Federal Aviation Administration September 19, 2013 – Federal Register Recent Federal Regulation Documents

This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.

The FAA is issuing this notice to advise the public of the ninety-first meeting of the RTCA Special Committee 159, Global Positioning Systems (GPS)

A NPRM published in the Federal Register of September 6, 2013, to amend the Class D airspace ceiling at Addison Airport, Dallas, TX, is being withdrawn. Upon review, the FAA determined that the proposed rulemaking action is premature in that an existing Dallas/Fort Worth Class B airspace rulemaking action is pending.

This action proposes to establish Class D airspace and Class E airspace at Laguna Army Air Field (AAF), (Yuma Proving Ground), Yuma, AZ. The establishment of an air traffic control tower has made this action necessary for the safety and management of Instrument Flight Rules (IFR) aircraft within this airspace.

This action grants with conditions a limited waiver of the slot usage requirement for operating authorizations (slots) at Newark Liberty International Airport (EWR) due to construction at the airport during the summer 2014 scheduling season. This waiver applies only to EWR slots for the following days and local times: (1) March 30 through June 15 for 0600-2259 slots; (2) Mondays through Saturdays from June 16 through September 19 for 0600-0629 slots; (3) Sundays from June 22 through September 14 for 0600-0859 slots; and (4) September 20 through October 25 for 0600-2259 slots.

We propose to supersede airworthiness directive (AD) 2012-12- 08, which applies to certain The Boeing Company Model 777-200 and -300 series airplanes. AD 2012-12-08 requires an inspection for the part number of the fuse pin, and replacement of the pin if necessary. Since we issued AD 2012-12-08, we have determined that additional airplanes may be subject to the identified unsafe condition. This proposed AD would retain the actions required by AD 2012-12-08 and add airplanes to the applicability. We are proposing this AD to prevent structural damage to the side and drag brace lock assemblies, which could result in landing gear collapse during touchdown, rollout, or taxi.

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.