Federal Aviation Administration January 3, 2024 – Federal Register Recent Federal Regulation Documents
Results 1 - 15 of 15
Petition for Exemption; Summary of Petition Received; Equinox Innovative Systems
On December 14, 2023, the Federal Aviation Administration (FAA) published a notice in the Federal Register containing a summary of a petition from Equinox Innovative Systems seeking relief from specified requirements of Federal Aviation Regulations. The FAA is extending the comment period for this petition for exemption to allow commenters additional time to analyze the petition and prepare a response.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is superseding Airworthiness Directive (AD) 2022-07- 15, which applied to all Airbus SAS Model A318, A319, A320, and A321 series airplanes. AD 2022-07-15 required replacing affected braking and steering control units (BSCUs) and revising the operator's existing FAA-approved minimum equipment list (MEL). This AD was prompted by a determination that a type 1 relay combined with an affected BSCU would induce BSCU freezing. This AD removes certain airplanes from the applicability, retains the requirements of AD 2022-07-15, requires an inspection for the relay type installed and replacement of type 1 relays with type 2 relays, limits the installation of affected BSCUs on certain airplanes and prohibits the installation of affected BSCUs for certain other airplanes as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Embraer S.A. (Type Certificate Previously Held by Yaborã Indústria Aeronáutica S.A.; Embraer S.A.) Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Embraer S.A. Model ERJ 190-300 and -400 airplanes. This AD was prompted by a report that the method for calculating level-off altitude by the computerized airplane flight manual (CAFM), may result in a non- conservative level-off height. This AD requires revising the existing airplane flight manual (AFM) to incorporate new CAFM versions as specified in an Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc., Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL-600-2B16 (604 Variant) airplanes. This AD was prompted by a report that some airplanes were delivered without a portable protective breathing equipment (PBE) device located in the left-side forward wardrobe, flight deck, or passenger cabin area of the airplane. This AD requires visually inspecting the forward left side cabin area of the airplane to determine if the portable PBE device is installed and, if not installed, requires installing the portable PBE device along with the associated placard. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is superseding Airworthiness Directive (AD) 2020-24- 12, which applied to certain Airbus SAS Model A350-941 airplanes. AD 2020-24-12 required replacing certain center wing box (CWB) fasteners with fasteners having improved friction efficiency. This AD was prompted by reports that certain CWB fasteners had rotated inside the fastener holes due to insufficient friction for the application, and by the determination that additional work is necessary to ensure the correct application of the fuel vapor barrier structure paint on the outside of the CWB. This AD continues to require the actions in AD 2020-24-12; and requires the additional work; as specified in European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A318-112 airplanes; Model A319-115, -132, -133, -151N, -153N, and -171N airplanes; Model A320-211, -212, -214, -231, -232, - 251N, -252N, -253N, -271N, -272N, and -273N airplanes; and Model A321- 112 airplanes. This AD was prompted by a report that the fatigue life limit of the motoreductor installed on the on-board entrance stairs is not demonstrated for the complete airplane design service goal (DSG). This AD requires repetitive replacement of the motoreductor for onboard entrance stairs, and it limits the installation of affected parts under certain conditions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Defense and Space S.A. (Formerly Known as Construcciones Aeronauticas, S.A.) Airplanes
The FAA is superseding Airworthiness Directive (AD) 2021-02- 18, which applied to all Airbus Defense and Space S.A. Model CN-235, CN-235-100, CN-235-200, and CN-235-300 airplanes and Model C-295 airplanes. AD 2021-02-18 required repetitive inspections for cracking or broken rivets of certain left- and right-hand stringers and surrounding structure, and repair if necessary. This AD was prompted by a modification that was developed to reinforce the structure in the affected area, providing terminating action for the repetitive inspections required by AD 2021-02-18. This AD continues to require certain actions in AD 2021-02-18 and requires the new terminating action for the repetitive inspections, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Agency Information Collection Activities: Requests for Comments; Clearance of Renewed Approval of Information Collection: Noise Certification Standards for Subsonic Jet Airplanes and Subsonic Transport Category Large Airplanes
In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on May 8, 2023.
IFR Altitudes; Miscellaneous Amendments
This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.
Airworthiness Directives; WACO Classic Aircraft Corporation Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain WACO Classic Aircraft Corporation Model 2T-1A-2 airplanes. This AD was prompted by reports of multiple types of cracks at the leading edge former ribs and trailing edge former ribs in the upper wing center section. This AD requires installing maneuver restriction placards in the front and rear cockpits, inspecting the leading and trailing edge former ribs for cracking, replacing any cracked ribs, modifying the upper wing center section assembly, and removing the maneuver restriction placards after completing the modification. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Rolls-Royce Deutschland Ltd & Co KG Engines
The FAA is adopting a new airworthiness directive (AD) for all Rolls-Royce Deutschland Ltd & Co KG (RRD) Model Trent 1000-AE3, Trent 1000-CE3, Trent 1000-D3, Trent 1000-G3, Trent 1000-H3, Trent 1000-J3, Trent 1000-K3, Trent 1000-L3, Trent 1000-M3, Trent 1000-N3, Trent 1000- P3, Trent 1000-Q3, and Trent 1000-R3 engines. This AD is prompted by a determination that certain intervals for visual inspection of the intermediate-pressure stage 8 (IP8) and high-pressure stage 3 (HP3) air transfer tubes and front bearing housing IP8 air feed tubes need to be reduced. This AD requires initial and repetitive visual inspections of the IP8 and HP3 air transfer tubes and front bearing housing IP8 air feed tubes for cracking, damage, or air leakage wear, and replacement, if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference (IBR). The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; The Boeing Company Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This AD was prompted by a reported quality escapement where the seat track fitting nuts were under-torqued on some flight attendant seats in production. This AD requires re-torquing each free-standing attendant seat track fitting nut. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A318, A319, A321, A330-200, A330-200 Freighter, A330- 300, A330-800, A330-900, A340-200, and A340-300 series airplanes; Model A320-211, -212, -214, -216, -231, -232, -233, -251N, -252N, -253N, - 271N, -272N, and -273N airplanes; and Model A340-541 and A340-642 airplanes. This AD was prompted by a report that a production deficiency of some SafeLav gaseous oxygen container (SLGOC) batches was identified during production testing of newly manufactured oxygen containers. This AD requires replacing affected SLGOCs and prohibiting the installation of affected SLGOCs, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Dassault Aviation Airplanes
The FAA is superseding Airworthiness Directive (AD) 2023-04- 10, which applied to all Dassault Aviation Model MYSTERE-FALCON 900 airplanes. AD 2023-04-10 required revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. This AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This AD continues to require the actions in AD 2023-04- 10, and requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations; as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Saab AB, Support and Services (Formerly Known as Saab AB, Saab Aeronautics) Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Saab AB, Support and Services Model SAAB 2000 airplanes. This AD was prompted by a review of the anti-skid system that revealed the possibility of inadvertently connecting the inboard harness to the outboard channel (and vice versa) of the wheel speed transducers in the main landing gear (MLG) wheel axles. This AD requires installing color markings on the harnesses and the wheel axles, to ensure proper installation and connection of the anti-skid harnesses, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
