Federal Aviation Administration September 30, 2016 – Federal Register Recent Federal Regulation Documents

These special conditions are issued for the Embraer S.A. Model ERJ 190-300 series airplanes. These airplanes will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. This design feature is a fly-by-wire electronic flight control system (EFCS) and no direct coupling from the flight deck controller to the control surface. As a result, the pilot is not aware of the actual control surface position. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

This action modifies the Class E airspace extending upward from 700 feet above the surface at Napa County Airport, Napa, CA, by removing an irregular shaped area located approximately 20 miles southwest of Napa County Airport. This airspace area is discontinuous from the airspace surrounding Napa County Airport and is not essential to instrument flight rules (IFR) operations at the airport. This action also updates the airport's geographic coordinates, and is necessary for the safety and management of instrument flight rules (IFR) operations at the airport, with the minimum amount of airspace restriction.

This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

We are adopting a new airworthiness directive (AD) for certain Honeywell International Inc. (Honeywell) TPE331 model turboprop engines and TSE331-3U model turboshaft engines. This AD was prompted by the discovery of cracks in a 2nd stage compressor impeller during a routine shop visit. This AD requires removal of the 2nd stage compressor impeller. We are issuing this AD to prevent failure of the compressor impeller, uncontained part release, damage to the engine, and damage to the airplane.