Federal Aviation Administration January 23, 2024 – Federal Register Recent Federal Regulation Documents

The FAA is adopting a new airworthiness directive (AD) for all Bombardier, Inc., Model BD-100-1A10 airplanes. This AD was prompted by reports from the supplier that some overheat detection sensing elements of the bleed air leak detection system were manufactured with insufficient salt fill, which can result in an inability to detect hot bleed air leaks. This AD requires revising the existing airplane flight manual (AFM) to include procedures to prevent takeoff with an active bleed air leak annunciated while on the ground. This AD also requires testing the overheat detection sensing elements, marking each serviceable sensing element with a witness mark, and replacing each nonserviceable part with a serviceable part. This AD also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain General Electric Company (GE) Model GE90-90B, GE90-94B, GE90- 110B1, and GE90-115B engines. This AD was prompted by a manufacturer investigation that revealed certain high-pressure turbine (HPT) stage 1 disks, HPT stage 2 disks, forward HPT rotor seals, interstage HPT seals, and stages 7-9 compressor rotor spools were manufactured from powder metal material suspected to contain iron inclusion. This AD requires replacement of affected HPT stage 1 disks, HPT stage 2 disks, forward HPT rotor seals, interstage HPT seals, and stages 7-9 compressor rotor spools. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2023-01- 07 for all GE Aviation Czech s.r.o. (GEAC) (type certificate previously held by WALTER Engines a.s., Walter a.s., and MOTORLET a.s.) Model H75- 100, H75-200, H80, H80-100, H80-200, H85-100, and H85-200 engines. AD 2023-01-07 required revising the airworthiness limitations section (ALS) of the existing engine maintenance manual (EMM) and the operator's existing approved maintenance or inspection program, as applicable, to incorporate updated coefficients and recalculate the cycles accumulated on critical parts. Since the FAA issued AD 2023-01- 07, the manufacturer revised the ALS of the EMM to introduce new and more restrictive airworthiness limitations and associated thresholds and intervals for life-limited parts, which prompted this AD action. This AD requires revising the ALS of the existing EMM and the operator's existing approved engine maintenance or inspection program, as applicable, to incorporate new and more restrictive instructions and associated thresholds and intervals for life-limited parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference (IBR). The FAA is issuing this AD to address the unsafe condition on these products.