Federal Aviation Administration September 10, 2019 – Federal Register Recent Federal Regulation Documents
Results 1 - 6 of 6
Amendment of the Class E Airspace; Ashland, KY
This action modifies the Class E airspace extending upward from 700 feet above the surface at Ashland Regional Airport, Ashland, KY. This action is due to an airspace review caused the revision of the instrument procedures at the airport, which require additional airspace. The name of the airport are also being updated to coincide with the FAA's aeronautical database.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A330-200 Freighter, -200, and -300 series airplanes; and certain Airbus SAS Model A340-200, -300, -500, and -600 series airplanes. This AD was prompted by a determination that certain wing slat tracks that were inadvertently indicated as eligible for installation on all Model A330 and A340 series airplanes are unable to sustain the ultimate loads relative to the weight variant of certain airplane configurations. This AD requires identifying affected parts, inspecting for and repairing cracks, and replacing affected parts with serviceable parts, as specified in a European Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Establishment of Class D and E Airspace; Wichita, KS
This action establishes Class D airspace and Class E airspace designated as surface area, at Beech Factory Airport, Wichita, KS. This action is for the safety and management of instrument flight rules (IFR) operations at the airport.
Airworthiness Directives; International Aero Engines AG Turbofan Engines
The FAA is adopting a new airworthiness directive (AD) for certain International Aero Engines AG (IAE) V2500 model turbofan engines. This AD was prompted by an inspection that determined that material anomalies exist in certain low-pressure turbine (LPT) stage 6 disks. This AD requires removal from service of the affected LPT stage 6 disks and their replacement with a part eligible for installation. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Pratt & Whitney Turbofan Engines
The FAA proposes to adopt a new airworthiness directive (AD) for all Pratt & Whitney (PW) PW1519G, PW1521G, PW1521GA, PW1524G, PW1525G, PW1521G-3, PW1524G-3, PW1525G-3, PW1919G, PW1921G, PW1922G, PW1923G, and PW1923G-A model turbofan engines. This proposed AD was prompted by reports of in-flight shutdowns due to oil leaking from the connection between the LP10 oil supply tube and the fuel oil cooler (FOC). This proposed AD would require initial and repetitive gap inspections of the LP10 oil supply tube and the FOC and, if a gap is found, replacement of these parts. This proposed AD further requires removal of these parts at the next engine shop visit. The FAA is proposing an AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters Deutschland GmbH
The FAA is adopting a new airworthiness directive (AD) for Airbus Helicopters Deutschland GmbH (Airbus Helicopters) Model EC135P1, EC135P2, EC135P2+, EC135P3, EC135T1, EC135T2, EC135T2+, and EC135T3 helicopters. This AD requires inspecting certain part-numbered actuators for corrosion, and removing them from service as necessary. This AD also requires reporting certain information to Airbus Helicopters. This AD is prompted by a hard landing of a helicopter and discovery of a ruptured and displaced tie bar inside the piston of the longitudinal single-axis actuator of the main rotor actuator (MRA). The actions of this AD are intended to address an unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
