Department of Transportation 2008 – Federal Register Recent Federal Regulation Documents

The FAA proposes to supersede an existing airworthiness directive (AD) that applies to all EMBRAER Model EMB-135 airplanes and Model EMB-145, -145ER, -145MR, -145LR, -145XR, -145MP, and -145EP airplanes. The existing AD currently requires replacing the metallic tubes enclosing the vent and pilot valve wires in the left- and right- hand wing fuel tanks with non-conductive hoses. This proposed AD would add airplanes to the applicability of the existing AD. This proposed AD results from fuel system reviews conducted by the manufacturer. We are proposing this AD to prevent an ignition source inside the fuel tank that could ignite fuel vapor and cause a fuel tank explosion and loss of the airplane.

We propose to adopt a new airworthiness directive (AD) for certain Boeing Model 727 airplanes. This proposed AD would require performing an operational test of the engine fuel suction feed of the fuel system, and other related testing if necessary. This proposed AD results from a report of in-service occurrences of loss of fuel system suction feed capability, followed by total loss of pressure of the fuel feed system. We are proposing this AD to detect and correct failure of the engine fuel suction feed of the fuel system, which could result in multi-engine flameout, inability to restart the engines, and consequent forced landing of the airplane.

This action corrects a typographical error that appeared in a final rule, which the FAA published in the Federal Register. In that final rule, the FAA inadvertently changed a word. The intent of this action is to correct the error in the regulation to ensure the requirement is clear and accurate.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below has been forwarded to the Office of Management and Budget (OMB) for review and comment. The ICR describes the nature of the information collection and its expected burden. A Federal Register Notice soliciting public comment on the ICR, with a 60-day comment period, was published on January 11, 2008 at 73 FR 2077.

The FAA invites public comments about our intention to request that the Office of Management and Budget (OMB) approve a current information collection. The information is required to carry out FAA missions related to the aviation industry, flight planning, and airport engineering.

The FAA invites public comrnents about our intention to request the Office of Management and Budget (OMB) to approve a current information collection. The rule requires passengers who intend to use an approved POC to present a physician statement before boarding.

The FAA invites public comments about our intention to request the Office of Management and Budget (OMB) to approve a current information collection. 14 CFR part 133 was adopted to establish certification rules and application requirements governing non passenger-carrying rotorcraft external-load operations conducted for compensation or hire.

The FAA invites public comments about our intention to request the Office of Management and Budget (OMB) to approve a current information collection. The FAA is amending its hazardous materials training requirements, requiring that certain repair stations provide documentation showing that persons handling hazmat for transportation have been trained following DOT guidelines.

The FAA invites public comments about our intention to request the Office of Management and Budget (OMB) to approve a current information collection. Information will be used to determine if licensees have complied with financial responsibility requirements (including maximum probable loss determination) as set forth in FAA regulations.

In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the applications described herein. This notice is abbreviated to expedite docketing and public notice. Because the sections affected, modes of transportation, and the nature of the applications have been shown in earlier Federal Register publications, they are not repeated here. Requests for modifications of special permits (e.g., to provide for additional hazardous materials, packaging design changes, additional mode of transportation, etc.) are described in footnotes to the application number. Application numbers with the suffix ``M'' denote a modification request. These applications have been separated from the new applications for special permits to facilitate processing.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is superseding an existing airworthiness directive (AD) that applies to all Boeing Model 747-400, 747-400D, and 747-400F series airplanes. That AD currently requires reviewing airplane maintenance records, doing repetitive inspections for cracking of the yaw damper actuator portion of the upper and lower rudder power control modules (PCMs), replacing the PCMs if necessary, and reporting all airplane maintenance records review and inspection results to the manufacturer. This new AD limits the applicability, reduces the initial inspection threshold and repetitive interval, removes the reporting requirement, and requires installation of a secondary retention device for the yaw damper modulating piston. Installation of the secondary retention device terminates the repetitive inspection requirements. This AD results from additional reports of failure or cracking of the PCM manifold in the area of the yaw damper cavity endcap at intervals well below the initial inspection threshold of the existing AD. We are issuing this AD to prevent an uncommanded left rudder hardover in the event of cracking in the yaw damper actuator portion of the upper or lower rudder PCMs, and subsequent failure of the PCM manifold, which could result in increased pilot workload, and possible runway departure upon landing.

The Federal Aviation Administration (FAA) announces that it is reviewing a proposed noise compatibility program that was submitted for Marana Regional Airport under the provisions of 49 U.S.C. 47501 et seq. (the Aviation Safety and Noise Abatement Act, hereinafter referred to as 'the Act'') and 14 CFR Part 150 by the Town of Marana, Arizona. This program was submitted subsequent to a determination by FAA that associated noise exposure maps submitted under 14 CFR Part 150 for Marana Regional Airport were in compliance with applicable requirements, effective December 7, 2007 (72 FR 71475). The proposed noise compatibility program will be approved or disapproved on or before December 3, 2008.

In accordance with the requirements of 49 U.S.C. 5117(c), PHMSA is publishing the following list of special permit applications that have been in process for 180 days or more. The reason(s) for delay and the expected completion date for action on each application is provided in association with each identified application.

In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR Part 107, Subpart B), notice is hereby given of the actions on special permits applications in (October to April 2008). The mode of transportation involved are identified by a number in the ``Nature of Application'' portion of the table below as follows: 1Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft. Application numbers prefixed by the letters EE represent applications for Emergency Special Permits. It should be noted that some of the sections cited were those in effect at the time certain special permits were issued.

As authorized by Pub. L. 105-383 and Pub. L. 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2008-0056 at https:// www.regulations.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Pub. L. 105-383 and MARAD's regulations at 46 CFR Part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR Part 388.

In accordance with the Paperwork Reduction Act of 1995, this notice announces the Maritime Administration's (MARAD's) intention to request extension of approval (with modifications) for three years of a currently approved information collection.

As authorized by Public Law 105-383 and Public Law 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2008-0059 at https:// www.regulations.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Public Law 105-383 and MARAD's regulations at 46 CFR part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.- flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR part 388.

As authorized by Public Law 105-383 and Public Law 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2008-0058 at https:// www.regulations.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Public Law 105-383 and MARAD's regulations at 46 CFR part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.- flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR part 388.

We propose to adopt a new airworthiness directive (AD) for certain Boeing Model 747-400, 747-400D, and 747-400F series airplanes. This proposed AD would require installing an extension tube to the existing pump discharge port of the scavenge pump on the outboard side of the center fuel tank in the main fuel tank 2. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to prevent a fire or explosion in the fuel tank and consequent loss of the airplane.