Federal Aviation Administration October 13, 2006 – Federal Register Recent Federal Regulation Documents

Membership in the National Parks Overflights Advisory Group
Document Number: E6-17030
Type: Notice
Date: 2006-10-13
Agency: Federal Aviation Administration, Department of Transportation
By Federal Register notice (See 71 FR 16610; April 3, 2006), the National Park Service (NPS) and the Federal Aviation Administration (FAA), asked interested persons to apply to fill six vacant positions on the National Parks Overflights Advisory Group (NPOAG) Aviation Rulemaking Committee (ARC). The vacancies represent general aviation (one vacancy), commercial air tour operators (two vacancies), environmental concerns (two vacancies) and Native American tribes (one vacancy), and invited interested persons to apply to fill the vacancies due to completion (October 9, 2006) of a three-year term appointment. This notice informs the public of the persons selected to fill the vacancies on the NPOAG ARC.
Airworthiness Directives; Airbus Model A318, A319, A320, and A321 Airplanes
Document Number: E6-17006
Type: Proposed Rule
Date: 2006-10-13
Agency: Federal Aviation Administration, Department of Transportation
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The proposed AD would require actions that are intended to address the unsafe condition described in the MCAI.
Airworthiness Directives; Bombardier Model DHC-8-400 Series Airplanes
Document Number: E6-17005
Type: Proposed Rule
Date: 2006-10-13
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to supersede an existing airworthiness directive (AD) that applies to certain Bombardier Model DHC-8-400 series airplanes. The existing AD currently requires revising the airplane flight manual (AFM) to advise the flightcrew of appropriate procedures to follow in the event that a main landing gear (MLG) fails to extend following a gear-down selection. The existing AD also currently requires repetitive replacement of the left and right MLG uplock assemblies with new assemblies; and an inspection of the left and right MLG uplock rollers for the presence of an inner low friction liner, and corrective actions if necessary. This proposed AD would revise the requirement for replacing the left and right MLG uplock assemblies by allowing replacement with alternative parts. For a certain MLG uplock assembly, this proposed AD would require repetitive inspections of the uplock hatch lower jaw for the presence of a wear groove and replacement with an improved part if necessary. For a certain MLG uplock assembly, this proposed AD also would require repetitive inspections of the uplock roller to ensure that it rotates freely and replacement with a new part if necessary. This proposed AD would allow optional replacement of the left and right MLG uplock assemblies with improved parts, which ends the requirements of the AFM revision and repetitive replacement and inspections. This proposed AD would remove airplanes from the applicability. This proposed AD results from development of a terminating action. We are proposing this AD to ensure that the flightcrew has the procedures necessary to address failure of an MLG to extend following a gear-down selection; and to detect and correct such failure, which could result in a gear-up landing and possible injury to passengers and crew.
Airworthiness Directives; McDonnell Douglas Model 717-200 Airplanes
Document Number: E6-17004
Type: Proposed Rule
Date: 2006-10-13
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to adopt a new airworthiness directive (AD) for certain McDonnell Douglas Model 717-200 airplanes. This proposed AD would require replacing certain attaching hardware of the bulkhead nipple assemblies of the left and right wing vent boxes with new electrical bonding attaching hardware, doing resistance testing of the new electrical bonds, and doing fuel leakage testing of the reworked nipple assemblies. This proposed AD results from fuel system reviews conducted by the manufacturer. We are proposing this AD to provide a conductive path, from the bulkhead nipple assemblies of the left and right wing vent boxes to the airframe structure inside the wing fuel tanks, to dissipate high amperage lightning-induced currents which might otherwise create an ignition source for fuel vapors inside the wing vent boxes and lead to an explosion of the fuel tanks.
Airworthiness Directives; McDonnell Douglas Model DC-10-10, DC-10-10F, DC-10-15, DC-10-30, and DC-10-30F (KC-10A and KDC-10) Airplanes; Model DC-10-40 and DC-10-40F Airplanes Equipped With Pratt & Whitney JT9-20 or JT9-20J Engines; and Model MD-10-10F and MD-10-30F Airplanes
Document Number: E6-17003
Type: Proposed Rule
Date: 2006-10-13
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to adopt a new airworthiness directive (AD) for the McDonnell Douglas airplanes previously described. This proposed AD would require replacing the control modules of the fire detection systems of the propulsion engines with new, improved control modules. This proposed AD results from a report of broken or severed wiring between engine fire detectors and the fire detection system control module, which caused the fire detection system to become non-functional without flightcrew awareness. We are proposing this AD to prevent unannunciated fire in a propulsion engine, which could cause injury to flightcrew and passengers or loss of the airplane.
