Department of Transportation April 24, 2006 – Federal Register Recent Federal Regulation Documents

Airworthiness Directives; Pilatus Aircraft Ltd. Models PC-6, PC-6-H1, PC-6-H2, PC-6/350, PC-6/350-H1, PC-6/350-H2, PC-6/A, PC-6/A-H1, PC-6/A-H2, PC-6/B-H2, PC-6/B1-H2, PC-6/B2-H2, PC-6/B2-H4, PC-6/C-H2, and PC-6/C1-H2 Airplanes
Document Number: E6-6055
Type: Proposed Rule
Date: 2006-04-24
Agency: Federal Aviation Administration, Department of Transportation
We propose to revise Airworthiness Directive (AD) 68-17-03, which applies to all Pilatus Aircraft Ltd. PC-6 series airplanes. AD 68-17-03 currently requires you to repetitively inspect the rudder end rib for cracks and replace the rudder end rib with a modified rudder end rib when you find cracks. Installing the modified rudder end rib terminates the repetitive inspection requirements of AD 68-17-03. Under a licensing agreement with Pilatus, Fairchild Republic Company (also identified as Fairchild Industries, Fairchild Heli Porter, or Fairchild-Hiller Corporation) produced Model PC-6 series airplanes (manufacturer serial numbers 2001 through 2092) in the United States. AD 68-17-03 was intended to apply to all affected serial numbers of Model PC-6 series airplanes listed on Type Certificate Data Sheet (TCDS) No. 7A15, including the Fairchild-produced airplanes. Consequently, this proposed AD would clarify that all models of the PC- 6 airplane on TCDS No. 7A15 (including those models produced under the licensing agreement by Fairchild Republic Company) are included in the applicability. We are proposing this AD to detect and correct cracks in the rudder end rib, which could result in failure of the rudder end rib. This failure could result in loss of directional control.
Airworthiness Directives; Mitsubishi Heavy Industries MU-2B Series Airplanes
Document Number: E6-6054
Type: Proposed Rule
Date: 2006-04-24
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to revise an earlier proposed airworthiness directive (AD) that applies to all Mitsubishi Heavy Industries MU-2B series airplanes. The earlier NPRM would have required you to do the following: Remove and visually inspect the wing attach barrel nuts, bolts, and retainers for cracks, corrosion, and fractures; replace any cracked, corroded, or fractured parts; inspect reusable wing attach barrel nuts and bolts for deformation and irregularities in the threads; replace any deformed or irregular parts; and install new or reusable parts and torque to the correct value. The earlier NPRM resulted from a recent safety evaluation that used a data-driven approach to evaluate the design, operation, and maintenance of the MU- 2B series airplanes in order to determine their safety and define what steps, if any, are necessary for their safe operation. This proposed AD would retain the actions from the earlier NPRM, add airplanes to the applicability, revise the serial numbers of the affected airplanes, and update the manufacturer's contact information. This proposed AD results from the manufacturer revising the service information to include two additional airplane models. Since these actions impose an additional burden over that proposed in the NPRM, we are reopening the comment period to allow the public the chance to comment on these additional actions.
Availability of a Draft FONSI/FONPA
Document Number: E6-6038
Type: Notice
Date: 2006-04-24
Agency: Maritime Administration, Department of Transportation
The purpose of this Notice is to make available to the public the draft Finding of No Significant Impact/Finding of No Practicable Alternative (FONSI/FONPA) for the Port of Anchorage Intermodal Expansion, North End Runway Material Extraction and Transport Project (Project). A draft Environmental Assessment (EA), dated March 2006, was prepared that analyzed the potential impacts on the human and natural environment associated with the proposed material extraction activities at the North End Borrow Site and potential transportation corridors located on Elmendorf Air Force Base (EAFB). A final EA and a final FONSI/FONPA will be published once comments have been properly addressed. This environmental documentation supports the proposed expansion of the Port of Anchorage (POA), which includes a variety of activities to enhance the transportation of goods and people within the State of Alaska.
Worker Visibility
Document Number: E6-6025
Type: Proposed Rule
Date: 2006-04-24
Agency: Federal Highway Administration, Department of Transportation
The FHWA proposes to require the use of high-visibility safety apparel for workers who are working within the Federal-aid highway rights-of-way. This action would decrease the likelihood of fatalities or injuries to workers on foot who are exposed either to traffic (vehicles using the highway for purposes of travel) or to construction vehicles or equipment while working within the rights-of-ways of Federal-aid highways. This proposal is in response to section 1402 of the Safe, Accountable, Flexible, Efficient Transportation Equity Act: A Legacy for Users (SAFETEA-LU), Public Law 109-59, 119 Stat. 1227.
