Federal Aviation Administration November 29, 2006 – Federal Register Recent Federal Regulation Documents
Results 1 - 5 of 5
Airworthiness Directives; Turbomeca Arriel 1 Series Turboshaft Engines
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Hartzell Propeller Inc. Propellers and McCauley Propeller Systems Controllable Propellers
The FAA is adopting a new airworthiness directive (AD) for certain Hartzell Propeller Inc. HC, BHC, and PHC series propellers; and McCauley Propeller Systems controllable propellers serviced by Oxford Aviation Services Limited, doing business as CSE Aviation, in the United Kingdom between September 1998 and October 2003. This AD requires inspecting the propeller blades and other critical propeller parts for wear and mechanical damage. This AD results from findings that CSE Aviation failed to perform some specific inspections and repairs. We are issuing this AD to detect unsafe conditions that could result in a propeller blade separating from the hub and loss of control of the airplane.
Standard Instrument Approach Procedures, Weather Takeoff Minimums; Miscellaneous Amendments
This amendment establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and/or Weather Takeoff Minimums for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, addition of new obstacles, or changes in air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Airworthiness Directives; Air Tractor, Inc. Model AT-602 Airplanes
This document makes a correction to Airworthiness Directive (AD) 2006-23-09, which published in the Federal Register on November 9, 2006 (71 FR 65719), and applies to all Air Tractor, Inc. Model AT-602 airplanes. AD 2006-23-09 requires you to repetitively inspect (using the eddy current method) the wing center splice joint two outboard fastener holes on both of the wing main spar lower caps for fatigue cracking; repair or replace any wing main spar lower cap where fatigue cracking is found; and report any fatigue cracking found. This AD results from fatigue cracking at the wing center splice joint outboard fastener hole in one of the wing main spar lower caps. The AD number in the AD is incorrectly referenced as ``2006-23-01'' instead of ``2006- 23-09'' in two places. This document corrects these references.
Airworthiness Directives; Stemme GmbH & Co. AG Model STEMME S10-VT Sailplanes
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as ripped pressure lines between Airbox-Carburetor-Differential fuel pressure sensor. We are issuing this AD to require actions that are intended to address the unsafe condition described in the MCAI.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
