Federal Aviation Administration December 20, 2021 – Federal Register Recent Federal Regulation Documents
Results 1 - 7 of 7
Petition for Exemption; Summary of Petition Received; The Boeing Company
This notice contains a summary of a petition seeking relief from specified requirements of Federal Aviation Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.
Airworthiness Directives; Viking Aircraft Limited Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Viking Air Limited Model DHC-3 airplanes. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI identifies the unsafe condition as fatigue damage of the wing strut lug fitting components and the fuselage to wing strut attachment (tie-bar). This AD requires determining service life limits for the wing strut fitting on the main spar and for the tie-bar and following instructions for removal and replacement of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Daher Aerospace (Type Certificate Previously Held by SOCATA) Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Daher Aerospace (type certificate previously held by SOCATA) (Daher) Model TBM 700 airplanes. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The unsafe condition that is the subject of the MCAI is ice accumulation on the oil cooler air inlet duct fin. This AD requires modifying the oil cooler air induction duct. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Leonardo S.p.a. Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Leonardo S.p.a. Model A109S and AW109SP helicopters. This AD was prompted by the discovery that rubber protection of certain electrical wiring had not been installed in the baggage avionics bay during production. This AD requires installing protective rubber borders on the edge of the baggage avionics bay frames, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Leonardo S.p.a. Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Leonardo S.p.a. Model AW189 helicopters. This AD was prompted by the determination that certain part-numbered fairings were never introduced into the main rotor (MR) tip lights kit design definition and were not certified for icing conditions. This AD requires replacing affected parts. This AD also prohibits, after modification of the helicopter as required, installing any affected part on any helicopter as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Various Model 234 and Model CH-47D Helicopters
The FAA is adopting a new airworthiness directive (AD) for various Model 234 and Model CH-47D helicopters. This AD was prompted by two reports of mechanical failures of the longitudinal cyclic trim actuator (LCTA). This AD requires determining the maintenance history, and hours time-in-service (TIS) and number of lift cycles for each LCTA since last overhaul, and then requires initial and repetitive overhauls of each LCTA based on that maintenance and service history. This AD also prohibits installing an LCTA unless it meets certain requirements. Finally, this AD requires reporting certain information to the FAA. The FAA is issuing this AD to address the unsafe condition on these products.
Agency Information Collection Activities: Requests for Comments; Clearance of a Renewed Approval of Information Collection: Flight and Duty Limitations and Rest Requirements-Flightcrew Members
In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The collection involves reporting exceeded flight duty periods and flight times, including scheduled maximum and actual flight duty periods and flight times, basic flight information (e.g., city pairs, departure times, flight number), and reason for exceedance. Reporting and recordkeeping are required any time a certificated air carrier has exceeded a maximum daily flight time limit or a maximum daily Flight Duty Period (FDP) limit. It is also required for the voluntary development of a Fatigue Risk Management System (FRMS), and for fatigue training. The information is necessary to monitor trends in exceedance and possible underlying systemic causes requiring operator action, and to determine whether operator is scheduling realistically.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.