Federal Motor Vehicle Safety Standards; Occupant Protection in Interior Impact
Document Number: E6-6024
Type: Proposed Rule
Date: 2006-04-24
Agency: National Highway Traffic Safety Administration, Department of Transportation
Our safety standard on occupant protection in interior impact requires, in part, that light vehicles provide head protection when an occupant's head strikes upper interior components, such as pillars, side rails, headers, and the roof during a crash. For altered vehicles and vehicles built in two or more stages, these requirements become effective September 1, 2006. The Recreation Vehicle Industry Association and the National Truck Equipment Association petitioned the agency to permanently exclude certain types of altered vehicles and vehicles manufactured in two or more stages from these requirements. This document responds to these petitions for rulemaking and proposes certain amendments to the standard. Based on a careful consideration of both the safety benefits of the upper interior protection requirements, and practicability concerns relating to vehicles built in two or more stages and certain altered vehicles, we are proposing to limit these requirements to only the front seating positions of those vehicles. Further, we tentatively conclude that it is appropriate to exclude a narrow group of multi- stage vehicles delivered to the final stage manufacturer without an occupant compartment, because of impracticability concerns. We are also proposing to delay the effective date of the head impact protection requirements as they apply to final stage manufacturers and alterers until September 1, 2008.
Revision of Class E Airspace; Herlong, CA
Document Number: 06-3864
Type: Rule
Date: 2006-04-24
Agency: Federal Aviation Administration, Department of Transportation
This final rule will revise the Class E airspace area at Herlong, CA. Additional controlled airspace is necessary for the safety of Instrument Flight Rules (IFR) aircraft during airborne holding. Holding airspace is designed with specific altitudes and lateral boundaries within controlled airspace. This airborne holding procedure is also an integral part of a new Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedure (SIAP) at the Amedee Army Air Field (AFF), Herlong, CA.
Establishment of Class E Airspace; Galbraith Lake, AK
Document Number: 06-3863
Type: Rule
Date: 2006-04-24
Agency: Federal Aviation Administration, Department of Transportation
This action establishes Class E airspace at Galbraith Lake, AK to provide adequate controlled airspace to contain aircraft executing two amended Special Standard Instrument Approach Procedures (SIAPs). This rule results in new Class E airspace established upward from 700 feet (ft.) above the surface at Galbraith Lake, AK.
Revision of Class E Airspace; Middleton Island, AK
Document Number: 06-3862
Type: Rule
Date: 2006-04-24
Agency: Federal Aviation Administration, Department of Transportation
This action revises Class E airspace at Middleton Island, AK to provide adequate controlled airspace to contain aircraft executing two new and two amended Standard Instrument Approach Procedures (SIAPs). This rule results in revised Class E airspace established upward from 700 feet (ft.) and 1,200 ft. above the surface at Middleton Island, AK.
Establishment of Class E Airspace; Kuparuk, AK
Document Number: 06-3861
Type: Rule
Date: 2006-04-24
Agency: Federal Aviation Administration, Department of Transportation
This action establishes Class E airspace at Kuparuk, AK to provide adequate controlled airspace to contain aircraft executing eight Special Standard Instrument Approach Procedures (SIAPs). This rule results in new Class E airspace established upward from 700 feet (ft.) above the surface at Ugnu-Kuparuk Airport, AK.
Revision of Class E Airspace; Togiak Village, AK
Document Number: 06-3860
Type: Rule
Date: 2006-04-24
Agency: Federal Aviation Administration, Department of Transportation
This action revises Class E airspace at Togiak Village, AK to provide adequate controlled airspace to contain aircraft executing two new and two amended Standard Instrument Approach Procedures (SIAPs). This rule results in revised Class E airspace established upward from 700 feet (ft.) above the surface at Togiak Village, AK.
Establishment of Class E Airspace; Minchumina, AK
Document Number: 06-3859
Type: Rule
Date: 2006-04-24
Agency: Federal Aviation Administration, Department of Transportation
This action corrects an error in the airspace description contained in a Final Rule that was published in the Federal Register on Wednesday, April 5, 2006 (71 FR 16997). Airspace Docket No. 05-AAL-41.
Interim Guidelines for Certification and Continued Airworthiness of Unbalanced Control Surfaces With Freeplay and Other Nonlinear Features
Document Number: 06-3858
Type: Notice
Date: 2006-04-24
Agency: Federal Aviation Administration, Department of Transportation
The Federal Aviation Administration (FAA) announces the availability of proposed Interim Guidelines for Certification and Continued Airworthiness of Unbalanced Control Surfaces with Freeplay and Other Nonlinear Features.
Agency Information Collection Activity Under OMB Review, Request for Comments; Renewal of an Approved Information Collection Activity, Operating Requirements: Commuter and On-Demand Operation
Document Number: 06-3857
Type: Notice
Date: 2006-04-24
Agency: Federal Aviation Administration, Department of Transportation
The FAA invites public comments about our intention to request the Office of Management and Budget's (OMB) renewal of a current information collection. The Federal Register Notices with a 60-day comment period soliciting comments on the following collection of information was published on January 18, 2006, volume 71, 11, page 2982. Standards have been established for the operation of agricultural aircraft and for the dispensing of chemicals, pesticides, and toxic substances. Information collected shows applicant compliance and eligibility for certification by FAA.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.