Department of Transportation 2010 – Federal Register Recent Federal Regulation Documents

This action proposes to establish Class E Airspace at Colebrook, NH, to accommodate a new Area Navigation (RNAV) Global Positioning System (GPS) Special Standard Instrument Approach Procedure (SIAP) serving the Upper Valley Connecticut Hospital. This action would enhance the safety and airspace management of Instrument Flight Rules (IFR) operations in the National Airspace System.

This action proposes to establish Class E surface airspace and modify existing Class E airspace at Deer Park Airport, Deer Park, WA, to accommodate aircraft using the existing Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedures (SIAPs) at Deer Park Airport. The FAA is proposing this action to enhance the safety and management of aircraft operations at the airport.

The Federal Aviation Administration (FAA) announces its determination that the Noise Exposure Maps submitted by the City of New Smyrna Beach for New Smyrna Beach Municipal Airport under the provisions of 49 U.S.C. 47501 et seq. (Aviation Safety and Noise Abatement Act) and 14 CFR Part 150 are in compliance with applicable requirements.

This action proposes to amend Class E airspace at Arco, ID. Decommissioning of the Arco-Butte County Non-Directional Beacon (NDB) at Arco-Butte County Airport has made this action necessary for the safety and management of Instrument Flight Rules (IFR) operations at Arco-Butte County Airport. This action also would adjust the geographic coordinates of the airport.

The FAA proposes to rule and invites public comment on the release of land at Fort Smith Regional Airport under the provisions of Title 49, U.S.C. Section 47153(c).

This document proposes adopting a new airworthiness directive (AD) for Robinson Model R22, R22 Alpha, R22 Beta, and R22 Mariner helicopters, and Model R44 and R44 II helicopters. The AD would require visually inspecting each tail rotor (T/R) control pedal bearing block support (support) for a crack, measuring the thickness of each uncracked support, installing support safety tabs on certain supports, and replacing supports of a certain thickness during overhaul. This proposal is prompted by two reports of Model R22 helicopters experiencing broken supports during flight, which resulted in the T/R control pedals becoming jammed. The actions specified by the proposed AD are intended to prevent the supports from breaking, which can bind the T/R control pedals, resulting in a reduction of yaw control and subsequent loss of control of the helicopter.

This action revises Class E airspace at Monterey Peninsula Airport, Monterey, CA. The FAA is taking this action in response to a request from the National Aeronautical Charting Office (NACO) to better clarify the legal description of controlled airspace designated as an extension to Class C surface area.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection abstracted below has been forwarded to the Office of Management and Budget (OMB) for review and approval. The nature of the information collection is described as well as its expected burden. The Federal Register notice with a 60-day comment period soliciting comments on the following collection of information was published on April 16, 2010 and expired on June 15, 2010. No comments were received.

This notice announces actions taken by the FHWA that are final within the meaning of 23 U.S.C. 139(l)(1). The actions relate to a proposed highway project, US-95 Garwood to Sagle Environmental Study in Bonner and Kootenai Counties in the State of Idaho, FHWA-ID-EIS-06-F Federal-Aid project number NH-5110(141), Idaho Transportation Department Key Number 9779.

This action will amend Class E airspace at Bozeman, MT, to accommodate aircraft using a new VHF Omni-Directional Radio Range (VOR) Standard Instrument Approach Procedures (SIAPs) at Gallatin Field Airport. This will improve the safety and management of Instrument Flight Rules (IFR) operations at the airport.

FRA is establishing Federal safety requirements for railroad bridges. This final rule requires track owners to implement bridge management programs, which include annual inspections of railroad bridges, and to audit the programs. This final rule also requires track owners to know the safe load capacity of bridges and to conduct special inspections if the weather or other conditions warrant such inspections.

FMCSA announces its proposal to grant a 2-year, limited exemption from the Federal hours-of-service regulations for the transportation of anhydrous ammonia from any distribution point to a local farm retailer or to the ultimate consumer, and from a local farm retailer to the ultimate consumer, as long as the transportation takes place within a 100 air-mile radius of the retail or wholesale distribution point. This exemption would extend the agricultural operations exemption established by section 345 of the National Highway System Designation Act of 1995, as amended, by the sections 4115 and 4130 of the Safe, Accountable, Flexible, Efficient Transportation Equity: A Legacy for Users (SAFETEA-LU) to certain drivers and motor carriers engaged in the distribution of anhydrous ammonia during the planting and harvesting seasons, as defined by the States in which the carriers and drivers operate. The Agency believes that the exemption would likely achieve a level of safety that is equivalent to, or greater than, the level that would be achieved absent such exemption, based on the terms and conditions imposed. This exemption would preempt inconsistent State and local requirements applicable to interstate commerce.

This document adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.

This action will establish Class E airspace at Kemmerer, WY to accommodate aircraft using a new Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedures (SIAPs) at Kemmerer Municipal Airport. This will improve the safety and management of Instrument Flight Rules (IFR) operations at the airport.

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: An A330 experienced an uncommanded engine 1 in flight spool down, which occurred while applying fuel gravity feed procedure, in response to low pressure indications from all fuel boost pumps, in both left and right wings. The investigations revealed that the wing tank pressure switches P/N (part number) HTE69000-1 had frozen due to water accumulated in their external part, causing spurious low pressure indications. As per procedure, the main pumps are then switched off, increasing the level of unavailable fuel. This, in combination with very low fuel quantities or another independent trapped fuel failure scenarios, can lead to fuel starvation on the affected engine(s). The proposed AD would require actions that are

We are adopting a new airworthiness directive (AD) for certain Model 757 airplanes, Model 767 airplanes, and Model 777-200 and -300 series airplanes. This AD requires repetitive inspections for damage of the electrical terminal at the left and right flightdeck window 1, and corrective actions if necessary. This AD also allows for replacing the flightdeck window 1 with a new improved flightdeck window equipped with different electrical connections, which terminates the repetitive inspections for that flightdeck window 1. This AD results from several reports of electrical arcs at the terminal blocks of the electrically heated flightdeck window 1. We are issuing this AD to prevent smoke and fire in the cockpit, which could lead to loss of visibility, and injuries to or incapacitation of the flightcrew.

In accordance with the Paperwork Reduction Act of 1995 and its implementing regulations, the Federal Railroad Administration (FRA) hereby announces that it is seeking renewal of the following information collection activities that were previously approved by OMB. Before submitting these information collection requirements for clearance by the Office of Management and Budget (OMB), FRA is soliciting public comment on specific aspects of the activities identified below.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are superseding an existing airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for certain Model 777 airplanes. This AD requires inspecting the bolt, nut, and downstop of the slat track assembly to determine if the bolt, nut, or stops are missing and to determine if the thread protrusion of the bolt from the nut is within specified limits and parts are correctly installed, and related investigative and corrective actions if necessary. For certain airplanes, this AD also requires inspecting the slat cans at the outboard slat number 3 and 12 outboard main track locations for holes and wear damage, and corrective actions if necessary; and replacing the downstop hardware for the outboard slats number 3 and 12 outboard and inboard main track locations. This AD results from a report of a hole in the inboard main track slat can for outboard slat number 12 on a Model 777 airplane. The hole was caused when the bolt securing the downstop migrated out of the fitting and contacted the slat can. We are issuing this AD to detect and correct damage to the outboard slat main track slat cans, which can allow fuel leakage into the fixed wing leading edge in excess of the capacity of the draining system. Excess fuel leakage could result in an uncontained fire.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is issuing this notice to advise the public of a meeting of RTCA Special Committee 222: Inmarsat Aeronautical Mobile Satellite (Route) Services.