Department of Transportation July 20, 2006 – Federal Register Recent Federal Regulation Documents
Results 1 - 19 of 19
National Environmental Policy Act (NEPA) Implementing Instructions for Airport Actions
On April 28, 2006, the Federal Aviation Administration's Office of Airports (ARP) issued a Notice of Availability for Order 5050.4B, National Environmental Policy Act (NEPA) Implementing Instructions for Airport Actions (71 FR 25279). Today's Notice alerts interested parties that ARP has posted an edited version of the Order at: https://www.faa.gov/airportsairtraffic/airports/resources/ publications/orders/environmental50504/. The newly posted Order corrects minor grammatical and spelling errors and incorrect paragraph citations present in the Order issued on April 28, 2006. The revisions do not change the Order's content.
Special Condition; Avidyne Corporation, Inc.; Various Airplane Models; Protection of Systems for High Intensity Radiated Fields (HIRF)
These amended special conditions are issued to Avidyne Corporation, 55 Old Bedford Road, Lincoln, MA 01773. This is an amendment to special condition 23-184-SC, which was published on May 23, 2006 (71 FR 29574), for installation of an EFIS manufactured by Avidyne on various models. The original issue left off the Cirrus Design Corporation SR22, which was the first model to be certified under the STC. The airplanes listed under this multi-model approval will have novel and unusual design features when compared to the state of technology envisaged in the applicable airworthiness standards. These novel and unusual design features include the installation of the Entegra II Avionics System, consisting of: (2) Model 700-0003-( ) Integrated Flight Displays (IFD), (2) Model 700- 00011-( ) Magnetometer/OAT sensors, and (1) Model 700-00085-000 Keyboard/Controller. These components are all manufactured by Avidyne Corporation, Inc. The applicable regulations do not contain adequate or appropriate airworthiness standards for the protection of these systems from the effects of high intensity radiated fields (HIRF). These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to the airworthiness standards applicable to these airplanes.
Qualification of Drivers; Exemption Applications; Vision
FMCSA announces its decision to exempt 47 individuals from the vision requirement in the Federal Motor Carrier Safety Regulations (FMCSRs). The exemptions will enable these individuals to operate commercial motor vehicles (CMVs) in interstate commerce without meeting the prescribed vision standard. The Agency has concluded that granting these exemptions will provide a level of safety that is equivalent to, or greater than, the level of safety maintained without the exemptions for these CMV drivers.
Airworthiness Directives; Honeywell International Inc. TPE331 Series Turboprop Engines
The FAA is adopting a new airworthiness directive (AD) for Honeywell International Inc. TPE331 series turboprop engines with certain part numbers of Woodward fuel control unit (FCU) assemblies installed. This AD requires initial and repetitive dimensional inspections of the fuel control drive, for wear or damage. This AD results from reports of loss of the fuel control drive, leading to engine overspeed, overtorque, overtemperature, uncontained rotor failure, and asymmetric thrust in multi-engine airplanes. We are issuing this AD to prevent destructive overspeed that could result in uncontained rotor failure, and damage to the airplane.
Environmental Impact Statement: Hamilton County, OH and Kenton County, KY
The FHWA is issuing this notice to advise the public that an Environmental Impact Statement (EIS) will be prepared for a proposed highway project in Hamilton County, Ohio and Kenton County, Kentucky. This Notice of Intent is a follow-up to a notice published in the Federal Register on June 1, 2000 which advised the public that a Major Investment Study for the I-75 Corridor (completed in 2004) served as the formal scoping process for the preparation of one or more Environmental Assessments or EISs.
