Federal Aviation Administration April 14, 2014 – Federal Register Recent Federal Regulation Documents

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The requested information is needed to mitigate potential hazards presented by airmen using alcohol or drugs in flight, to identify persons possibly unsuitable for pilot certification.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. This information collection is used to allocate slots and maintain accurate records of slot transfers at High Density Traffic Airports. The information is provided by air carriers and commuter operators, or other persons holding a slot at High Density Airports.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. FAR Part 43 prescribes the rules governing maintenance, rebuilding, and alteration of aircraft components, and is necessary to ensure this work is performed by qualified persons, and at proper intervals. This work is done by certified mechanics, repair stations, and air carriers authorized to perform major alterations and major repairs.

The FAA proposes to rule and invite public comment on the release of land at the Victoria Regional Airport under the provisions of Section 125 of the Wendell H. Ford Aviation Investment Reform Act for the 21st Century (AIR 21).

We propose to adopt a new airworthiness directive (AD) for all The Boeing Company Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. This proposed AD was prompted by reports of latently failed fuel shutoff valves discovered during fuel filter replacement. This proposed AD would require revising the maintenance or inspection program to include new airworthiness limitations. We are proposing this AD to detect and correct latent failures of the fuel shutoff valve to the engine, which could result in the inability to shut off fuel to the engine and, in case of certain engine fires, an uncontrollable fire that could lead to wing failure.

We propose to adopt a new airworthiness directive (AD) for all British Aerospace Regional Aircraft Jetstream Model 3201 airplanes that would supersede AD 2007-10-16. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as the need to incorporate revisions to the Airworthiness Limitations section of the Instructions for Continued Airworthiness. We are issuing this proposed AD to require actions to address the unsafe condition on these products.

We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc. Model CL-600-2C10 (Regional Jet Series 700, 701, & 702) airplanes, Model CL-600-2D15 (Regional Jet Series 705) airplanes, Model CL-600-2D24 (Regional Jet Series 900) airplanes, and Model CL-600-2E25 (Regional Jet Series 1000) airplanes. This proposed AD was prompted by two in-service reports of fracture of the rudder pedal tubes installed on the pilot-side rudder bar assembly. This proposed AD would require repetitive inspections for cracking and damage of the pilot-side rudder pedal tubes, and corrective action if necessary. This proposed AD would also provide optional terminating action for the repetitive inspections. We are proposing this AD to detect and correct cracked and damaged pilot-side rudder pedal tubes, which could result in loss of function of the pilot's rudder pedal during flight, takeoff, or landing, and could result in reduced controllability of the airplane.

We propose to supersede Airworthiness Directive (AD) 95-26-11, which applies to all Lockheed Martin Corporation/Lockheed Martin Aeronautics Company Model L-1011 series airplanes. AD 95-26-11 currently requires inspections to detect cracking of the fittings that attach the aft pressure bulkhead to the fuselage stringers, inspections to detect cracking of the fittings and of the splice tab of the aft pressure bulkhead, and corrective actions if necessary. Since we issued AD 95-26-11, we have determined that the fittings at stringer attachments to the upper region of the aft pressure bulkhead are subject to widespread fatigue damage (WFD), which could result in cracking in the aft pressure bulkhead. This proposed AD would reduce the compliance time; add inspections for cracking of certain aft fuselage skin panels; add a structural modification; and also add a post modification inspection program. We are proposing this AD to prevent simultaneous failure of multiple stringer end fittings through fatigue cracking at the aft pressure bulkhead, which could lead to rapid decompression of the airplane.

These special conditions are issued for the Embraer S.A. Model EMB-550 airplane. This airplane will have a novel or unusual design feature associated with an electronic flight control system that prevents the pilot from inadvertently or intentionally exceeding the positive or negative airplane limit load factor. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

This action modifies RNAV route Q-20 by relocating the FUSCO waypoint (WP) southwest to match the intersection of Jet routes J-15 and J-183. This action enhances the safe and efficient management of aircraft within the National Airspace System.