Federal Aviation Administration October 19, 2011 – Federal Register Recent Federal Regulation Documents

The FAA proposes to amend the maintenance regulations by removing from the preventive maintenance category the task of updating databases used in self-contained, front-panel or pedestal-mounted navigation equipment. This change would allow pilots who operate certificated aircraft to update the specified databases and eliminate the requirement for certificated mechanics or repair stations to perform the update. The effect of this revision would be to ensure that pilots using specified navigation equipment have the most current and accurate navigational data and thereby increase aviation safety.

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD would require revising the maintenance program to include new or more restrictive life-limits and inspections. This proposed AD was prompted by changes to the Airworthiness Limitations Section (ALS) of the maintenance manual, which adds life-limits, revises life-limits, or adds inspections not previously identified. We are proposing this AD to limit exposure of flight critical components to corrosion, cracking, or failure due to life-limits, which if not corrected, could result in loss of roll control, fatigue cracking, or loss of structural components.

We propose to supersede two existing airworthiness directives (ADs) that apply to General Electric Company (GE) CF6-45 and CF6-50 series turbofan engines with certain low-pressure turbine (LPT) rotor stage 3 disks installed. The existing ADs currently require inspections of high pressure turbine (HPT) and LPT rotors, engine checks, and surveys. Since we issued those ADs, GE has determined that the low- cycle fatigue (LCF) lives of the LPT rotor stage 3 disks affected by those ADs are below the current published engine manual life limits and has introduced a new LPT rotor stage 3 disk part number. This proposed AD would establish a new lower life limit for the LPT rotor stage 3 disks. We are proposing this AD to prevent critical life-limited rotating engine part failure, which could result in an uncontained engine failure and damage to the airplane.

We are adopting a new airworthiness directive (AD) for certain Model EMB-135ER, -135KE, -135KL, and -135LR airplanes; and Model EMB- 145, -145ER, -145MR, -145LR, -145MP, and -145EP airplanes. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are superseding an existing airworthiness directive (AD) that applies to certain Model A300 B4-600, B4-600R, and F4-600R series airplanes, and Model C4-605R Variant F airplanes (collectively called A300-600 series airplanes). This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are superseding an existing airworthiness directive (AD) that applies to the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are superseding an existing airworthiness directive (AD) that applies to the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: