Federal Aviation Administration April 21, 2008 – Federal Register Recent Federal Regulation Documents

This action proposes special conditions for the Embraer S.A. Model ERJ 190-100 ECJ airplane. This airplane will have novel or unusual design features associated with access during flight of the main deck Class C cargo compartment. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These proposed special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

This action proposes special conditions for the Embraer S.A. Model ERJ 190-100 ECJ airplane which has a novel and unusual design feature, in that it features multiple electrical/electronic equipment bays that are located throughout the airplane. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These proposed special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards. Additional special conditions will be issued for other novel or unusual design features of the Embraer S.A. Model ERJ 190-100 ECJ airplane.

We are adopting a new airworthiness directive (AD) for certain Boeing Model 737-600, -700, -700C, -800, and -900 series airplanes. This AD requires replacing the drain tube assemblies and support clamps on the aft fairing of the engine struts. This AD results from reports of failure of the drain tube assembly and clamp on the aft fairings of an engine strut. We are issuing this AD to prevent failure of the drain tube assemblies and clamps on the aft fairings of the of the engine struts. Such a failure could allow leaked flammable fluids in the drain systems to discharge on to the heat shields of the aft fairings of the engine struts, which could result in an undetected and uncontrollable fire.

We are adopting a new airworthiness directive (AD) for all Boeing Model 737-200C series airplanes. This AD requires revising the FAA-approved maintenance inspection program to include inspections that will give no less than the required damage tolerance rating for each structural significant item (SSI), doing repetitive inspections to detect cracks of all SSIs, and repairing cracked structure. This AD results from a report of incidents involving fatigue cracking in transport category airplanes that are approaching or have exceeded their design service objective. We are issuing this AD to maintain the continued structural integrity of the entire fleet of Model 737-200C series airplanes.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is superseding an existing airworthiness directive (AD), which applies to all EMBRAER Model ERJ 170-100 LR, -100 SE, -100 STD, and -100 SU airplanes; and Model ERJ 190-100 IGW, -100 LR, and - 100 STD airplanes. That AD currently requires revising the Limitations section of the airplane flight manual (AFM) to prohibit the flightcrew from moving the throttle into the forward thrust range immediately after applying the thrust reverser. This new AD adds additional airplanes to the applicability and requires the AFM revision for those additional airplanes. For certain airplanes, this AD also requires installing new, improved full-authority digital engine-control (FADEC) software. This AD results from a report that, during landing, the thrust reverser may not re-stow completely if the throttle lever is moved into the forward thrust range immediately after the thrust reverser is applied. We are issuing this AD to prevent the flightcrew from performing a takeoff with a partially deployed thrust reverser, which could result in reduced controllability of the airplane.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: