Department of Transportation October 5, 2023 – Federal Register Recent Federal Regulation Documents
Results 1 - 15 of 15
Airworthiness Directives; International Aero Engines, LLC Engines
The FAA proposes to adopt a new airworthiness directive (AD) for certain International Aero Engines, LLC (IAE) Model PW1124G1-JM, PW1127G-JM, PW1127GA-JM, PW1129G-JM, PW1130G-JM, PW1133G-JM, and PW1133GA-JM engines. This proposed AD was prompted by a report that certain high-pressure compressor (HPC) 2nd stage rotors and HPC 4th stage rotors have potentially degraded knife-edge seals and abrasive coating of the rear wing 4th stage rotor due to having been cleaned in alkaline solution without masking the knife-edge seal coating. Operating in this condition could result in material degradation and fracture of the HPC 2nd stage rotor and HPC 4th stage rotor. This proposed AD would require replacement of certain HPC 2nd stage rotors and HPC 4th stage rotors. The FAA is proposing this AD to address the unsafe condition on these products.
Amendment of Class D and Class E Airspace; Philadelphia, PA
This action amends Class D and Class E surface airspace for Northeast Philadelphia Airport, Philadelphia, PA, by updating the airport's description headers and making editorial changes. This action does not change the airspace boundaries or operating requirements.
Airworthiness Directives; The Boeing Company Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 767 airplanes. This proposed AD was prompted by a report of cracks on the forward entry door and forward service door cutout aft lower corner fuselage skin and bear strap. This proposed AD would require repetitive inspections for cracking at the affected area, and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Canada Limited Partnership (Type Certificate Previously Held by C Series Aircraft Limited Partnership (CSALP); Bombardier, Inc.) Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500- 1A11 airplanes. This AD was prompted by a report the engine fire extinguishing control and indication system did not illuminate correctly. This AD requires installing a software update to the integrated cockpit control panel (ICCP) remote data concentrator (RDC), as specified in a Transport Canada AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 and A350-1041 airplanes. This AD is prompted by reports that excessively deep spot faces on the front engine mounting bolt holes on the wing pylon were detected on the production line. This AD requires a one-time inspection for clash (interference) of the three front engine mounting bolt holes on both the left and right wing pylons, and, depending on findings, accomplishment of applicable corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; ATR-GIE Avions de Transport Régional Airplanes
The FAA is superseding Airworthiness Directive (AD) 2021-10- 20, which applied to certain ATR-GIE Avions de Transport R[eacute]gional Model ATR42-500 and ATR72-212A airplanes. AD 2021-10-20 required revising the existing aircraft flight manual (AFM) and applicable corresponding operational procedures to update a systems limitation, limiting dispatch with certain equipment inoperative, performing an operational test of a certain contactor and an electrical test of a certain battery toggle switch, and performing corrective actions if necessary. This AD was prompted by new procedures for modifying the wiring and replacing the battery toggle switch that have been developed that would terminate the AD requirements. This AD continues to require certain actions in AD 2021-10-20, and requires modifying the battery toggle switch wiring and replacing the battery toggle switch, and revises the applicability to include additional airplanes, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
The FAA is adopting a new airworthiness directive (AD) for all MHI RJ Aviation ULC Model CL-600-2C10 (Regional Jet Series 700, 701 & 702), CL-600-2C11 (Regional Jet Series 550), CL-600-2D15 (Regional Jet Series 705), CL-600-2D24 (Regional Jet Series 900), and CL-600-2E25 (Regional Jet Series 1000) airplanes. This AD was prompted by a manufacturing quality escape concerning the installation of the Halon metering device on certain cargo fire extinguisher containers. This AD requires the inspection of cargo fire extinguisher container serial numbers and the replacement of the affected containers. This AD would also limit the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A319-151N, -153N and -171N airplanes; Model A320-251N, -252N, -253N, -271N, -272N, and -273N airplanes; and Model A321-251N, -252N, -253N, -271N, -272N, -251NX, -252NX, -253NX, -271NX, and -272NX airplanes. This AD was prompted by a safety review of the airplane fuel system, which identified that the electrical harness routing of the engine low pressure shut off valve (LPSOV) is not adequately protected against uncontained engine rotor failure (UERF). This AD requires modification of the LPSOV electrical harness routing on either the left-hand engine or the right-hand engine, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is superseding Airworthiness Directive (AD) 2022-18- 12, which applied to all Airbus SAS Model A330-841 and -941 airplanes. AD 2022-18-12 required installing serviceable engine electronic control (EEC) software or EEC units having the serviceable software, limiting certain parts installation configurations, and prior or concurrent modification of EEC software. This AD was prompted by a determination that engine crystal icing protection could be (temporarily) lost if an erroneous total pressure value is provided by the airplane system, which is addressed through EEC software. This AD continues to require certain actions in AD 2022-18-12 and requires adding new limitations for intermixing of certain EEC software standards and a new operational limitation for engines with certain EEC software installed, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also prohibits the installation of certain engines under certain conditions. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; ATR-GIE Avions de Transport Régional Airplanes
The FAA proposes to supersede Airworthiness Directive (AD) 2021-17-02, which applies to all ATRGIE Avions de Transport R[eacute]gional Model ATR42-200, -300, and -320 airplanes. AD 2021-17- 02 requires a one-time inspection for discrepancies of the wire bundles between the left- and right-hand angle of attack (AOA) probes and the crew alerting computer, and, depending on findings, applicable corrective actions. AD 2021-17-02 also required for certain airplanes, modifying the captain stick shaker wiring, and for all airplanes, revising the existing aircraft flight manual (AFM) and applicable corresponding operational procedures to incorporate procedures for the stick pusher/shaker. Since the FAA issued AD 2021-17-02, a modification was developed to the affected wiring. This proposed AD would require installing a new AOA power supply unit and revising the existing AFM, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus SAS Model A320-214, A320-216, A320-251N, A320-271N, and A321-253NX airplanes. This proposed AD was prompted by a quality review of the forward cargo door frame-to-fuselage skin panel assembly identified several fastener holes that deviated from the manufacturing requirements. This proposed AD would require repetitive special detailed inspections of the affected area for discrepancies and, depending on findings, accomplishment of applicable corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Saab AB, Support and Services (Formerly Known as Saab AB, Saab Aeronautics) Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for all Saab AB, Support and Services Model SAAB 2000 airplanes. This proposed AD was prompted by a review of the anti-skid system revealed the possibility of inadvertently connecting the inboard harness to the outboard channel (and vice versa) of the wheel speed transducers in the main landing gear (MLG) wheel axles. This proposed AD would require installing color markings on the harnesses and the wheel axles, to ensure proper installation and connection of the anti-skid harnesses, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Qualification of Drivers; Exemption Applications; Epilepsy and Seizure Disorders
FMCSA announces its decision to renew exemptions for seven individuals from the requirement in the Federal Motor Carrier Safety Regulations (FMCSRs) that interstate commercial motor vehicle (CMV) drivers have ``no established medical history or clinical diagnosis of epilepsy or any other condition which is likely to cause loss of consciousness or any loss of ability to control a CMV.'' The exemptions enable these individuals who have had one or more seizures and are taking anti-seizure medication to continue to operate CMVs in interstate commerce.
Qualification of Drivers; Exemption Applications; Hearing
FMCSA announces its decision to exempt 11 individuals from the hearing requirement in the Federal Motor Carrier Safety Regulations (FMCSRs) to operate a commercial motor vehicle (CMV) in interstate commerce. The exemptions enable these hard of hearing and deaf individuals to operate CMVs in interstate commerce.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A330-202, A330-203, A330-223, A330-243, and A330-841 airplanes. This AD was prompted by a determination that the cold working process was partially completed on a certain circumferential joint. This AD requires modification of the circumferential joint, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.