Federal Aviation Administration October 28, 2009 – Federal Register Recent Federal Regulation Documents
Results 1 - 12 of 12
Airworthiness Directives; Turbomeca Arriel 2S1 Turboshaft Engines
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: During acceleration up to One Engine Inoperative (OEI) 30-second rating, one event of flight loss of full automatic control occurred on an Arriel 2S1 engine. The selection of OEI 30-second rating on engine 1 was triggered by the automatic detection of an OEI situation further to a transient deceleration of engine 2. The transient deceleration of engine 2 was caused by the untimely reset of its DECU. Once this reset was completed, engine 2 resumed its nominal operation. Afterwards the aircraft then continued its flight safely with its engine 1 operating in manual control mode. The loss of full automatic control of engine 1 was caused by loss of steps of the stepper motor controlling the fuel metering valve inside the Hydromechanical Unit (HMU). It has been found that high accelerations, notably up to OEI 30-second rating, increase the risk of loss of steps of the HMU stepper motor. Therefore, this event has led to the consideration of the following unsafe condition at aircraft level: In- flight loss of full automatic control of the engine induced by the loss of steps of the stepper motor during acceleration up to OEI 30-second rating, further to an actual OEI situation on the other engine (such as a power loss event).
Petition for Exemption; Summary of Petition Received
This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.
Petition for Exemption; Summary of Petition Received
This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.
Airworthiness Directives; Bombardier Model CL-600-2C10 (Regional Jet Series 700 & 701) Airplanes, Model CL-600-2D15 (Regional Jet Series 705) Airplanes, and Model CL-600-2D24 (Regional Jet Series 900) Airplanes
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Dassault Model Falcon 900EX Airplanes
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Airbus Model A300 B4-2C, B4-103, and B4-203 Airplanes; and Model A300 B4-601, B4-603, B4-620, B4-622, B4-605R, and B4-622R Airplanes
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Establishment of Class E Airspace; Nantucket, MA
This action establishes Class E Airspace at Nantucket Memorial Airport, Nantucket, MA, by establishing Class E Surface airspace designated as an extension to Class D airspace. This action will encompass the new Standard Instrument Approach Procedures (SIAPs) and enhance the safety and management of Instrument Flight Rules (IFR) around the Nantucket Memorial Airport, MA.
Modification of Class E Airspace; Anniston, AL
This action modifies the Class E airspace at Anniston Metropolitan Airport in Anniston, AL. After a new RNAV (GPS) Z approach was developed for Runway 23, it was determined that the Class E airspace at the airport should be modified to facilitate a more efficient operation. This rule increases the safety and management of the National Airspace System (NAS) around Anniston Metropolitan Airport.
Special Conditions: Bombardier Model Challenger CL-600-2B16 (CL-605, Ref. Note 9 of TC No. A21EA); Enhanced Flight Vision System (EFVS)
These special conditions are issued for the Bombardier Model CL-600-2B16 (CL-605) airplane. This airplane, as modified by Rockwell Collins Aerospace & Electronics, Inc., will have an Enhanced Flight Vision System (EFVS). The EFVS is a novel or unusual design feature which consists of a head-up display (HUD) system modified to display forward-looking infrared (FLIR) radar imagery. The airworthiness regulations applicable to pilot compartment view do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
This rule establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
This establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Airworthiness Directives; Eurocopter France (ECF) Model EC 155B and EC155B1 Helicopters
We are adopting a new airworthiness directive (AD) for the specified ECF model helicopters. This AD results from a mandatory continuing airworthiness information (MCAI) AD issued by the European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community. The MCAI AD states that freezing of the route display on the navigation display (ND) in the Sector mode occurs for flight plans that include procedures in the terminal zone (departure or arrival). The MCAI AD prohibits the use of the UNS-1D navigation system (also known as the Flight Management System (FMS)) for Standard Instrument Departure (SID), Standard Instrument Terminal Arrival Route (STAR), and instrument approach procedures. The actions are intended to prevent the flight crew from relying on a frozen route ND, unanticipated increases in flight crew workload, pilot confusion in the terminal airspace environment, and subsequent loss of control of the helicopter.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.