Federal Aviation Administration July 9, 2024 – Federal Register Recent Federal Regulation Documents

The FAA is adopting a new airworthiness directive (AD) for certain CFE Company (CFE) Model CFE738-1-1B engines. This AD was prompted by a manufacturer investigation that revealed certain high- pressure turbine (HPT) stage 1 and stage 2 disks were manufactured from powder metal material suspected to contain iron inclusion. This AD requires replacement of affected HPT stage 1 and stage 2 disks with parts eligible for installation. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all Leonardo S.p.a. Model AW189 helicopters. This AD was prompted by a report of abnormal oscillatory behavior during automated glide slope approaches, due to sealant on the glide slope (G/S) antenna coaxial connectors. This AD requires visually inspecting certain G/S antennas and G/S antenna coaxial connectors for the presence of any sealant; cleaning parts and removing any sealant; performing an external G/S acceptance test procedure (ATP); and taking corrective actions if necessary. This AD would also prohibit installing certain G/S antennas and G/S antenna coaxial connecters. These requirements are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2022-14- 10, which applied to certain Airbus SAS Model A318 series airplanes; Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320-211, -212, -214, -216, -231, -232, and -233 airplanes; and Model A321-111, -112, -131, -211, -212, -213, -231, and -232 airplanes. AD 2022-14-10 required repetitive inspections for cracking of the radius of the front spar vertical stringers and the horizontal floor beam on a certain frame (FR), repetitive inspections for cracking of the fastener holes of the front spar vertical stringers on that frame, and repair if necessary. AD 2022-14-10 also provided, for certain airplanes, a modification of the center wing box area that terminates the repetitive inspections under certain conditions. Since the FAA issued AD 2022-14-10, an additional airplane model has been identified that is also subject to the unsafe condition. This AD continues to require the actions in AD 2022-14-10 and adds Model A321-271N airplanes to the applicability, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference (IBR). The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all Rolls-Royce Deutschland Ltd & Co KG (RRD) Trent 1000-A, Trent 1000-AE, Trent 1000-C, Trent 1000-CE, Trent 1000-D, Trent 1000-E, Trent 1000-G, and Trent 1000-H engines. This AD is prompted by reports of cracking and separation of certain low-pressure turbine (LPT) stage 1 blade assemblies. This AD requires initial and repetitive inspections of affected LPT stage 1 blade assemblies for cracking or separation and, depending on the results of the inspections, reduction of the inspection interval or replacement of the LPT stage 1 blade set and disk. This AD also prohibits the installation of an LPT disk or blade set assembly unless it is considered a serviceable part, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.