Federal Aviation Administration March 17, 2021 – Federal Register Recent Federal Regulation Documents

The FAA is superseding Airworthiness Directive (AD) 2018-16- 02, which applied to all Airbus SAS Model A318-111 and -112 airplanes; Model A319-111, -112, -113, -114, and -115 airplanes; Model A320-211, - 212, -214, and -216 airplanes; and Model A321-111, -112, -211, -212, and -213 airplanes. AD 2018-16-02 required modifying and re-identifying the 3-lug aft engine mount assemblies. This AD continues to require modifying and re-identifying the 3-lug aft engine mount assemblies, and also requires modifying and re-identifying the 4-lug aft engine mount assemblies; as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD was prompted by a report of a production quality deficiency on the inner retainer installed on link assemblies of the aft engine mount, which could result in failure of the retainer. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for Leonardo S.p.a. (Leonardo) Model AW189 helicopters. This AD was prompted by two reported failures of the tail plane installation forward bolts (bolts). This AD requires inspecting the bolts and depending on the results of those inspections, removing certain parts from service or installing a tail plane retromod. This AD also requires torqueing certain part-numbered nuts, inspecting bolts and nuts for wear, and depending on the results of those inspections, removing parts from service. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is correcting a notice of proposed rulemaking (NPRM) that published in the Federal Register. The NPRM proposed to issue an airworthiness directive (AD) that would apply to certain Mooney International Corporation (Mooney) Model M20V airplanes. As published, the docket number referenced throughout is incorrect. This document corrects that error. In all other respects, the original document remains the same; however, for clarity, the FAA is publishing the entire proposed rule in the Federal Register.

These special conditions are issued for the Leonardo S.p.A. (Leonardo) Model A119 and AW119 MKII helicopters. These helicopters as modified by AgustaWestland Philadelphia Corporation (AWPC) will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for helicopters. This design feature is the optional closed circuit refueling receiver (CCRR). The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.