Federal Aviation Administration December 15, 2021 – Federal Register Recent Federal Regulation Documents

This action proposes special conditions for The Boeing Company (Boeing) Model 737-10 airplane. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport-category airplanes. This design feature is single-occupant, passenger oblique seats, with airbag devices and 3-point restraints, installed at 49 degrees relative to the airplane cabin bow-to-stern centerline. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These proposed special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

The Federal Aviation Administration (FAA) announces its determination that the Noise Exposure Maps submitted by the Naples Airport Authority for the Naples Municipal Airport under the provisions of the Aviation Safety and Noise Abatement Act and are in compliance with applicable requirements.

The FAA is adopting a new airworthiness directive (AD) for all Rolls-Royce Deutschland Ltd. & Co KG (RRD) Trent 7000-72 and Trent 7000-72C model turbofan engines. This AD was prompted by the manufacturer revising the engine Time Limits Manual (TLM) life limits of certain critical rotating parts and updating certain maintenance tasks. This AD requires the operator to revise the airworthiness limitation section (ALS) of their existing approved continuous airworthiness maintenance program (CAMP) by incorporating the revised tasks of the applicable TLM for each affected model turbofan engine, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPS) and associated Takeoff Minimums and Obstacle Departure procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

The FAA is superseding Airworthiness Directive (AD) 2019-01- 08, which applied to certain The Boeing Company Model 777-200, -200LR, -300, and -300ER series airplanes. AD 2019-01-08 required modifications for galley mounted attendant seat fittings. This AD was prompted by a report that showed a non-compliance exists on some in-service galley attendant seat fitting installations, and a determination that additional airplanes are subject to the unsafe condition. This AD requires modifications for galley mounted attendant seat fittings. The FAA is issuing this AD to address the unsafe condition on these products.