued for non-rechargeable lithium battery installations on the Gulfstream Aerospace LP (GALP) Model Gulfstream 200 airplane, as modified by Gulfstream Aerospace Corporation (Gulfstream). Non-rechargeable lithium batteries are a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

The FAA is correcting a final rule published on September 7, 2016. In that rule, the FAA amended its regulations to relocate and update the content of SFAR No. 108 to the newly created subpart N of part 91 in order to improve the safety of operating the Mitsubishi Heavy Industries (MHI) MU-2B series airplane. This document corrects two errors in the codified text of the final rule.

The FAA is issuing this notice to advise the public of a meeting of Thirty Third RTCA SC-213 Enhanced Flight Vision Systems/ Synthetic Vision Systems (EFVS/SVS) Joint Plenary with EUROCAE Working Group 79.

These special conditions are issued for non-rechargeable lithium battery installations on the Gulfstream Aerospace Corporation (Gulfstream) Model GV-SP airplane. Non-rechargeable lithium batteries are a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

We propose to adopt a new airworthiness directive (AD) for SOCATA Model TBM 700 airplanes that would supersede AD 2002-19-01. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as the flight control wheel traveling beyond normal roll control limits and jamming in a position that could cause loss of control. We are issuing this proposed AD to require actions to address the unsafe condition on these products.

Notice is being given that the Federal Aviation Administration (FAA) is considering a request from the County of Greenwood to waive the requirement that one parcel (10.11 acres) of surplus property, located at the Greenwood County Airport be used for aeronautical purposes. Currently, ownership of the property provides for protection of FAR Part 77 surfaces and compatible land use which would continue to be protected with deed restrictions required in the transfer of land ownership.

This notice contains a summary of a petition seeking relief from specified requirements of title 14, Code of Federal Regulations (14 CFR). The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of the FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

We propose to adopt a new airworthiness directive (AD) for certain Aviat Aircraft Inc. Models A-1C-180 and A-1C-200 airplanes equipped with Rapco part number RA1798-00-1 fuel vent check valves. This proposed AD was prompted by a report that the fuel tank vent check valves are sticking in the closed position causing fuel starvation to the engine. This proposed AD would require checking the fuel vent check valves for proper operation and replacing any inoperative fuel vent check valve with an airworthy part. We are proposing this AD to correct the unsafe condition on these products.

We are superseding Airworthiness Directive (AD) 2015-15-03 for all General Electric Company (GE) GEnx turbofan engine models. AD 2015- 15-03 precluded the use of certain electronic engine control (EEC) full authority digital engine control (FADEC) software on GEnx turbofan engines. This AD requires removing a specific part and replacing it with a part eligible for installation and specifying the EEC FADEC software version for the affected GEnx turbofan engines. This AD was prompted by GE implementing final design changes that remove the unsafe condition. We are issuing this AD to correct the unsafe condition on these products.

This rule amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide for the safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

We are revising an earlier proposed airworthiness directive (AD) that proposed to supersede AD 2011-01-15, which applies to certain The Boeing Company Model 757-200, -200CB, and -300 series airplanes. AD 2011-01-15 requires repetitive inspections for cracking of the fuselage skin of the crown skin panel along the chem-milled step at certain stringers, and repair, if necessary. This action revises the notice of proposed rulemaking (NPRM) by reducing the compliance time for certain inspections. We are proposing this AD to address the unsafe condition on these products. Since these actions impose an additional burden over that proposed in the NPRM, we are reopening the comment period to allow the public the chance to comment on these proposed changes.

FMCSA announces its decision to exempt 46 individuals from its rule prohibiting persons with insulin-treated diabetes mellitus (ITDM) from operating commercial motor vehicles (CMVs) in interstate commerce. The exemptions enable these individuals to operate CMVs in interstate commerce.

FMCSA announces receipt of applications from 36 individuals for exemption from the vision requirement in the Federal Motor Carrier Safety Regulations. They are unable to meet the vision requirement in one eye for various reasons. The exemptions will enable these individuals to operate commercial motor vehicles (CMVs) in interstate commerce without meeting the prescribed vision requirement in one eye. If granted, the exemptions would enable these individuals to qualify as drivers of commercial motor vehicles (CMVs) in interstate commerce.

FRA announces the fifty-seventh meeting of the RSAC, a Federal Advisory Committee (Committee) that develops recommendations on railroad safety regulations and other railroad safety issues through a consensus process. This meeting has been rescheduled from January 26, 2017, the previously announced date. The RSAC meeting topics will include opening remarks from the FRA Associate Administrator for Railroad Safety and Chief Safety Officer, as well as a status report from the Engineering Task Force. In addition, FRA will present to the Committee the consensus recommendations from the Hazardous Materials Working Group's retrospective review of certain portions of the Hazardous Materials Regulations, with the intent of moving for a Committee vote to approve the same. This agenda is subject to change, including the possible addition of further proposed tasks.