Department of Transportation March 24, 2022 – Federal Register Recent Federal Regulation Documents
Results 1 - 21 of 21
Airworthiness Directives; Bell Textron Canada Limited (Type Certificate Previously Held by Bell Helicopter Textron Canada Limited) Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for Bell Textron Canada Limited (type certificate previously held by Bell Helicopter Textron Canada Limited) Model 206L, 206L-1, 206L-3, and 206L-4 helicopters with a certain part-numbered main rotor (M/R) blade installed under Supplemental Type Certificate (STC) SR02684LA. This proposed AD was prompted by delamination of M/R blades. This proposed AD would require a repetitive inspection for delamination, and depending on the results, removing the M/R blade from service and reporting certain information. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; The Boeing Company Airplanes
The FAA proposes to supersede Airworthiness Directive (AD) 2015-12-03, which applies to certain The Boeing Company Model 777-200, -200LR, -300, and -300ER series airplanes. AD 2015-12-03 requires repetitive freeplay inspections and lubrication of the right and left elevators, rudder, and rudder tab, and related investigative and corrective actions if necessary. Since the FAA issued AD 2015-12-03, engineering testing revealed that the force being applied to the elevator to detect excessive freeplay was insufficient. This proposed AD would continue to require certain actions in AD 2015-12-03 for certain airplanes, and would require revising the existing maintenance or inspection program, as applicable, for certain other airplanes, to incorporate a revised or new elevator freeplay maintenance procedure, as applicable. This proposed AD would also add airplanes to the applicability. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; International Aero Engines, LLC Turbofan Engines
The FAA proposes to adopt a new airworthiness directive (AD) for certain International Aero Engines, LLC (IAE LLC) PW1122G-JM, PW1124G1-JM, PW1124G-JM, PW1127G1-JM, PW1127GA-JM, PW1127G-JM, PW1129G- JM, PW1130G-JM, PW1133GA-JM, and PW1133G-JM model turbofan engines. This proposed AD was prompted by an analysis of an event involving an International Aero Engines AG (IAE AG) V2533-A5 model turbofan engine, which experienced an uncontained failure of a high-pressure turbine (HPT) 1st-stage disk that resulted in high-energy debris penetrating the engine cowling. This proposed AD would require performance of an ultrasonic inspection (USI) of the HPT 1st-stage disk and HPT 2nd-stage disk and, depending on the results of the inspections, replacement of the HPT 1st-stage disk or HPT 2nd-stage disk. The FAA is proposing this AD to address the unsafe condition on these products.
Special Conditions: Dassault Aviation Model Falcon 6X Airplane; Electronic-System Security Protection From Unauthorized Internal Access
These special conditions are issued for the Dassault Aviation (Dassault) Model Falcon 6X airplane. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. This design feature is a digital systems architecture for the installation of a system with wireless and hardwired network and hosted application functionality that allows access, from sources internal to the airplane, to the airplane's internal electronic components. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Proposed Establishment of United States Area Navigation (RNAV) Route T-378; Fort Yukon, AK
This action proposes to establish United States Area Navigation (RNAV) route T-378 in the vicinity of Fort Yukon, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Proposed Establishment of United States Area Navigation (RNAV) Route T-377; Sitka, AK
This action proposes to establish United States Area Navigation (RNAV) route T-377 in the vicinity of Sitka, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Proposed Establishment of United States Area Navigation (RNAV) Route T-371; Kodiak, AK
This action proposes to establish United States Area Navigation (RNAV) route T-371 in the vicinity of Kodiak, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Proposed Amendment of United States Area Navigation (RNAV) Route T-230; St. Paul Island, AK
This action proposes to amend United States Area Navigation (RNAV) route T-230 in the vicinity of St. Paul Island, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Proposed Establishment of United States Area Navigation (RNAV) Route T-388; Port Heiden, AK
This action proposes to establish United States Area Navigation (RNAV) route T-388 in the vicinity of Port Heiden, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Proposed Establishment of United States Area Navigation (RNAV) Route T-386; Fairbanks, AK
This action proposes to establish United States Area Navigation (RNAV) route T-386 in the vicinity of Fairbanks, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Proposed Establishment of United States Area Navigation (RNAV) Route T-383; Sitka, AK
This action proposes to establish United States Area Navigation (RNAV) route T-383 in the vicinity of Sitka, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Proposed Establishment of United States Area Navigation (RNAV) Route T-380; Emmonak, AK
This action proposes to establish United States Area Navigation (RNAV) route T-380 in the vicinity of Emmonak, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Airworthiness Directives; Airbus Helicopters
The FAA is removing Airworthiness Directive (AD) 2021-03-16, which applied to all Airbus Helicopters Model AS350B, AS350B1, AS350B2, AS350B3, AS350BA, AS350D, AS355E, AS355F, AS355F1, AS355F2, AS355N, and AS355NP helicopters. AD 2021-03-16 required inspecting each sliding door and replacing the upper rail or front roller or removing the front roller from service if necessary. Since the FAA issued AD 2021-03-16, inspection results and further investigation have confirmed that the in-flight loss of a sliding door, which prompted AD 2021-03-16, was an isolated case resulting from incorrect operation and maintenance error. Therefore, the FAA has determined that no unsafe condition is likely to exist or develop on the sliding doors on other helicopters in the fleet. Accordingly, AD 2021-03-16 is removed.
