Federal Aviation Administration December 6, 2021 – Federal Register Recent Federal Regulation Documents
Results 1 - 13 of 13
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320-211, -212, -214, -216, -231, -232, and - 233 airplanes; and Model A321-111, -112, -131, -211, -212, -213, -231, and -232 airplanes. This AD was prompted by a report that during re- engineering of galley G5, a 9G forward full scale qualification test was performed, and the door of the waste compartment opened before the required load was reached. This AD requires modifying the waste compartment door of each affected galley, as specified in a European Aviation Safety Agency (EASA) AD, which is incorporated by reference The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; The Boeing Company Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 and 787-9 airplanes. This AD was prompted by reports that shimming requirements were not met during the assembly of certain structural joints, which can result in reduced fatigue thresholds of the affected structural joints. This AD requires repetitive inspections for cracking of certain areas of the front spar pickle fork and front spar outer chord and repair of any cracking found. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; The Boeing Company Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 and 787-9 airplanes. This AD was prompted by reports that shimming requirements were not met during the assembly of certain structural joints, which can result in reduced fatigue thresholds and cracking of the affected structural joints. This AD requires repetitive inspections for cracking of certain areas of the aft wheel well bulkhead (AWWB) body chord and AWWB side fitting and failsafe straps, and repair of any cracking found. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc., Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-100-1A10 airplanes. This AD was prompted by reports of erratic electrical system status on the push button annunciators (PBAs) and the engine instrument and crew alerting system (EICAS). This AD requires revising the existing airplane flight manual (AFM) to incorporate procedures to be applied during erroneous electrical status indication conditions. The FAA is issuing this AD to address the unsafe condition on these products.
Amendment of Class E Airspace; Galesburg, IL
This action amends the Class E airspace at Monmouth Municipal Airport, Monmouth, IL, contained within the Galesburg, IL, airspace legal description. This action is the result of an airspace review caused by the decommissioning of the Galesburg very high frequency (VHF) omnidirectional range (VOR) as part of the VOR Minimal Operational Network (MON) Program.
Airworthiness Directives; Hoffmann GmbH & Co. KG Propellers
The FAA is superseding Airworthiness Directive (AD) 2020-25-05 for all Hoffmann GmbH & Co. KG (Hoffmann) model HO-V 72 propellers. AD 2020-25-05 required amending the existing aircraft flight manual (AFM) with abnormal propeller vibration instructions. AD 2020-25-05 also required visual inspection and non-destructive test (NDT) inspection of the propeller hub and, depending on the results of the inspections, replacement of the propeller hub with a part eligible for installation. AD 2020-25-05 also required replacement of the propeller hub before exceeding 30 years since the date of manufacture. This AD was prompted by reports of cracks at different positions on two affected propeller hubs and subsequent manufacturer revision of the service information, which showed that the 30-year life limit of the propeller hub is no longer needed. This AD requires amending the existing AFM by inserting abnormal propeller vibration instructions, visual inspection and NDT inspection of the propeller hub and, depending on the results of the inspections, replacement of the propeller hub with a part eligible for installation. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Leonardo S.p.a Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Leonardo S.p.a. Model AW109SP helicopters. This AD was prompted by reports of an ineligible hydraulic pump being installed on Model AW109SP helicopters. This AD requires inspecting each hydraulic pump for damage and, depending on the inspections results, removing parts from service and accomplishing other corrective actions. This AD also requires removing certain parts from service before they exceed their life limits. The corrective actions are required to be accomplished as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Leonardo S.p.a. Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Leonardo S.p.a. Model A109E helicopters. This AD was prompted by reports of cracking in the center fuselage frame assembly in the intersection of the lateral pylon and floor spar at station (STA) 1815 on the left- and right-hand sides. This AD requires repetitive inspections of the intersection of the lateral pylon and floor spar at STA 1815 for cracking and, depending on the findings, repair, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; MD Helicopters Inc. (MDHI) Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain MD Helicopters Inc. (MDHI), Model 369D, 369E, 369F, 369FF, 369H, 369HE, 369HM, 369HS, 500N, and 600N helicopters. This AD was prompted by a report of a spiral crack in the pilot-to-copilot tail rotor torque tube (torque tube). This AD requires a one-time visual and recurring borescope inspections of the torque tube and depending on the results, removing the torque tube from service. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Learjet Inc. Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Learjet Inc. Model 45 airplanes. This AD was prompted by a report of a fuel leak due to a cracked fuel line between the engine fuel control and the engine fuel flow meter. This AD requires replacing the existing fuel flow meter bracket assembly with a redesigned bracket assembly and reporting information to the FAA. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Learjet Inc. Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Learjet Inc. (Learjet) Model 45 airplanes. This AD was prompted by reports of corrosion found on the upper surface of the lower center wing mid spar splice plate. This AD requires repetitively inspecting the center wing area for corrosion and deterioration of protective treatments, removing any corrosion, and treating any deteriorated areas. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; ASI Aviation (Type Certificate Previously Held by Reims Aviation S.A.) Airplanes
The FAA is superseding Airworthiness Directive (AD) 2015-16-07 R1, which applied to certain Reims Aviation S.A. (type certificate now held by ASI Aviation) Model F406 airplanes. AD 2015-16-07 R1 required inspecting the left-hand and right-hand rudder control pedal torque tubes and replacing with a serviceable part as necessary. Since the FAA issued AD 2015-16-07 R1, the European Aviation Safety Agency (EASA) superseded its mandatory continuing airworthiness information (MCAI) to correct an unsafe condition on these products. This AD retains the requirements of AD 2015-16-07 R1, expands the applicability, and requires repeating the inspections using updated procedures. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Schempp-Hirth Flugzeugbau GmbH Gliders
The FAA proposes to adopt a new airworthiness directive (AD) for all Schempp-Hirth Flugzeugbau GmbH Model Ventus-2a and Ventus-2b gliders. This proposed AD was prompted by mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as severe corrosion on the inboard flaperon actuation push rods and ball bearing connecting the flaperon push rod to the bell crank inside the wing. This proposed AD would require inspecting the affected parts of the flaperon control in the wings and taking corrective actions if necessary. The FAA is proposing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.