Federal Aviation Administration September 20, 2007 – Federal Register Recent Federal Regulation Documents
Results 1 - 9 of 9
Recording of Major Repairs and Major Alterations
This action amends instructions to aviation maintenance providers regarding submittal of FAA Form 337, Major Repair and Alteration, for either major repair or major alteration; or for extended-range fuel tanks installed within the passenger compartment or a baggage compartment. This change clarifies the mailing instructions when submitting Form 337 to the FAA. The intent of this action is to amend the regulation to ensure mailing requirements are clear and accurate.
Airworthiness Directives; Boeing Model 737-100, -200, -200C, -300, -400, and -500 Series Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Boeing Model 737-100, -200, -200C, -300, -400, and -500 series airplanes. This proposed AD would require doing repetitive internal eddy current and detailed inspections to detect cracked stringer tie clips; doing applicable corrective and related investigative actions, if necessary; and measuring the fastener spacing and the edge margin; as applicable. As a temporary alternative to doing the actions described previously, this proposed AD would require repetitive external general visual inspections of the skin and lap joints for cracks and evidence of overload resulting from cracked stringer tie clips, and applicable corrective actions if necessary. This proposed AD results from a report of several cracked stringer tie clips. We are proposing this AD to prevent multiple cracked stringer tie clips and damaged skin and frames, which could lead to the skin and frame structure developing cracks and consequent decompression of the airplane.
Airworthiness Directives; Fokker Model F.28 Mark 0070 and 0100 Airplanes
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Boeing Model 767 Airplanes
The FAA proposes to supersede an existing airworthiness directive (AD) that applies to all Boeing Model 767 airplanes. The existing AD currently requires repetitive measurements of the rudder and elevator freeplay, repetitive lubrications of rudder and elevator components, and related investigative/corrective actions if necessary. This proposed AD would instead require revised repetitive measurements of the rudder freeplay and the elevator freeplay for each of the power control actuators (PCAs) that move the rudder and elevator, corrective and related investigative actions if necessary, and repetitive lubrications of the rudder and elevator components. For some airplanes, this proposed AD would also require related concurrent actions. This proposed AD results from reports of freeplay-induced vibration of the rudder and the elevator. The potential for vibration of the control surface should be avoided because the point of transition from vibration to divergent flutter is unknown. We are proposing this AD to prevent excessive vibration of the airframe during flight, which could result in loss of control of the airplane.
Airworthiness Directives; Airbus Model A318, A319, A320, and A321 Series Airplanes
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Bombardier Model CL-600-2B19 (Regional Jet Series 100 & 440) Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Bombardier Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. This proposed AD would require repetitive detailed inspections for cracking of the left side and right side frame and reinforcement angles at fuselage station (FS) 640 between stringer 9 and stringer 12, and corrective actions if necessary. This proposed AD results from reports that cracks have been discovered on the frame and reinforcement angles at FS 640. We are proposing this AD to detect and correct cracking of the frame, which could lead to failure of the fuselage structure and possible loss of the airplane.
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
This Rule establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Standard Instrument Approach Procedures; Miscellaneous Amendments
This rule amends Standard Instrument Approach Procedures (SIAPs) for operations at certain airports. These regulatory actions are needed because of changes in the National Airspace System, such as the commissioning of new navigational facilities, adding of new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Public Notice for Waiver of Aeronautical Land-Use Assurance; Pellston Regional Airport; Pellston, MI
The Federal Aviation Administration (FAA) is considering a proposal to change a portion of the airport from aeronautical use to non-aeronautical use and to authorize the release of 621.46 acres of vacant airport property for the proposed development of warehouses, training centers, and associated access roads as a component of Sovereign Deed's National Response Center. The land consists of 7 parcels. Parcel 1 was acquired under grant 9-20-048-C905. Parcels 2, 3, 4, 5 and 8 were dedicated as airport property prior to 1946 and have no federal funding involvement. Parcel 7 was acquired under grants 9-2- 048-C905 and 8-26-0076-01. There are no impacts to the airport by allowing the airport to lease the property. The land is not needed for aeronautical use. Approval does not constitute a commitment by the FAA to financially assist in the lease of the subject airport property nor a determination of eligibility for grant-in-aid funding from the FAA. The disposition of proceeds from the lease of the airport property will be in accordance with FAA's Policy and Procedures Concerning the Use of Airport Revenue, published in the Federal Register on February 16, 1999. In accordance with section 47107(h) of title 49, United States Code, this notice is required to be published in the Federal Register 30 days before modifying the land-use assurance that requires the property to be used for an aeronautical purpose.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