Airworthiness Directives; Empresa Brasileira de Aeronautica S.A. (EMBRAER) Model EMB-135BJ and EMB-145XR Airplanes
Document Number: E6-16895
Type: Rule
Date: 2006-10-13
Agency: Federal Aviation Administration, Department of Transportation
This amendment adopts a new airworthiness directive (AD), applicable to certain Empresa Brasileira de Aeronautica S.A. (EMBRAER) Model EMB-135BJ and Model EMB-145XR airplanes. This AD requires, for all airplanes, installation of an additional indication device to the clear-ice indication system. For certain airplanes, this AD requires replacing the existing clear-ice indication lamp with a new, improved lamp. For certain other airplanes, this AD also requires modifying certain electrical connections to add an indication device to the clear-ice indication system, removing a certain placard, and re- activating the clear-ice additional indicator lamp. The actions specified by this AD are intended to prevent undetected build-up of clear ice on the wing surfaces, which could lead to reduced controllability of the airplane. This action is intended to address the identified unsafe condition.
Airworthiness Directives; Cirrus Design Corporation Models SR20 and SR22 Airplanes
Document Number: E6-16741
Type: Rule
Date: 2006-10-13
Agency: Federal Aviation Administration, Department of Transportation
The FAA adopts a new airworthiness directive (AD) for certain Cirrus Design Corporation (CDC) Models SR20 and SR22 airplanes. This AD requires you to check the maintenance records to determine whether the brake caliper piston O-ring seals were replaced at the last annual or 100-hour inspection. If the O-rings were not replaced, this AD requires you to replace the O-ring seals with new seals or replace brake calipers. This AD also requires you to modify the main landing gear wheel fairings to add temperature indicator sticker inspection holes, trim the wheel fairings to prevent them from holding fluids, install temperature indicator stickers on the brake calipers, and insert Revision A6 (with revised preflight walk-around, a limitation on the engine speed used to taxi, and brake inspection/servicing intervals) into the Pilot's Operating Handbook (POH). This AD results from several reports of airplanes experiencing brake fires and two airplanes losing directional control. We are issuing this AD to detect, correct, and prevent overheating damage to the brake caliper piston O-ring seals, which could result in leakage of brake hydraulic fluid. Consequently, this could lead to the loss of braking with loss of airplane directional control or brake fire.
Modification of the Class B Airspace Area; Atlanta, GA
Document Number: 06-8688
Type: Rule
Date: 2006-10-13
Agency: Federal Aviation Administration, Department of Transportation
This action makes minor modifications to the floor of the Atlanta, GA, Class B airspace area in order to contain large, turbine- powered aircraft within Class B airspace during simultaneous triple instrument landing system (STILS) operations at the Hartsfield-Jackson Atlanta International Airport (ATL). In addition, this action makes two editorial changes to the Atlanta Class B airspace legal description. The FAA is taking this action to enhance safety and to prevent significant air traffic delays in the National Airspace System (NAS).
Ninth Meeting: RTCA Special Committee 207/Airport Security Access Control Systems
Document Number: 06-8666
Type: Notice
Date: 2006-10-13
Agency: Federal Aviation Administration, Department of Transportation
The FAA is issuing this notice to advise the public of a meeting of RTCA Special Committee 207, Airport Security Access Control Systems.
Operating Limitations at Chicago O'Hare International Airport; Notice of Order
Document Number: 06-8658
Type: Notice
Date: 2006-10-13
Agency: Federal Aviation Administration, Department of Transportation
On September 22, 2006, the FAA issued an order to show cause, which solicited written views on modifying the August 2004 Order temporarily limiting scheduled operations at O'Hare International Airport (O'Hare) to allow carriers to trade and transfer scheduled arrivals for consideration for the remaining duration of the Order. The FAA is issuing a final modification to the Order based on the proposal.
Amending the Congestion and Delay Reduction at Chicago O'Hare International Airport
Document Number: 06-8651
Type: Rule
Date: 2006-10-13
Agency: Department of Transportation, Federal Aviation Administration
The FAA published a final rule on August 29, 2006, (71 FR 51382), to address persistent flight delays from overscheduling at O'Hare International Airport (O'Hare). This amendment revises section 93.25, ``Initial assignment of Arrival Authorizations to U.S. and Canadian air carriers for domestic and U.S./Canada transborder service,'' to direct the FAA to assign each U.S. and Canadian conducting scheduled service at O'Hare by January 27, 2007, Arrival Authorizations based on their permanent holdings as of the 7-day period of October 22 through October 28, 2006, as evidenced by the FAA's records. While the FAA is making this rule effective without notice and comment, the FAA invites the public to comment on the amendment. The FAA will consider the comments to see whether the rule should be further modified.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.