Department of Transportation 2009 – Federal Register Recent Federal Regulation Documents

We are adopting a new airworthiness directive (AD) to supersede AD 2006-24-11, which applies to certain Hawker Beechcraft Corporation (HBC) (Type Certificate previously held by Raytheon Aircraft Company) Models 1900, 1900C, and 1900D airplanes. AD 2006-24- 11 currently requires you to repetitively inspect the forward, vertical, and aft flanges of both the left and right wing rear spar lower caps for cracks, repair any cracks found, and report the inspection results to the manufacturer. Since we issued AD 2006-24-11, the manufacturer has developed a modification kit to install on the wing rear spar lower caps that will terminate the 200-hour repetitive inspection required in AD 2006-24-11. Consequently, this AD requires installing the new modification kits on the wing rear spar lower caps and terminates the repetitive inspections required in AD 2006-24-11 when the kits are installed. We are issuing this AD to prevent fatigue cracks in the wing rear spar lower caps, which could result in fatigue failure of the wing rear spar lower caps. A rear spar failure could result in complete wing failure and the wing separating from the airplane.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

FMCSA previously announced its decision to renew the exemptions from the vision requirement in the Federal Motor Carrier Safety Regulations for 12 individuals. FMCSA has statutory authority to exempt individuals from the vision requirement if the exemptions granted will not compromise safety. The Agency has concluded that granting these exemptions will provide a level of safety that will be equivalent to, or greater than, the level of safety maintained without the exemptions for these commercial motor vehicle (CMV) drivers.

FMCSA announces its decision to renew the exemptions from the vision requirement in the Federal Motor Carrier Safety Regulations for 23 individuals. FMCSA has statutory authority to exempt individuals from the vision requirement if the exemptions granted will not compromise safety. The Agency has concluded that granting these exemption renewals will provide a level of safety that is equivalent to, or greater than, the level of safety maintained without the exemptions for these commercial motor vehicle (CMV) drivers.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2009-0139 at https://www.regulations.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with 46 U.S.C. 12121 and MARAD's regulations at 46 CFR part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2009-0140 at https://www.regulations.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with 46 U.S.C. 12121 and MARAD's regulations at 46 CFR part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the

We are adopting a new airworthiness directive (AD) to revise AD 2009-10-09, which applies to Cessna Aircraft Company (Cessna) 150 and 152 series airplanes. AD 2009-10-09 requires either installing a placard prohibiting spins and other acrobatic maneuvers in the airplane or replacing the rudder stop, the rudder stop bumper, and the attachment hardware with a new rudder stop modification kit and replacing the safety wire with jamnuts. Since we issued AD 2009-10-09, we became aware of a need to clarify certain model and serial number designations, remove the duplicate requirement of replacing the safety wire with jamnuts, and clarify the conditional acceptability of using modification kit part number (P/N) SK152-25 as a terminating action to this AD. Consequently, this AD retains the actions currently required in AD 2009-10-09, corrects model designation for certain serial numbers, removes the duplicate requirement of replacing safety wire with jamnuts, and clarifies the conditional acceptability of using modification kit P/N SK152-25 as a terminating action to this AD. We are issuing this AD to prevent the rudder from traveling past the normal travel limit. Operation in this non-certificated control position is unacceptable and could cause undesirable consequences, such as contact between the rudder and the elevator.

We are adopting a new airworthiness directive (AD) for the products listed above that would revise an existing AD. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: IAI Company Flammability tests revealed that the baggage compartment rubber seals manufactured by Gumiyan are not compliant with FAR [Federal Aviation Regulation] 25, Appendix F, Part I requirements.

The National Highway Traffic Safety Administration (NHTSA) is currently seeking public comment on emerging or potential traffic safety problems. Public feedback will assist the agency in preparing to meet the challenges it faces in the next 5 years on improving motor vehicle and traffic safety in the United States. This foundational work will assist the agency in shaping its 2010-2015 strategic plan.

We propose to adopt a new airworthiness directive (AD) for the products listed above that would supersede an existing AD. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: Following in-flight test deployments, several Air-Driven generators (ADGs) failed to come on- line. Investigation revealed that, as a result of a wiring anomaly that had not been detected during ADG manufacture, a short circuit was possible between certain internal wires and their metallic over-braided shields, which could result in the ADG not providing power when deployed. The unsafe condition is that failure of the ADG could lead to loss of several functions essential for safe flight. The proposed AD

The FAA proposes to rule and invite public comment on the release of land at the Gunnison-Crested Butte Regional Airport under the provisions of Section 47125(a) of Title 49 United States Code (U.S.C.).

These special conditions are issued for the Cessna Aircraft Company, Model 525C airplane. This airplane will have a novel or unusual design feature(s) associated with turbofan engines, engine location, and certain performance characteristics necessary for this type of airplane that were not envisioned by the existing regulations. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Requirement (ICR) abstracted below has been forwarded to the Office of Management and Budget (OMB) for review and comment. The ICR describes the nature of the information collection and its expected burden. The Federal Register notice with a 60-day comment period soliciting comments on the following collection of information was published on August 24, 2009 (74 FR 42732).

Section 1604(b)(7) of the Safe, Accountable, Flexible, Efficient Transportation Equity Act: A Legacy for Users (SAFETEA-LU) (Pub. L. 109-59; Aug. 10, 2005), authorizes the Secretary of Transportation (Secretary) to develop and publish performance goals for each express lane project accepted under the Express Lanes Demonstration Program. This notice lists the Performance Goals, Monitoring and Reporting Program requirements for the IH-30 (the Tom Landry Freeway) Express Lanes project and IH-35E Express Lanes project in Dallas in the State of Texas.

The FHWA invites public comments about our intention to request the Office of Management and Budget's (OMB) approval for the renewal of a currently approved information collection that is summarized below under SUPPLEMENTARY INFORMATION. We are required to publish this notice in the Federal Register by the Paperwork Reduction Act of 1995.

This document contains a change to the title of the Notice of Availability of the Environmental Assessment served and published in the Federal Register on Monday, October 26, 2009 (74 FR 55085) by the Board's Section of Environmental Analysis. That notice, published in this docket, was titled ``Eastern Iowa Industrial Center Rail Project Construction and Operation ExemptionCity of Davenport, Iowa.'' The title should read, ``City of Davenport, IAConstruction and Operation Exemptionin Scott County, IA.''

These special conditions are issued for Airbus Model A340 airplanes. These airplanes, manufactured by Airbus, will have novel or unusual design features associated with seats with inflatable lap

We are adopting a new airworthiness directive (AD) for certain Hawker Beechcraft Corporation Models 1900, 1900C, and 1900D airplanes. This AD requires a one-time visual inspection and repetitive ultrasonic inspections of the left and right main landing gear (MLG) actuators for leaking and/or cracks with replacement of the actuator if leaking and/ or cracks are found. This AD results from reports of leaking and cracked actuators. We are issuing this AD to detect and correct leaking and cracks in the MLG actuators, which could result in loss of hydraulic fluid. This condition could lead to an inability to extend or lock down the landing gear, which could result in a gear up landing or a gear collapse on landing.

The FAA proposes to rule and invites public comment on the application to impose a PFC at Metropolitan Oakland International Airport, under the provisions of the Aviation Safety and Capacity Expansion Act of 1990 (Title IX of the Omnibus Budget Reconciliation Act of 1990) (Pub. L. 101-508) and Part 158 of the Federal Aviation Regulations (14 CFR Part 158).