Federal Aviation Administration November 28, 2008 – Federal Register Recent Federal Regulation Documents

Airworthiness Directives; Honeywell International Inc. ALF502L-2 and ALF502L-2C Turbofan Engines
Document Number: E8-28269
Type: Proposed Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to adopt a new airworthiness directive (AD) for Honeywell International Inc. ALF502L-2 and ALF502L-2C turbofan engines with certain high-pressure compressor (HPC) first stage discs installed. This proposed AD would require performing a dimensional inspection to determine if excessive disc balance material was removed and a magnetic particle inspection if the disc passes the dimensional inspection. This proposed AD results from reports of discs found with excessive material removed from the balancing material of the disc. We are proposing this AD to prevent the discs from fracturing before reaching the currently published life limit. A disc fracture could result in an uncontained failure of the disc and damage to the airplane.
RTCA Program Management Committee
Document Number: E8-28238
Type: Notice
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
The FAA is issuing this notice to advise the public of a meeting of the RTCA Program Management Committee.
Airworthiness Directives; MD Helicopters, Inc. Model 500N and 600N Helicopters
Document Number: E8-28110
Type: Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
This document supersedes AD 2008-18-52 and publishes in the Federal Register an amendment adopting Emergency Airworthiness Directive (AD) 2008-22-52 which was sent previously to all known U.S. owners and operators of MD Helicopters, Inc. (MDHI) Model 500N and 600N helicopters by individual letters. This AD requires turning OFF the Yaw Stability Augmentation System (YSAS); installing a placard that limits airspeed to 100 KTS or VNE, whichever is less; and revising the limitations section of the Rotorcraft Flight Manual (RFM) to reflect that limitation. Finally, replacing the adapter tubes with airworthy adapter tubes that have a production date code stamp is required. This AD is prompted by several occurrences of failed adapter tubes on the Model MD900 helicopter which uses the same adapter tubes. The actions specified by this AD are intended to prevent loss of yaw control and subsequent loss of control of the helicopter.
Airworthiness Directives; MD Helicopters, Inc. Model 600N Helicopters
Document Number: E8-28108
Type: Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
This document corrects airworthiness directive (AD) 2008-20-05 which was published on October 10, 2008 (73 FR 60102) and applies to MD Helicopters, Inc. (MDHI) Model 600N helicopters. AD 2008-20-05 requires modifying the fuselage aft section, repetitively inspecting the tailboom attachment fittings, installing inspection holes and attachment bolt washers, modifying both access covers, and replacing broken attachment bolts. This document corrects the AD number that is incorrectly listed as 2008-20-08 on page 60104 of the AD.
Airworthiness Directives; Bombardier Model BD-700-1A10 and BD-700-1A11 Airplanes
Document Number: E8-28103
Type: Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Pratt & Whitney Canada Corp. JT15D-5; -5B; -5F; and -5R Turbofan Engines
Document Number: E8-28062
Type: Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as follows:
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
Document Number: E8-28035
Type: Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
This establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Special Conditions: Embraer Model EMB-500 Series Airplane Special Conditions for Flight Performance, Flight Characteristics, and Operating Limitations
Document Number: E8-28025
Type: Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
These special conditions are issued for the Embraer Model EMB- 500 series airplane. This airplane will have a novel or unusual design feature(s) associated with engine location, certain performance, flight characteristics and operating limitations necessary for this type of airplane. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Airworthiness Directives; Airbus Model A330-200, A330-300, A340-300, A340-500, and A340-600 Series Airplanes
Document Number: E8-27940
Type: Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
We are superseding an existing airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Boeing Model 737-600, -700, -700C, -800 and -900 Series Airplanes
Document Number: E8-27926
Type: Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Boeing Model 737-600, -700, -700C, -800 and -900 series airplanes. This AD requires an inspection of the escape slides for the forward and aft entry and service doors to determine the part number and service bulletin number stenciled on the escape slide girt, and modification of the escape slide assemblies. This AD also requires concurrent modification of the escape slide latch assemblies; concurrent inspection of the escape slides to determine the part number and service bulletin number stenciled on the escape slide girts, and replacement of the trigger housing on the regulator valve with an improved trigger housing if necessary; and concurrent replacement of the rod in the pilot valve regulator with a new, improved rod; as applicable. This AD results from reports that certain escape slides did not automatically inflate when deployed or after the manual inflation cable was pulled. We are issuing this AD to prevent failure of an escape slide to inflate when deployed, which could result in the slide being unusable during an emergency evacuation and consequent injury to passengers or crewmembers.
Airworthiness Directives; Vulcanair S.p.A. Model P68 Series Airplanes
Document Number: E8-27916
Type: Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Rolls-Royce plc Models RB211 Trent 768-60, Trent 772-60, and Trent 772B-60 Turbofan Engines
Document Number: E8-27298
Type: Rule
Date: 2008-11-28
Agency: Federal Aviation Administration, Department of Transportation
The FAA is superseding an existing airworthiness directive (AD) for Rolls-Royce plc (RR) models RB211 Trent 768-60, Trent 772-60, and Trent 772B-60 turbofan engines that have not incorporated RR Service Bulletin (SB) No. RB.211-72-E708, SB No. RB.211-72-F227, or SB No. RB.211-72-E965, at original issue or later revision. That AD currently requires initial and repetitive borescope inspections of the high-pressure/intermediate-pressure (HP/IP) turbine bearing internal oil vent tube, scavenge tube, and tube heat shields for wear and cracking, and removing tubes from service if found with any cracks beyond serviceable limits. That AD also currently requires installation of a new or modified HP/IP turbine bearings support as terminating action for the repetitive borescope inspections. This AD has the same requirements, and adds a repetitive inspection of the vent flow restrictor for blockage. This AD results from RR revising their alert service bulletin for inspection of the HP/IP turbine bearing internal oil vent tube, scavenge tube, and tube heat shields for damage, to include a repetitive inspection of the vent flow restrictor for blockage. We are issuing this AD to prevent oil ejecting from the HP/IP turbine bearings chamber and igniting. Burning oil can cause the intermediate-pressure (IP) shaft to fracture, the IP turbine to overspeed, and possible uncontained failure of the engine.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.