Department of Transportation November 3, 2009 – Federal Register Recent Federal Regulation Documents

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Requirement (ICR) abstracted below has been forwarded to the Office of Management and Budget (OMB) for review and comment. The ICR describes the nature of the information collection and its expected burden. The Federal Register notice with a 60-day comment period soliciting comments on the following collection of information was published on August 24, 2009 (74 FR 42732).

Section 1604(b)(7) of the Safe, Accountable, Flexible, Efficient Transportation Equity Act: A Legacy for Users (SAFETEA-LU) (Pub. L. 109-59; Aug. 10, 2005), authorizes the Secretary of Transportation (Secretary) to develop and publish performance goals for each express lane project accepted under the Express Lanes Demonstration Program. This notice lists the Performance Goals, Monitoring and Reporting Program requirements for the IH-30 (the Tom Landry Freeway) Express Lanes project and IH-35E Express Lanes project in Dallas in the State of Texas.

The FHWA invites public comments about our intention to request the Office of Management and Budget's (OMB) approval for the renewal of a currently approved information collection that is summarized below under SUPPLEMENTARY INFORMATION. We are required to publish this notice in the Federal Register by the Paperwork Reduction Act of 1995.

This document contains a change to the title of the Notice of Availability of the Environmental Assessment served and published in the Federal Register on Monday, October 26, 2009 (74 FR 55085) by the Board's Section of Environmental Analysis. That notice, published in this docket, was titled ``Eastern Iowa Industrial Center Rail Project Construction and Operation ExemptionCity of Davenport, Iowa.'' The title should read, ``City of Davenport, IAConstruction and Operation Exemptionin Scott County, IA.''

These special conditions are issued for Airbus Model A340 airplanes. These airplanes, manufactured by Airbus, will have novel or unusual design features associated with seats with inflatable lap

We are adopting a new airworthiness directive (AD) for certain Hawker Beechcraft Corporation Models 1900, 1900C, and 1900D airplanes. This AD requires a one-time visual inspection and repetitive ultrasonic inspections of the left and right main landing gear (MLG) actuators for leaking and/or cracks with replacement of the actuator if leaking and/ or cracks are found. This AD results from reports of leaking and cracked actuators. We are issuing this AD to detect and correct leaking and cracks in the MLG actuators, which could result in loss of hydraulic fluid. This condition could lead to an inability to extend or lock down the landing gear, which could result in a gear up landing or a gear collapse on landing.