Department of Transportation March 26, 2021 – Federal Register Recent Federal Regulation Documents
Results 1 - 13 of 13
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by reports of migration of the bushings of the horizontal tail plane (HTP) lateral load fittings (LLFs) on the left- and right-hand sides during flight test. This AD requires repetitive inspections for migration of the bushings of the HTP LLFs on the left- and right-hand sides, and terminating repair or modification of any affected bushing, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model AS332L, AS332L1, AS332C, and AS332C1 helicopters. This AD was prompted by the failure of a second stage planet gear installed in the main gearbox (MGB). This AD requires identifying the part number of each second stage planet gear assembly installed in the MGB, replacing an MGB having certain second stage planet gear assembly part numbers with a serviceable MGB, modifying the helicopter by installing a full flow magnetic plug (FFMP), repetitively inspecting the FFMP and the MGB bottom housing and conical housing for metal particles, analyzing any metal particles that are found, and applying corrective actions if necessary, as specified in European Union Aviation Safety Agency (EASA) ADs, which are incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus SAS (Airbus) Model A318 series airplanes; Model A319-111, -112, -113, -114, -115, -131, -132, -133, -151N, and -153N airplanes; Model A320 series airplanes; and Model A321 series airplanes. This proposed AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This proposed AD would require revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters Deutschland GmbH Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for Airbus Helicopters Deutschland GmbH Model MBB-BK 117 A-1, MBB-BK 117 A-3, MBB-BK 117 A-4, MBB-BK 117 B-1, MBB-BK 117 B-2, and MBB-BK 117 C-1 helicopters. This proposed AD was prompted by an analysis of the main rotor (M/R) blade loop area. This proposed AD would require repetitive inspections of certain M/R blade thimble areas and corrective actions if necessary, as specified in a European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters Deutschland GmbH (Type Certificate Previously Held by Eurocopter Deutschland GmbH and Eurocopter Canada Ltd.) Helicopters
The FAA is superseding Airworthiness Directive (AD) 97-26-02 for Eurocopter Deutschland GmbH Model BO-105A, BO-105C, BO-105S, BO- 105LS A-1, and BO-105LS A-3 helicopters; and Eurocopter Canada Ltd. Model BO-105LS A-3 helicopters. AD 97-26-02 required a repetitive visual inspection for cracks in the ribbed area of the main rotor (M/R) mast flange (flange), and depending on the outcome, replacing the M/R mast. This new AD retains the requirements of AD 97-26-02 and removes the reinforced M/R mast from the applicability. This AD was prompted by the determination that a certain reinforced M/R mast is not affected by the unsafe condition. The actions of this AD are intended to address an unsafe condition on these products.
Notice of Final Federal Agency Actions on Proposed Highway in Idaho
This notice announces actions taken by the FHWA that are final. The actions relate to a proposed highway project, U.S. 20 at Targhee Pass, specifically the section between its junction with Idaho State Highway 87 and the Montana State line, milepost 402.1 to 406.3 in Fremont County, State of Idaho. The actions grant licenses, permits, and approvals for the project.
IFR Altitudes; Miscellaneous Amendments
This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.
Special Conditions: The Boeing Company Model 787 Series Airplane; Seats With Pretensioner Restraint Systems
These special conditions are issued for The Boeing Company (Boeing) Model 787 series airplane. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. This design feature is pretensioner restraint systems installed on passenger seats. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Airworthiness Directives; Pratt & Whitney Turbofan Engines
The FAA proposes to supersede Airworthiness Directive (AD) 2019-21-11 and AD 2020-07-02. AD 2019-21-11 applies to all Pratt & Whitney (PW) PW1519G, PW1521G, PW1521G-3, PW1521GA, PW1524G, PW1524G-3, PW1525G, PW1525G-3, PW1919G, PW1921G, PW1922G, PW1923G, and PW1923G-A model turbofan engines. AD 2020-07-02 applies to all PW PW1519G, PW1521G, PW1521G-3, PW1521GA, PW1524G, PW1524G-3, PW1525G, and PW1525G- 3 model turbofan engines. AD 2019-21-11 requires initial and repetitive borescope inspections (BSIs) of the low-pressure compressor (LPC) rotor 1 (R1) and, depending on the results of the inspections, replacement of the LPC. AD 2020-07-02 requires the removal from service of certain electronic engine control (EEC) full authority digital electronic control (FADEC) software and the installation of a software version eligible for installation. Since the FAA issued AD 2019-21-11 and AD 2020-07-02, the manufacturer developed a new version of EEC FADEC software, which terminates the need for repetitive BSIs of the LPC R1. This proposed AD would continue to require repetitive BSIs of certain LPC R1s until replacement of EEC FADEC software with the updated software. This proposed AD would require a BSI after installation of the updated EEC FADEC software if certain Onboard Maintenance Message fault codes are displayed and meet specified criteria. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; The Boeing Company Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 777 airplanes. This proposed AD was prompted by significant changes, including new or more restrictive requirements, made to the airworthiness limitations (AWLs) and Critical Design Configuration Control Limitations (CDCCLs) related to fuel tank ignition prevention, the engine fuel suction feed system, and the nitrogen generation system. This proposed AD would require revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 and -1041 airplanes. This proposed AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This proposed AD would require revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations, as specified in a European Union Aviation Safety Agency (EASA), which is proposed for incorporation by reference. This proposed AD would also require, for certain airplanes, an update of the hydraulic monitoring system to include additional redundancy. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Pilatus Aircraft Ltd. Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Pilatus Aircraft Ltd. (Pilatus) Model PC-24 airplanes. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI identifies the unsafe condition as the engine attachment hardware not conforming to the approved design, which could affect the structural integrity of the airplane. This proposed AD would require inspecting the engine attachment hardware for missing washers and loose nuts and taking corrective actions as necessary. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Various Restricted Category Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for type certificated Model UH-1H restricted category helicopters. This proposed AD was prompted by multiple reports of failure of the main driveshaft. This proposed AD would require establishing a life limit for certain main driveshafts, and a one-time and repetitive inspections of the main driveshafts. The FAA is proposing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