Special Conditions; Cirrus Design Corporation SR22; Protection of Systems for High Intensity Radiated Fields (HIRF)
These amended special conditions are issued to Cirrus Design Corporation, 4515 Taylor Circle, Duluth, Minnesota 55811, for a Type Design Change. This special condition amends special condition 23-134- SC, which was published February 4, 2003 (68FR 5538), for installation of an Electronic Flight Instrument System (EFIS) manufactured by Avidyne Corporation on the SR22. This amendment covers additional electronic equipment, such as a digital autopilot and/or engine related systems designed to perform critical functions on the SR22 and other models listed on the same Type Data Sheet, A00009CH. The airplanes will have novel and unusual design features when compared to the state of technology envisaged in the applicable airworthiness standards. The applicable regulations do not contain adequate or appropriate airworthiness standards for the protection of these systems from the effects of high intensity radiated fields (HIRF). These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to the airworthiness standards applicable to these airplanes.
Special Conditions: Societe de Motorisation Aeronautiques (SMA) Engines, Inc., Cessna Models 182Q and 182R; Diesel Cycle Engine Using Turbine (Jet) Fuel
These special conditions are issued for the Cessna Models 182Q and 182R airplanes with a Societe de Motorisation Aeronautiques (SMA) Model SR305-230 aircraft diesel engine (ADE). This airplane will have a novel or unusual design feature(s) associated with the installation of a diesel cycle engine utilizing turbine (jet) fuel. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for installation of this new technology engine. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Airworthiness Directives; Mitsubishi Heavy Industries, Ltd. MU-2B Series Airplanes
We are adopting a new airworthiness directive (AD) for certain Mitsubishi Heavy Industries, Ltd. (MHI) MU-2B series airplanes. This AD requires you to incorporate text from the service information into the Limitations Section of the FAA-approved Airplane Flight Manual (AFM). This AD results from a recent safety evaluation that used a data-driven approach to analyze the design, operation, and maintenance of the MU-2B series airplanes in order to determine their safety and define what steps, if any, are necessary for their safe operation. Part of that evaluation was the identification of unsafe conditions that exist or could develop on the affected type design airplanes. Field reports indicate an unsafe condition of improper rigging and/or adjustment of the propeller feathering linkage. Service centers found the unsafe condition during inspections. We are issuing this AD to detect and correct improper rigging of the propeller feathering linkage. The above issue, if uncorrected, could result in degraded performance and poor handling qualities with consequent loss of control of the airplane.
Airworthiness Directives; Boeing Model 737-200, -300, and -400 Series Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Boeing Model 737-200, -300, and -400 series airplanes. This AD requires replacing the existing fueling float switch in the auxiliary fuel tank with a new, improved fueling float switch, installing a new liner system inside the float switch conduit, and performing related investigative and other specified actions. This AD results from reports of chafing of the direct-current-powered float switch wiring insulation in the center fuel tank. We are issuing this AD to prevent contamination of the fueling float switch of the auxiliary fuel tank by moisture or fuel, and chafing of the float switch wiring against the float switch conduit in the fuel tank, which could present an ignition source inside the fuel tank that could cause a fire or explosion.
Airworthiness Directives; Airbus Model A300 B2-203 and A300 B4-203 Airplanes; Model A300 B4-600, B4-600R, and F4-600R Series Airplanes, and Model C4-605R Variant F Airplanes (Collectively Called A300-600 Series Airplanes); and Model A310-200 and -300 Series Airplanes
The FAA is superseding an existing airworthiness directive (AD), which applies to certain Airbus Model A300 series airplanes and all Model A300-600 and A310 series airplanes. That AD currently requires repetitive inspections of the pitch trim system to detect continuity defects in the autotrim function, and follow-on corrective actions if necessary. For certain airplanes, this new AD requires replacing the flight augmentation computers (FACs) with new improved FACs. This AD also revises the applicability of the existing AD. This AD results from the development of a final action intended to address the unsafe condition. We are issuing this AD to prevent a sudden change in pitch due to an out-of-trim condition combined with an autopilot disconnect, which could result in reduced controllability of the airplane.
Airworthiness Directives; Airbus Model A300 B2 and B4 Series Airplanes; and Model A300 B4-600, B4-600R, and F4-600R Series Airplanes, and Model C4-605R Variant F Airplanes (Collectively Called A300-600 Series Airplanes)
The FAA is superseding two existing airworthiness directives (AD) that apply to certain Airbus Model A300 B2, A300 B4, and A300-600 series airplanes. One AD currently requires an inspection for cracks of the lower outboard flange of gantry No. 4 in the main landing gear (MLG) bay area, and repair if necessary. The other AD currently requires, among other actions, repetitive inspections of the gantry lower flanges, and repair if necessary. This new AD requires new repetitive inspections for cracks in the lower flange of certain gantries, and repair if necessary, which ends the existing inspection requirements. This new AD also provides for optional terminating actions for the new repetitive inspections. This AD results from a report of a large fatigue crack along the outboard flange of beam No. 4 and a subsequent determination that existing inspections are inadequate. We are issuing this AD to detect and correct fatigue cracks in the lower flanges of gantries 1 through 5 inclusive in the MLG bay area, which could result in reduced structural integrity of the fuselage, and consequent rapid decompression of the airplane.
Airworthiness Standards; Engine Bird Ingestion
The FAA is proposing to amend the aircraft turbine engine type certification standards to reflect recent analysis of the threat flocking birds present to turbine engine aircraft. These proposed changes would also harmonize FAA, Joint Aviation Authority (JAA), and European Aviation Safety Agency (EASA) bird ingestion standards for aircraft turbine engines type certificated by the United States and the JAA/EASA countries, and simplify airworthiness approvals for import and export. These proposed changes are necessary to establish uniform international standards that provide an adequate level of safety for aircraft turbine engines with respect to the current large flocking bird threat.
Public Notice for Waiver of Aeronautical Land-Use Assurance, Cambridge Municipal Airport, Cambridge, OH
The Federal Aviation Administration (FAA) is considering a proposal to change a portion of the airport from aeronautical use to non-aeronautical use and to authorize the release 4.105 acres of vacant airport property for an exchange of property between the Cambridge Area Regional Airport Authority and Dunning Investment Company, Ltd. The land was conveyed to the Cambridge Area Regional Airport Authority in Deed Volume 364, page 656 of the Recorder's Office, Guernsey County, Ohio. The land was acquired under FAA Project No. 3-39-0013-0303. There are no impacts to the airport by allowing the airport to dispose of the property. Approval does not constitute a commitment by the FAA to financially assist in the disposal of the subject airport property nor a determination of eligibility for grant-in-aid funding from the FAA. In exchange, the Cambridge Regional Airport Authority will receive a parcel of land adjacent to Cambridge Municipal Airport. This parcel is necessary to meet design standards for future airport development as indicated on the Airport Layout Plan for Cambridge Municipal Airport. In accordance with section 47107(h) of title 49, United States Code, this notice is required to be published in the Federal Register 30 days before modifying the land-use assurance that requires the property to be used for an aeronautical purpose.
Notice of Passenger Facility Charge (PFC) Approvals and Disapprovals
The FAA publishes a monthly notice, as appropriate, of PFC approvals and disapprovals under the provisions of the Aviation Safety and Capacity Expansion Act of 1990 (Title IX of the Omnibus Budget Reconciliation Act of 1990) (Pub. L. 101-508) and Part 158 of the Federal Aviation Regulations (14 CFR Part 158). This notice is published pursuant to paragraph d of Sec. 158.29.
U.S. Institute for Environmental Conflict Resolution; Request for Public Participation in National Outdoor Advertising Control Program Assessment
The FHWA and the U.S. Institute have initiated an assessment of the national outdoor advertising control (OAC) program, which implements the provisions of 23 U.S.C. 131. The goal of the assessment is to reach out, through a neutral entity, to parties interested in OAC to identify issues that cause controversy, perspectives of the various stakeholders, and appropriate methods for addressing conflicts and improving program results. The U.S. Institute, operating under an interagency agreement with the FHWA, is responsible for carrying out the neutral conflict assessment process. This notice describes the first of several opportunities for public participation in the assessment process. At this time, the public is invited to identify any OAC issues that should be considered during the assessment. The public also is invited to suggest persons or entities with particular interests or expertise in outdoor advertising and the OAC program, that the assessors should consider contacting as a part of the assessment proceedings.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
