Department of Transportation January 18, 2011 – Federal Register Recent Federal Regulation Documents
Results 1 - 17 of 17
Airworthiness Directives; The Boeing Company Model 757 Airplanes
The FAA proposes to supersede an existing airworthiness directive (AD) that applies to certain Model 757 airplanes. The existing AD currently requires inspecting certain power feeder wire bundles for damage, inspecting the support clamps for these wire bundles to determine whether the clamps are properly installed, and performing corrective actions if necessary. This proposed AD would require additional inspections for certain airplanes. This proposed AD results from a report that a power feeder wire bundle chafed against the number six auxiliary slat track, causing electrical wires in the bundle to arc, which damaged both the auxiliary slat track and power feeder wires. We are proposing this AD to prevent arcing that could be a possible ignition source for leaked flammable fluids, which could result in a fire. Arcing could also result in a loss of power from the generator connected to the power feeder wire bundle, and consequent loss of systems, which could reduce controllability of the airplane.
Airworthiness Directives; The Boeing Company Model 777-200, -200LR, -300, and -300ER Series Airplanes
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD would require installing foreign object debris (FOD) rubber shields over the primary and secondary external power connectors for certain airplanes, and wrapping fire-resistant silicone tape around the hydraulic tube for certain other airplanes. This proposed AD was prompted by a report of a fire in the main equipment center due to failure of an external power connector, which caused high-temperature arcing and subsequent splatter of molten copper on an adjacent hydraulic tube, creating a hole in the tube and spraying hydraulic fluid into the power connector, resulting in a fire. In addition there were several reports of overheating or arcing of external power connectors, and one report of a fire due to arcing caused by FOD. We are proposing this AD to prevent FOD from entering the primary and secondary external power connectors, which could result in overheating or arcing and consequent fire in the main equipment center.
Notice of Final Federal Agency Actions on Proposed Highway in California
The FHWA, on behalf of Caltrans, is issuing this notice to announce actions taken by Caltrans, that are final within the meaning of 23 U.S.C. 139(l)(1). The actions relate to a proposed highway project along Interstate 805, San Diego, CA, PM: 23.3-27.7 in the County of San Diego, State of California. Those actions grant licenses, permits, and approvals for the project.
Notice of Final Federal Agency Actions on Proposed Project in Washington
This notice announces actions taken by the FHWA that are final within the meaning of 23 U.S.C. 139(l)(1). The actions relate to a proposed project, the SR 520 Pontoon Construction Project in the State of Washington. Those actions grant approval for the project.
Safe, Efficient Use and Preservation of the Navigable Airspace; Correction
The FAA is correcting the regulation addressing the effective date of FAA determinations issued under 14 CFR part 77. The FAA amended this regulation by final rule published on July 21, 2010. The purpose of the final rule was to update the regulations governing objects that may affect the navigable airspace, to incorporate case law and legislative action, and to simplify the rule language. In one section of the regulations, we inadvertently state that the effective date of all determinations is 40 days from the date of issuance. However, only FAA determinations subject to the discretionary review process are effective 40 days from the date of issuance. All other FAA determinations are effective upon issuance. This document corrects that error.
Airworthiness Directives; The Boeing Company Model 737-600, -700, -700C, -800, -900, and -900ER Series Airplanes
We propose to adopt a new airworthiness directive (AD) for certain Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. This proposed AD would require inspecting to determine the clearance and any wire bundle damage between wire bundle W443 and the left forward rudder quadrant, followed by adjusting the minimum clearance between the wire bundle and the left forward rudder quadrant, and repairing any wire bundle damage. This proposed AD results from reports of contact between wire bundle W443 and the left forward rudder quadrant. We are proposing this AD to detect and correct contact between the wire bundle and the left forward rudder quadrant. Damage to the wire bundle could result in uncommanded stabilizer trim and autopilot disconnects due to shorted wires from contact between the wire bundle and the left forward rudder quadrant, potentially affecting the capability of the flight crew during high work load and consequently reducing control of the airplane. Restricted free movement of the rudder quadrant at full right rudder travel would reduce controllability of the airplane.
Notice of Limitation on Claims Against Proposed Public Transportation Projects
This notice announces final environmental actions taken by the Federal Transit Administration (FTA) for the following projects: (1) New Orleans Union Passenger Terminal (NOUPT)/Loyola Avenue Streetcar Project, New Orleans Regional Transit Authority, New Orleans, LA; (2) South Corridor: Portland-Milwaukie Light Rail Project, Tri-County Metropolitan Transportation District of Oregon (TriMet), Clackamas, and Portland, Oregon; and (3) Second Avenue Subway Project, Metropolitan Transportation Authority, New York, NY. The purpose of this notice is to announce publicly the environmental decisions by FTA on the subject projects and to activate the limitation on any claims that may challenge these final environmental actions.
Office of Hazardous Materials Safety; Notice of Applications for Modification of Special Permit
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the applications described herein. This notice is abbreviated to expedite docketing and public notice. Because the sections affected, modes of transportation, and the nature of application have been shown in earlier Federal Register publications, they are not repeated here. Requests for modification of special permits (e.g. to provide for additional hazardous materials, packaging design changes, additional mode of transportation, etc.) are described in footnotes to the application number. Application numbers with the suffix ``M'' denote a modification request. These applications have been separated from the new application for special permits to facilitate processing.
Office of Hazardous Materials Safety; Notice of Application for Special Permits
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular special permit is requested is indicated by a number in the ``Nature of Application'' portion of the table below as follows: 1Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft.
Revocation and Establishment of Compulsory Reporting Points; Alaska
This action removes and establishes high altitude Alaskan compulsory reporting points in the vicinity of the United States (U.S.) and Canadian border. Specifically, the FAA is removing BORAN and establishing the TOVAD reporting point.
Amendment of Jet Route J-93; CA
This action amends Jet Route J-93 in California between the Julian VHF Omnidrectional Radio Range Tactical Air Navigation Aid (VORTAC), and the ASUTA intersection on the United States/Mexican border. The FAA is realigning the jet route due to the relocation of the Penasco VOR, located in Mexico. This action ensures the efficient use of our National Airspace System.
Amendment of VOR Federal Airways V-2 and V-21; Hawaii
This action amends two VHF Omnidirectional Range (VOR) Federal airway legal descriptions in the State of Hawaii. The FAA is taking this action to remove exclusions to restricted airspace areas that have been removed from the National Airspace System (NAS).
Notice of Final Federal Agency Actions on Proposed Highway in Minnesota
This notice announces actions taken by the FHWA and other Federal agencies that are final within the meaning of 23 U.S.C. 139(l)(1). The actions relate to a proposed highway project on a 3.5 mile combined segment of Trunk Highway (TH) 23 and U.S. Highway 71. The proposed project is from the TH 294 and TH 23/71 divergence on the south to the divergence of the TH 23 and U.S. Highway 71 on the north in Dovre Township, northeast of Willmar, Minnesota in Kandlyohi County. The proposed improvements include grade-separated interchanges at a relocated County Road 90 and at County State Aid Highway 25, median and driveway closures, and new or reconstructed segments of local frontage roads. Those actions grant approvals for the project.
Notice of Final Federal Agency Actions on Proposed Highway in Minnesota
This notice announces actions taken by the FHWA and other Federal agencies that are final within the meaning of 23 U.S.C. 139(l)(1). The actions relate to a proposed highway project on TH 371 from the intersection of CSAH 18 in Nisswa (Crow Wing County) to the County Road 2/42 intersection in Pine River (Cass County), Minnesota. Those actions grant approvals for the project.
Airworthiness Directives; Eurocopter France (Eurocopter) Model SA-365N, SA-365N1, AS-365N2, AS 365 N3, and SA-366G1 Helicopters
We propose to adopt a new airworthiness directive (AD) for the specified Eurocopter model helicopters. This proposed AD would require an initial and recurring inspections of the inner angles and flanges of the 9-degree frame on the right-hand (RH) and left-hand (LH) sides for a crack. If a crack is found, this proposed AD would require, before further flight, repairing the frame. This proposed AD is prompted by the discovery of a crack in the 9-degree frame of a Eurocopter Model AS-365N2 helicopter. These cracks could also develop on the other specified model helicopters because they contain the same 9-degree frame. The actions specified by this proposed AD are intended to detect a crack in the 9-degree frame to prevent loss of structural integrity and subsequent loss of control of the helicopter.
Establishment of Class E Airspace; Lucin, UT
This action makes a minor correction to a final rule published in the Federal Register July 8, 2010, that establishes Class E en route domestic airspace for the Lucin VORTAC, Lucin, UT.
Notice of Passenger Facility Charge (PFC) Approvals and Disapprovals
The FAA publishes a monthly notice, as appropriate, of PFC approvals and disapprovals under the provisions of the Aviation Safety and Capacity Expansion Act of 1990 (Title IX of the Omnibus Budget Reconciliation Act of 1990) (Pub. L. 101-508) and Part 158 of the Federal Aviation Regulations (14 CFR Part 158). This notice is published pursuant to paragraph d of Sec. 158.29.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
