Department of Transportation September 2013 – Federal Register Recent Federal Regulation Documents

This document announces receipt by the National Highway Traffic Safety Administration (NHTSA) of a petition for a decision that nonconforming 1988-1996 Alpina B10 passenger cars that were not originally manufactured to comply with all applicable Federal Motor Vehicle Safety Standards (FMVSS), are eligible for importation into the United States because they have safety features that comply with, or are capable of being altered to comply with, all such standards.

The Board has approved the fourth quarter 2013 rail cost adjustment factor (RCAF) and cost index filed by the Association of American Railroads. The fourth quarter 2013 RCAF (Unadjusted) is 0.975. The fourth quarter 2013 RCAF (Adjusted) is 0.423. The fourth quarter 2012 RCAF-5 is 0.399.

We propose to adopt a new airworthiness directive (AD) for all Dassault Aviation Model FALCON 2000EX airplanes. This proposed AD was prompted by a revision to the airplane airworthiness limitations to introduce a corrosion prevention control program, among other changes, to the maintenance requirements and airworthiness limitations. This proposed AD would require revising the maintenance program to include the maintenance tasks and airworthiness limitations specified in the airworthiness limitations section of the airplane maintenance manual. We are proposing this AD to prevent reduced structural integrity of the airplane.

We propose to adopt a new airworthiness directive (AD) for certain ATR-GIE Avions de Transport R[eacute]gional Model ATR42 and Model ATR72 airplanes. This proposed AD was prompted by reports of defective sealing between the nacelle lower fairing and the underwing box. This proposed AD would require a one-time general visual inspection for damaged (worn, torn, or abraded) or missing seals between the nacelle lower fairing and the underwing box of both the left-hand and right-hand engine nacelles, and replacement of the seal and/or shims if necessary. We are proposing this AD to prevent the decrease of the fire extinguishing agent efficiency, which could delay fire extinction and allow fire propagation out of the nacelle fire protected area, resulting in damage to the airplane.

We propose to supersede airworthiness directive (AD) 2013-07- 07, which applies to all The Boeing Company Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. AD 2013-07-07 requires inspecting to determine the part number of the attach pins of the horizontal stabilizer rear spar, and replacing certain attach pins. Since we issued AD 2013-07-07, we received inquiries from affected operators regarding the parts installation limitation and prohibition, and re-installation of certain attach pins that were removed for inspection. This proposed AD would clarify the parts installation limitation and prohibition, and would add a new requirement for certain airplanes on which certain attach pins were installed. We are proposing this AD to prevent premature failure of the attach pins, which could cause reduced structural integrity of the horizontal stabilizer to fuselage attachment, resulting in loss of control of the airplane.

We propose to supersede airworthiness directive (AD) 89-12-10, which applies to certain The Boeing Company Model 747 series airplanes. AD 89-12-10 currently requires replacement of certain underwing fuel tank access doors with stronger, fire-resistant doors. Since we issued AD 89-12-10, we have received reports indicating that a standard access door was located where an impact-resistant access door was required, and stencils were missing from some impact-resistant access doors. Stencils are required to indicate that the door is impact-resistant and to indicate the correct location for installation of the impact- resistant door. This proposed AD would require an inspection of the left- and right-hand wing fuel tank access doors to determine whether impact-resistant access doors are installed in the correct locations, and replacement of any door with an impact-resistant access door if necessary. This proposed AD would also require an inspection for the presence of stencils and index markers on impact-resistant access doors, and application of new stencils or index markers if necessary. This proposed AD would also require revising the maintenance program to incorporate changes to the airworthiness limitations section. This proposed AD would also add airplanes to the applicability. We are proposing this AD to prevent foreign object penetration of the fuel tank, which could cause a fuel leak near an ignition source (e.g., hot brakes or engine exhaust nozzle), consequently leading to a fuel-fed fire.

In accordance with the Paperwork Reduction Act of 1995 and its implementing regulations, the Federal Railroad Administration (FRA) hereby announces that it is seeking an extension of the following currently approved information collection activities. These information collection activities received a six-month emergency approval from OMB on August 29, 2013. FRA seeks this extension while it is determining the proper course of action to take to ensure that certain unattended trains and vehicles on mainline track or mainline siding outside of a yard or terminal, particularly ones transporting hazardous materials, are properly secured against unintended movement. Before submitting these information collection requirements for clearance by the Office of Management and Budget (OMB), FRA is soliciting public comment on specific aspects of the activities identified below.

PHMSA is amending the pipeline safety regulations to update the administrative civil penalty maximums for violation of the safety standards to reflect current law, to update the informal hearing and adjudication process for pipeline enforcement matters to reflect current law, and to make other technical corrections and updates to certain administrative procedures. The amendments do not impose any new operating, maintenance, or other substantive requirements on pipeline owners or operators.

