Department of Transportation June 13, 2008 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for all Lockheed Model 382, 382B, 382E, 382F, and 382G series airplanes. This proposed AD would require revising the FAA-approved maintenance program by incorporating new airworthiness limitations for fuel tank systems to satisfy Special Federal Aviation Regulation No. 88 requirements. This proposed AD would also require the accomplishment of certain fuel system modifications, the initial inspections of certain repetitive fuel system limitations to phase in those inspections, and repair if necessary. This proposed AD results from a design review of the fuel tank systems. We are proposing this AD to prevent the potential for ignition sources inside fuel tanks caused by latent failures, alterations, repairs, or maintenance actions, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.

The FAA is revising an existing airworthiness directive (AD) that applies to Sandel Avionics Incorporated Model ST3400 TAWS/RMI units as described above. The existing AD currently requires installing a warning placard on the TAWS/RMI and revising the Limitations section of the airplane flight manual (AFM). The existing AD also requires installing upgraded software in the TAWS/RMI. This new AD allows installing later revisions of the software described in the existing AD. This AD results from a report that an in-flight bearing error occurred in a Model ST3400 TAWS/RMI configured to receive bearing information from a very high frequency omnidirectional range (VOR) receiver interface via a composite video signal, due to a combination of input signal fault and software error. We are issuing this AD to prevent a bearing error, which could lead to an airplane departing from its scheduled flight path, which could result in a reduction in separation from, and a possible collision with, other aircraft or terrain.

This Rule establishes, amends, suspends, or revokes STANDARD Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

This technical amendment corrects an error in the airspace description of a final rule published in the Federal Register on July 21, 2003 (68 FR 42962), Docket No. FAA-2002-13013, Airspace Docket No. 02-ANM-10. In that rule, the description of Jet Route 10 (J-10) was incorrect. This is an administrative correction to a published legal description. Additionally, the cite for J-10 was incorrectly written as paragraph 6010(a) Domestic VOR Federal Airways: This will be corrected to ``paragraph 2006 Jet Routes''.