Airworthiness Directives; De Havilland Aircraft of Canada Limited (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain De Havilland Aircraft of Canada Limited Model DHC-8-400 series airplanes. This proposed AD was prompted by reports of broken P- clamps on the pressure relief line and the motive flow line in the fuel tanks, and a subsequent determination that certain service information lacked instructions for maintaining appropriate clearance between certain fuel tubes and their support brackets, and may also have led to incorrect installation of certain TeflonTM sleeves. This proposed AD was also prompted by a determination that new or more restrictive airworthiness limitations are necessary. This proposed AD would require inspecting the motive flow line, vent line, and related parts, and adding support or additional clearance if necessary. This proposed AD would also require inspection, and replacement or relocation if necessary, of affected TeflonTM sleeves on the vent line, and installation of TeflonTM sleeves on the vent line at additional wing stations. This proposed AD would also require revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is proposing this AD to address the unsafe condition on these products.
Denial of Motor Vehicle Defect Petition, DP18-002
This notice sets forth the reasons for the denial of a petition submitted on August 7, 2018, by Mr. Gary Weinreich (the petitioner) to NHTSA's Office of Defects Investigation (ODI). The petition requests that the Agency investigate alleged ``premature and excessive frame corrosion'' in model year (MY) 2002 through 2006 Toyota 4Runner vehicles. The petitioner bases his request upon his own experience with a MY 2005 Toyota 4Runner, a class action lawsuit settlement involving other Toyota products, and other complaints of underbody corrosion in Toyota 4Runner vehicles that he found in NHTSA's online complaint database. After reviewing the information provided by the petitioner regarding his vehicle, facts related to the class action lawsuit cited by the petitioner, and field data regarding underbody corrosion in Toyota 4Runner vehicles, NHTSA has concluded that there is insufficient evidence to pursue further action. Accordingly, the Agency has denied the petition.
Special Conditions: Dassault Aviation Model Falcon 6X Airplane; Flight Envelope Protection, High-Speed Limiting
These special conditions are issued for the Dassault Aviation (Dassault) Model Falcon 6X airplane. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. This design feature is an overspeed protection system in the normal mode, designed to prevent the pilot from inadvertently or intentionally exceeding certain airplane speeds. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. This special conditions document contains the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Proposed Amendment of United States Area Navigation (RNAV) Route T-282; Ruby, AK
This action proposes to amend United States Area Navigation (RNAV) route T-282 in the vicinity of Ruby, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Proposed Amendment of United States Area Navigation (RNAV) Route T-242; Utqiagvik, AK
This action proposes to amend United States Area Navigation (RNAV) route T-242 in the vicinity of Utqiagvik, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Proposed Establishment of United States Area Navigation Route T-379; Discovery, AK
This action proposes to establish United States Area Navigation (RNAV) route T-379 in the vicinity of Discovery, AK in support of a large and comprehensive T-route modernization project for the state of Alaska.
Agency Information Collection Activities; Submission to the Office of Management and Budget for Review and Approval; Request for Comment; Fatal Crash Seat Belt Use Reporting and Awareness
In compliance with the Paperwork Reduction Act of 1995 (PRA), this notice announces that the Information Collection Request (ICR) abstracted below will be submitted to the Office of Management and Budget (OMB) for review and approval. The ICR describes the nature of the information collection and its expected burden. This document describes a new collection of information for which NHTSA intends to seek OMB approval on Fatal Crash Seat Belt Use Reporting and Awareness, a one-time voluntary experiment to understand whether the inclusion of seat belt status in a fatal crash news report could affect seat belt use. A Federal Register notice with a 60-day comment period soliciting comments on the following information collection was published on September 28, 2021. No comments were received.
Special Conditions: Dassault Aviation Model Falcon 6X Airplane; Interaction of Systems and Structures
These special conditions are issued for the Dassault Aviation (Dassault) Model Falcon 6X airplane. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. This design feature is installed systems that, directly or as a result of failure or malfunction, affect airplane structural performance. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.