We are adopting a new airworthiness directive (AD) for PILATUS AIRCRAFT LTD. Model PC-12/47E airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as common grounding of both the pilot primary flight display (PFD) and the Electronic Standby Instrument System (ESIS). If the common ground fails both navigations systems could fail simultaneously, which could result in loss of control. We are issuing this AD to require actions to address the unsafe condition on these products.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. This report is necessary to establish qualifications of eligibility to receive voluntary physiological training with the US Air Force and will be used as proper evidence of training. The information is collected from pilots and crewmembers for application to receive voluntary training.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. Flight plan information is used to govern the flight of aircraft for the protection and identification of aircraft and property and persons on the ground.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. A final rule published on January 16, 2007 (72 FR 1807) codified previous practices that permitted certificated air carriers to operate two-engine airplanes over long-range routes. The FAA uses this information collection to ensure that aircraft for long range flights are equipped to minimize diversions, to preclude and prevent diversions in remote areas, and to ensure that all personnel are trained to minimize any adverse impacts of a diversion.

This action proposes to establish Class E airspace at Donlin Creek Airport, Donlin Creek, AK. Controlled airspace is necessary to accommodate aircraft using the new Area Navigation (RNAV) Global Positioning System (GPS) standard instrument approach procedures at the airport. The FAA is proposing this action to enhance the safety and management of aircraft operations at the airport.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

PHMSA is issuing this safety advisory to notify the public of the unauthorized marking of high pressure compressed gas cylinders by Beauchesne Fire Equipment located at 21 Freeman St. Attleboro Falls, MA.

We propose to adopt a new airworthiness directive (AD) for all The Boeing Company Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes, and Model 777 airplanes. This proposed AD was prompted by testing reports on certain Honeywell phase 3 display units (DUs). These DUs exhibited susceptibility to radio frequency emissions in WiFi frequency bands at radiated power levels below the levels that the displays are required to tolerate for certification of WiFi system installations. The phase 3 DUs provide primary flight information including airspeed, altitude, pitch and roll attitude, heading, and navigation information to the flightcrew. This proposed AD would require replacing the existing phase 3 DUs with new phase 3A DUs and installing new DU database software. We are proposing this AD to prevent loss of flight-critical information displayed to the flightcrew during a critical phase of flight, such as an approach or takeoff, which could result in loss of airplane control at an altitude insufficient for recovery, or controlled flight into terrain or obstacles.

PHMSA proposes to amend the hazardous materials procedural found under our regulations. Specifically, this proposed action would prohibit a person who fails to pay a civil penalty as ordered, or fails to abide by a payment agreement, from performing activities regulated by the Hazardous Materials Regulations until payment is made.

We propose to supersede an existing airworthiness directive (AD) for Eurocopter France (Eurocopter) Model AS350B3 helicopters with a certain modification (MOD) installed. The existing AD currently requires installing two placards and revising the Rotorcraft Flight Manual (RFM). The AD also requires certain checks and inspecting and replacing, if necessary, all four laminated half-bearings (bearings). Since we issued that AD, we have determined that the unsafe condition applies to additional model helicopters, and that a recently developed Eurocopter modification should be a required terminating action for the repetitive checks required by the AD. This proposed AD would retain the existing AD requirements, require certain modifications which would be terminating action for the airspeed limitations, and would add certain helicopter models to the bearing inspection with a different inspection interval. The proposed actions are intended to prevent vibration due to a failed bearing, failure of the tail rotor, and subsequent loss of control of the helicopter.

In accordance with the Federal Advisory Committee Act, as amended, 5 U.S.C. app. 2 (FACA), notice is hereby given that the Surface Transportation Board (Board) intends to renew the charter of the Rail Energy Transportation Advisory Committee (RETAC).

This action corrects a final rule published in the Federal Register August 8, 2013 that establishes Class D airspace at Bryant Army Airfield (AAF), Anchorage, AK. In that rule, an error was made in the legal description for Bryant AAF, in that the language indicating Class D airspace as part time was left out.

This action establishes Class E airspace at the Wasatch VHF Omni-Directional Radio Range Tactical Air Navigational Aid (VORTAC) navigation aid, Wasatch, UT, to facilitate vectoring of Instrument Flight Rules (IFR) aircraft under control of Salt Lake City Air Route Traffic Control Center (ARTCC). This improves the safety and management of IFR operations within the National Airspace System. This action also makes a minor adjustment to the geographic coordinates of the Wasatch VORTAC navigation aid.

This notice announces actions taken by the FHWA and other Federal agencies that are final within the meaning of 23 U.S.C. 139(l)(1). The actions relate to a proposed highway project, State Highway 288, from (US) 59 south of downtown Houston, Harris County to County Road (CR) 60 in Brazoria County, Texas. Those actions grant licenses, permits, and approvals for the project.