National Highway Traffic Safety Administration March 2015 – Federal Register Recent Federal Regulation Documents

NHTSA published a notice in the Federal Register on May 8, 2013, (78 FR 26849; NHTSA Docket 2013-0058) that revised the Model Specifications for Breath Alcohol Ignition Interlock Devices (BAIIDs). The text of the notice contained some typographical and technical errors. This document describes and corrects those errors. This notice also proposes some additional changes to the BAIID Model Specifications and requests comments on the proposed changes.

Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatements of previously approved collections. This document describes the collection of information for which NHTSA intends to seek OMB approval.

This document grants in full the Volkswagen Group of America, Inc.'s (Volkswagen's) petition for exemption of the Audi TT vehicle line in accordance with 49 CFR part 543, Exemption from the Theft Prevention Standard. This petition is granted because the agency has determined that the antitheft device to be placed on the line as standard equipment is likely to be as effective in reducing and deterring motor vehicle theft as compliance with the parts-marking requirements of 49 CFR part 541, Federal Motor Vehicle Theft Prevention Standard (Theft Prevention Standard).

This notice grants the petition of Greenkraft, Inc. (Greenkraft) for a temporary exemption from the headlamp requirements of FMVSS No. 108 for the company's 1061 and 1083 model trucks for headlamps complying with European regulatory requirements. The exemption is limited to 120 vehicles. The agency has considered Greenkraft's petition for exemption and has determined that the exemption would facilitate the development or field evaluation of a low-emission motor vehicle and would not unreasonably reduce the safety level of that vehicle if the vehicle is used in a manner consistent with the conditions discussed in this notice.

This document supplements NHTSA's March 2012 notice of proposed rulemaking (NPRM) to amend Federal Motor Vehicle Safety Standard (FMVSS) No. 210, ``Seat belt assembly anchorages,'' to specify a force application device (FAD) for use as a testing interface to transfer loads onto the seat belt anchorage system during compliance tests of anchorage strength. The agency received a number of comments on the NPRM that raised issues concerning the feasibility of the FAD proposal. After reviewing the comments, NHTSA has decided to propose in this SNPRM an alternative test procedure, i.e., one that would maintain the current FMVSS No. 210 body blocks and adopt procedures ensuring that the placement of the body blocks, at pre-load, is sufficiently specified. The agency requests comments on this alternative strategy and other potential enhancements to the current body block test procedure.

Ford Motor Company (Ford) has determined that certain model year (MY) 2010-2014 Transit Connect vehicles do not fully comply with paragraph S5.1 of Federal Motor Vehicle Safety Standard (FMVSS) No. 205, Glazing Materials. Ford has filed an appropriate report dated March 31, 2014, pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports.