Department of Transportation May 2, 2016 – Federal Register Recent Federal Regulation Documents

Through this Notice, FRA announces its intent to jointly prepare an environmental impact statement (EIS) with the New Jersey Transit Corporation (NJ TRANSIT) for the Hudson Tunnel Project (the Proposed Action or the Project) under the National Environmental Policy Act (NEPA). The Proposed Action is intended to preserve the current functionality of the Northeast Corridor's (NEC) Hudson River rail crossing between New Jersey and New York and strengthen the resilience of the NEC. The Project would consist of construction of a new rail tunnel beneath the Hudson River, including railroad infrastructure in New Jersey and New York connecting the new rail tunnel to the existing NEC, and rehabilitation of the existing NEC tunnel beneath the Hudson River, referred to as the North River Tunnel. The EIS will evaluate the potential environmental impacts of a reasonable range of alternatives, including the No Action (No Build) Alternative. As appropriate, FRA and NJ TRANSIT will coordinate with the National Railroad Passenger Corporation (Amtrak), as owner of the North River Tunnel, and the Port Authority of New York and New Jersey (PANYNJ) on the EIS. FRA invites the public and all interested parties to provide comments on the scope of the EIS, including the proposed purpose and need, the Proposed Action and alternatives to be considered in the EIS, potential environmental impacts of concern and methodologies to be used in the EIS, the approach for public and agency involvement, and any other particular concerns about the potential impacts of the Proposed Action.

Before a federal agency may collect certain information from the public, the agency must receive approval from the Office of Management and Budget (``OMB''). Under procedures established by the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), before seeking OMB approval, federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatements of previously approved collections. In compliance with the Paperwork Reduction Act of 1995, this notice describes one collection of information for which NHTSA intends to seek OMB approval.

As required by the Paperwork Reduction Act of 1995, 44 U.S.C. 3501-3521 (PRA), the Surface Transportation Board (STB or Board) gives notice of its intent to seek approval from the Office of Management and Budget (OMB) for an extension of the Rail Depreciation Studies. This information collection is described in detail below. Comments are requested concerning: (1) The accuracy of the Board's burden estimates; (2) ways to enhance the quality, utility, and clarity of the information collected; (3) ways to minimize the burden of the collection of information on the respondents, including the use of automated collection techniques or other forms of information technology, when appropriate; and (4) whether the collection of information is necessary for the proper performance of the functions of the Board, including whether the collection has practical utility. Submitted comments will be summarized and included in the Board's request for OMB approval.

As required by the Paperwork Reduction Act of 1995, 44 U.S.C. 3501-3521 (PRA), the Surface Transportation Board (STB or Board) gives notice of its intent to seek approval from the Office of Management and Budget (OMB) for an extension of the system diagram maps, described below. Comments are requested concerning: (1) The accuracy of the Board's burden estimates; (2) ways to enhance the quality, utility, and clarity of the information collected; (3) ways to minimize the burden of the collection of information on the respondents, including the use of automated collection techniques or other forms of information technology, when appropriate; and (4) whether the collection of information is necessary for the proper performance of the functions of the Board, including whether the collection has practical utility. Submitted comments will be summarized and included in the Board's request for OMB approval.

We are adopting a new airworthiness directive (AD) for all Airbus Model A318-111 and -112 airplanes; Model A319-111, -112, -113, - 114, and -115 airplanes; Model A320-211, -212, and -214 airplanes; and Model A321-111, -112, -211, -212, and -213 airplanes. This AD was prompted by the results of an evaluation by the design approval holder (DAH). During a residual fatigue test, the forward engine mount failed prior to reaching the threshold/interval for the detailed inspections of the forward engine mounts specified in the airworthiness limitations. This AD requires repetitive detailed inspections of the right and left forward engine mounts, and corrective action if necessary. These inspections are required by AD 2015-05-02. This AD reduces the compliance times for those inspections. We are issuing this AD to detect and correct fatigue cracking in the forward engine mounts. Such cracking could result in reduced structural integrity of the airplane and could lead to in-flight loss of an engine, possibly resulting in reduced controllability of the airplane.

This action withdraws the NPRM published in the Federal Register on June 24, 2015, proposing to amend Class D and Class E airspace and remove Class E airspace in the Columbus, OH, area. The FAA has determined that withdrawal of that NPRM is warranted as a second NPRM for the same airspace action was issued in July 2015.

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. This AD was prompted by the discovery of a number of incorrectly calibrated angle of attack (AOA) transducers installed in the stall protection system. This AD requires replacement of incorrectly calibrated AOA transducers. We are issuing this AD to detect and replace incorrectly calibrated AOA transducers; incorrect calibration of the transducers could result in late activation of the stick pusher.

We are adopting a new airworthiness directive (AD) for certain Mitsubishi Heavy Industries, Ltd. Models MU-2B-30, MU-2B-35, MU-2B-36, MU-2B-36A, and MU-2B-60 airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as reports of cracks found in the attach fittings of the main landing gear oleo strut. We are issuing this AD to require actions to address the unsafe condition on these products.

We are superseding airworthiness directive (AD) 2014-12-51 for Airbus Helicopters (previously Eurocopter France) Model EC130B4 and EC130T2 helicopters. AD 2014-12-51 required repetitively inspecting the tailboom to Fenestron junction frame (junction frame) for a crack. This new AD retains the requirements of AD 2014-12-51, changes the applicability from helicopters with certain hours time-in-service (TIS) to junction frames with certain hours TIS, and adds a compliance time for sling cycles to the junction frame inspection interval. The actions of this AD are intended to detect a crack and to prevent failure of the junction frame, which could result in loss of the Fenestron and subsequent loss of control of the helicopter.

We are revising Airworthiness Directive (AD) 2015-09-04 for DG Flugzeugbau GmbH Model DG-1000T gliders equipped with a Solo Kleinmotoren Model 2350 C engine. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as engine shaft failure and consequent propeller detachment. We are issuing this AD to require actions to address the unsafe condition on these products.