Department of Transportation January 19, 2005 – Federal Register Recent Federal Regulation Documents

The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus models, as specified above. This proposed AD would require installing safety signs on all passenger/crew doors, emergency exit doors, and cargo compartment doors. This proposed AD is prompted by a report of injuries occurring on in-service airplanes when crewmembers forcibly initiated opening of passenger/crew doors against residual pressure causing the doors to rapidly open. We are proposing this AD to ensure that crewmembers are informed of the risks associated with forcibly opening passenger/crew, emergency exit, and cargo doors before an airplane is fully depressurized, which will prevent injury to crewmembers, and subsequent damage to the airplane caused by the rapid opening of the door.

The FAA proposes to adopt a new airworthiness directive (AD) for certain Boeing Model 777-200 and -300 series airplanes. This proposed AD would require modification of the operational program software (OPS) of the air data inertial reference unit (ADIRU). This proposed AD is prompted by a report of the display of erroneous heading information to the pilot due to a defect in the OPS of the ADIRU. We are proposing this AD to prevent the display of erroneous heading information to the pilot, which could result in loss of the main sources of attitude data, consequent high pilot workload, and subsequent deviation from the intended flight path.

This action amends Title 14 Code of Federal Regulations, part 71 (14 CFR 71) by revising Class E airspace at Coffeyville, KS. A review of controlled airspace for Coffeyville Municipal Airport revealed it does not comply with the criteria for 700 feet above ground level (AGL) airspace required for diverse departures. The area is modified and enlarged to conform to the criteria in FAA Orders.

This notice proposes to create a Class E surface area at Ankeny, IA. It also proposes to modify the Class E5 airspace at Ankeny, IA.

The FAA will hold two informational meetings to discuss the proposed policy (Draft Order 8110.RC) that the FAA's Aircraft Certification Service personnel, Flight Standards Service Personnel, persons designated by the Administrator, and organizations associated with the certification process required by Title 14 of the Code of Federal Regulations (14 CFR) will use during the certification evaluation of restricted category aircraft. These public meetings will be a continuation of information gathering for the evaluation of Restricted Category Aircraft Applications originally offered to the public for comments in the Federal Register dated October 8, 2004, Page 60454 (Volume 69, Number 195). Notes from these informational meetings will be posted on the Internet at: https://www.faa.gov/Certification/ Aircraft/DraftDoc/Comments.htm.

The Federal Aviation Administration (FAA) is issuing this Notice of Intent to announce publicly that an Environmental Impact Statement (EIS) will be prepared and considered for the proposed extension of Runway 9R/27L including associated improvements described below at the Fort Lauderdale-Hollywood International Airport.

The Federal Transit Administration (FTA) and the City of Tucson, Department of Transportation (TDOT), intend to prepare an Alternatives Analysis (AA) and an Environmental Impact Statement (EIS) in accordance with the National Environmental Policy Act (NEPA) on a proposal by the City of Tucson to provide additional transit service to the urban core of the City of Tucson. The AA/EIS will consider the following alternatives: (1) A No-Build Alternative, consisting of improvements contained in the Pima Association of Governments (PAG) 2025 Regional Transportation Plan (RTP); (2) Transportation System Management Alternative (TSM), consisting of all reasonable cost- effective transit service improvements within the urban core short of a major investment in a New Starts project; (3) Rubber Tired Rapid Bus Circulator operating in mixed traffic (4) Modern Streetcar operating in mixed traffic; and (5) Heritage Trolley in mixed traffic. The type, location, and need for ancillary facilities, such as maintenance facilities, will also be considered for each alternative. In addition, alternatives that are identified from the scoping process will be evaluated in the AA. This notice is an update to replace the notice published in the Federal Register on 12/21/04. Scoping will be accomplished through correspondence and discussions with interested persons; organizations; and Federal, State, and local agencies; and through public and agency meetings. Depending on the outcome of the scoping process and the analysis of a wide range of transit alternatives in the Draft EIS (DEIS), a Locally Preferred Alternative (LPA) will be selected and evaluated in the Final EIS (FEIS). The FEIS will evaluate the potential impacts of the selected investment strategy (the Build Alternative) and a No-Build Alternative.

The FAA adopts a new airworthiness directive (AD) to revise AD 98-20-38, which applies to all Beech 200 series airplanes. AD 98-20-38 requires you to revise the FAA-approved Airplane Flight Manual (AFM) to specify procedures that would prohibit flight in severe icing conditions (as determined by certain visual cues), limit or prohibit the use of various flight control devices while in severe icing conditions, and provide the flight crew with recognition cues for and procedures for exiting from severe icing conditions. Part of the applicability of AD 98-20-38 includes the Raytheon Models B200 and B200C airplanes. AD 96-09-13 already requires AFM revisions on this subject for these airplane models. Consequently, FAA is revising AD 98-20-38 to remove the Models B200 and B200C from the applicability and add clarification that AD 96-09-13 affects these airplanes. We are issuing this AD to minimize the potential hazards associated with operating these airplanes in severe icing conditions by providing more clearly defined procedures and limitations.

The FAA is adopting a new airworthiness directive (AD) for certain The Lancair Company (Lancair) Models LC40-550FG and LC42-550FG airplanes. This AD requires you to incorporate additional takeoff chart distance values information into the Performance Section of the FAA- approved Airplane Flight Manual (AFM). This AD results from flight testing that revealed that the takeoff distance values for the affected airplanes could not be duplicated. We are issuing this AD to prevent potential impact with terrain or obstruction during takeoff due to incorrect takeoff distance values.

The FAA adopts a new airworthiness directive (AD) to supersede AD 98-03-14, which applies to certain EXTRA Flugzeugbau GmbH (EXTRA) Model EA-300 and EA-300/S airplanes. AD 98-03-14 currently requires you to inspect the upper longeron cutout-bridge for cracks, to repair any cracks found, and to modify this area. This AD retains the actions of AD 98-03-14 and incorporates new service information. For owner/ operators of the affected airplanes that were able to do the modification required in AD 98-03-14, no further action is required. This AD results from mandatory continuing airworthiness information (MCAI) issued by the airworthiness authority for Germany. We are issuing this AD to detect and correct cracks in the upper longeron cutout-bridge, which could cause the upper longeron cutout-bridge to fail resulting in structural damage to the fuselage. This condition could lead to loss of control of the airplane.