Department of Transportation October 18, 2006 – Federal Register Recent Federal Regulation Documents
Results 1 - 8 of 8
Interstate Oasis Program
The FHWA is issuing this approved final Interstate Oasis Program policy document. Section 1310 of the Safe, Accountable, Flexible, Efficient Transportation Equity Act: A Legacy for Users (SAFETEA-LU) (Public Law 109-59, August 10, 2005) requires the Secretary of Transportation to develop standards for designating certain facilities as Interstate Oases and to design a uniform logo for such designated facilities. After consideration of public comments on a draft program and policy document, the FHWA has finalized the policies for the Interstate Oasis program.
Special Conditions: Boeing Commercial Airplane Group, Boeing Model 777-200 Series Airplane; Overhead Cross Aisle Stowage Compartments
The FAA proposes special conditions for the Boeing Model 777- 200 series airplanes. This airplane, modified by Boeing Commercial Airplane Group, will have novel or unusual design features associated with overhead cross aisle stowage compartments. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for these design features. These proposed special conditions contain the additional safety standards the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Airworthiness Directives; Pratt & Whitney JT8D-1, -1A, -1B, -7, -7A, -7B, -9, -9A, -11, -15, -15A, -17, -17A, -17R, -17AR, -209, -217, -217A, -217C, and -219 Turbofan Engines
The FAA is revising an existing airworthiness directive (AD) for Pratt & Whitney (PW) JT8D-1, -1A, -1B, -7, -7A, -7B, -9, -9A, -11, -15, -15A, -17, -17A, -17R, -17AR, -209, -217, -217A, -217C, and -219 turbofan engines. That AD currently requires either replacing high pressure compressor (HPC) front hubs and HPC disks that have operated at any time with PWA 110-21 coating and that operated in certain engine models, or, visually inspecting and fluorescent penetrant inspecting (FMPI) for cracking of those parts and re-plating them if they pass inspection. This AD requires the same actions, but makes necessary corrections to inadvertent reference errors and omissions found in AD 2006-17-07, and relaxes some of the compliance times in Table 5. This AD results from our finding reference errors and omissions in AD 2006- 17-07, from determining that the AD as drafted imposed an unnecessary burden on operators if they have to immediately remove engines, and from requests to clarify compliance paragraphs. We are issuing this AD to prevent a rupture of an HPC front hub or an HPC disk that could result in an uncontained engine failure and damage to the airplane.
Transfer of Federally Assisted Land or Facility
Section 5334(g) of the Federal Transit Laws, as codified, 49 U.S.C. 5301 et seq., permits the Administrator of the Federal Transit Administration (FTA) to authorize a recipient of FTA funds to transfer land or a facility to a public body for any public purpose with no further obligation to the Federal Government if, among other things, no Federal agency is interested in acquiring the asset for Federal use. Accordingly, FTA is issuing this notice to advise Federal agencies that New Jersey Transit (NJT) intends to transfer the Union City Bus Maintenance Facility on New York Avenue in Union City, New Jersey, to the City of Union City. The property comprises one entire block and is bounded by Bergenline Avenue on the west, New York Avenue on the east, 29th Street on the north and 27th Street on the south. NJT no longer has a need for, and has not occupied the property for some time. Union City intends to use the property as a department of public works consolidated maintenance and storage facility for its fleet of vehicles, as well as create structured public parking and other uses.
Airworthiness Directives; Boeing Model 747-400, 777-200, and 777-300 Series Airplanes
This amendment adopts a new airworthiness directive (AD), applicable to certain Boeing Model 747-400, 777-200, and 777-300 series airplanes. This AD requires, for certain airplanes, replacing the cell stack of the flight deck humidifier with a supplier-tested cell stack, or replacing the cell stack with a blanking plate and subsequently deactivating the flight deck humidifier. For certain other airplanes, this AD requires an inspection of the flight deck humidifier to determine certain part numbers and replacing the cell stack if necessary. This AD also allows blanking plates to be replaced with cell stacks. The actions specified by this AD are intended to prevent an increased pressure drop across the humidifier and consequent reduced airflow to the flight deck, which could result in the inability to clear any smoke that might appear in the flight deck. This action is intended to address the identified unsafe condition.
Special Conditions: Dassault Aviation Model Falcon 7X Airplane; Interaction of Systems and Structures, Limit Pilot Forces, and High Intensity Radiated Fields (HIRF) Protection
This action proposes special conditions for the Dassault Aviation Model Falcon 7X airplane. This airplane will have novel or unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. These design features include interaction of systems and structures, limit pilot forces, and electrical and electronic flight control systems. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for these design features. These proposed special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Office of Hazardous Materials Safety; Notice of Application for Special Permits
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular special permit is requested is indicated by a number in the ``Nature of Application'' portion of the table below as follows: 1Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft.
Office of Hazardous Materials Safety; Notice of Applications for Modification of Special Permit
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. This notice is abbreviated to expedite docketing and public notice. Because the sections affected, modes of transportation, and the nature of application have been shown in earlier Federal Register publications, they are not repeated here. Request of modifications of special permits (e.g. to provide for additional hazardous materials, packaging design changes, additional mode of transportation, etc.) are described in footnotes to the application number. Application numbers with the suffix ``M'' denote a modification request. These applications have been separated from the new applications for special permits to facilitate processing.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
