Federal Aviation Administration September 30, 2016 – Federal Register Recent Federal Regulation Documents

Airworthiness Directives; General Electric Company Turbofan Engines
Document Number: 2016-23740
Type: Rule
Date: 2016-09-30
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for all General Electric Company (GE) GE90-76B, GE90-77B, GE90-85B, GE90-90B, and GE90-94B turbofan engines with high-pressure compressor (HPC) stage 8-10 spool, part numbers (P/Ns) 1694M80G04, 1844M90G01, or 1844M90G02, installed. This AD was prompted by reports of cracks found on the seal teeth of the HPC stage 8-10 spool. This AD requires eddy current inspections (ECIs) or fluorescent penetrant inspections (FPIs) of the HPC stage 8-10 spool seal teeth and removing from service those parts that fail inspection. We are issuing this AD to prevent failure of the HPC stage 8-10 spool, uncontained rotor release, damage to the engine, and damage to the airplane.
Special Conditions: Embraer S.A., Model ERJ 190-300 Series Airplanes; Electronic Flight Control System: Control Surface Position Awareness, Multiple Modes of Operation
Document Number: 2016-23665
Type: Rule
Date: 2016-09-30
Agency: Federal Aviation Administration, Department of Transportation
These special conditions are issued for the Embraer S.A. Model ERJ 190-300 series airplanes. These airplanes will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. This design feature is a fly-by-wire electronic flight control system (EFCS) and no direct coupling from the flight deck controller to the control surface. As a result, the pilot is not aware of the actual control surface position. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Special Conditions: DAHER-SOCATA, Model TBM 700; Inflatable Four-Point Restraint Safety Belt With an Integrated Airbag Device
Document Number: 2016-23564
Type: Rule
Date: 2016-09-30
Agency: Federal Aviation Administration, Department of Transportation
These special conditions are issued for the installation of an inflatable four-point restraint safety belt with an integrated airbag device at the pilot and copilot seats on the DAHER-SOCATA, Model TBM 700 airplane. These airplanes, as modified by the installation of these inflatable safety belts, will have novel and unusual design features associated with the upper-torso restraint portions of the four-point safety belts, which contain an integrated airbag device. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Modification of Class E Airspace; Napa, CA
Document Number: 2016-23423
Type: Rule
Date: 2016-09-30
Agency: Federal Aviation Administration, Department of Transportation
This action modifies the Class E airspace extending upward from 700 feet above the surface at Napa County Airport, Napa, CA, by removing an irregular shaped area located approximately 20 miles southwest of Napa County Airport. This airspace area is discontinuous from the airspace surrounding Napa County Airport and is not essential to instrument flight rules (IFR) operations at the airport. This action also updates the airport's geographic coordinates, and is necessary for the safety and management of instrument flight rules (IFR) operations at the airport, with the minimum amount of airspace restriction.
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
Document Number: 2016-23414
Type: Rule
Date: 2016-09-30
Agency: Federal Aviation Administration, Department of Transportation
This rule amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide for the safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
Document Number: 2016-23411
Type: Rule
Date: 2016-09-30
Agency: Federal Aviation Administration, Department of Transportation
This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
Document Number: 2016-23410
Type: Rule
Date: 2016-09-30
Agency: Federal Aviation Administration, Department of Transportation
This rule amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide for the safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
Document Number: 2016-23406
Type: Rule
Date: 2016-09-30
Agency: Federal Aviation Administration, Department of Transportation
This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Airworthiness Directives; Bell Helicopter Textron Canada Limited (Bell) Helicopters
Document Number: 2016-23345
Type: Rule
Date: 2016-09-30
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for Bell Model 427 and Model 429 helicopters. This AD requires replacing certain engine and transmission oil check valves. This AD also prohibits installing the affected check valves on any helicopter. This AD is prompted by a report of several cracked or leaking check valves. These actions are intended to detect and prevent a cracked or leaking check valve which could result in loss of lubrication to the engine or transmission, failure of the engine or transmission, and subsequent loss of control of the helicopter.
Airworthiness Directives; Honeywell International Inc. Turboprop and Turboshaft Engines
Document Number: 2016-23263
Type: Rule
Date: 2016-09-30
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Honeywell International Inc. (Honeywell) TPE331 model turboprop engines and TSE331-3U model turboshaft engines. This AD was prompted by the discovery of cracks in a 2nd stage compressor impeller during a routine shop visit. This AD requires removal of the 2nd stage compressor impeller. We are issuing this AD to prevent failure of the compressor impeller, uncontained part release, damage to the engine, and damage to the airplane.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.