Department of Transportation May 21, 2010 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for certain Hawker Beechcraft Corporation Model 390 airplanes. This proposed AD would require inspecting for installation of certain serial number (S/N) starter generators and replacing the starter generator if one with an affected serial number is found. This proposed AD results from reports that starter generators with deficient armature insulating materials may have been installed on certain airplanes. We are proposing this AD to detect and replace starter generators with defective armature insulating materials. This condition could result in the loss of operation of one or both starter generators with consequent loss of all non-battery electrical power.

This document corrects a notice served and published in the Federal Register on January 15, 2010 (75 FR 2580), titled ``Carolina Coastal Railway, Inc.Acquisition and Operation ExemptionNorth Carolina State Ports Authority'' to reflect a correction submitted by Carolina Coastal Railway, Inc. (CLNA). CLNA filed a verified notice of exemption under 49 CFR 1150.41 to acquire, by assignment, the lease of Morehead & South Fork Railroad Co., Inc. (MHSF) with North Carolina State Ports Authority (SPA) and to operate approximately 0.87 miles of SPA's rail line. After the effective date of the exemption, CLNA filed a letter on February 16, 2010, notifying the Board that MHSF's counsel has advised CLNA that MHSF is not a party to any lease agreement with SPA and therefore was not assigning a lease to CLNA. Instead, MHSF assigned a freight easement and operating agreement to CNLA.\1\ This notice correctly identifies MHSF, instead of SPA, as the regulated party to the transaction, corrects the title, and clarifies what was conveyed. Accordingly, the correct title should read, ``Carolina Coastal Railway, Inc.Acquisition and Operation ExemptionMorehead & South Fork Railroad Co.''

The FMCSA amends its regulations implementing section 215 of the Motor Carrier Safety Improvement Act of 1999 (MCSIA). The purpose of this rule is both to make amendments responding to petitions for reconsideration and to make technical corrections to a FMCSA regulation.

FMCSA announces its decision to exempt 19 individuals from the vision requirement in the Federal Motor Carrier Safety Regulations (FMCSRs). The exemptions will enable these individuals to operate commercial motor vehicles (CMVs) in interstate commerce without meeting the prescribed vision standard. The Agency has concluded that granting these exemptions will provide a level of safety that is equivalent to, or greater than, the level of safety maintained without the exemptions for these CMV drivers.

In accordance with the Paperwork Reduction Act of 1995, this notice announces the intention of the Federal Transit Administration (FTA) to request the Office of Management and Budget (OMB) to approve the revision of the currently approved information collection:

We are superseding an existing airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: * * * * *

We are superseding an existing airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for the specified ECF model helicopters. This AD results from a mandatory continuing airworthiness information (MCAI) AD issued by the European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community. The MCAI AD states that with certain pilot and copilot seats in the rear high position and seat backrest fully tilted the seat shoulder harness could become jammed between the seat and bulkhead. This condition, if not corrected, could result in the shoulder harness binding and causing the inertial reel to malfunction and no longer retain the flight crew member in the seat in the event of an emergency or hard landing.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: