Federal Aviation Administration December 6, 2018 – Federal Register Recent Federal Regulation Documents
Results 1 - 13 of 13
Noise Exposure Map Notice; Receipt of Noise Compatibility Program and Request for Review; Westover Airport; Chicopee and Ludlow, Massachusetts
The Federal Aviation Administration (FAA) announces its determination that the noise exposure map for Westover Airport is in compliance with applicable requirements. The FAA also announces that it is reviewing a proposed noise compatibility program that was submitted for Westover Airport in conjunction with the noise exposure map, and that this program will be approved or disapproved on or before May 6, 2019.
Notice of Intent of Waiver With Respect to Land; Prairie Du Chien Municipal Airport, Prairie Du Chien, WI
The FAA is considering a proposal to change 0.38 acres of Clear Zone Easement contained in Parcel 17 to Avigation Easement in exchange for converting 1.23 acres of Avigation Easement contained in Parcel 20 to Clear Zone Easement. Both Parcel 17 and Parcel 20 share a common boundary and are owned by Crossing Rivers Health Center located at Prairie du Chien Municipal Airport, Prairie du Chien, WI. The proposed release of 0.38 acres of Clear Zone Easement to Avigation Easement is not in the Runway Protection Zone (RPZ). Of the easement being converted to Clear Zone from Avigation Easement in exchange for the release, 0.89 acres (of the 1.23 acres) lies in the RPZ, which brings that portion of the RPZ into conformance with FAA standards and policies. The release of 0.38 acres from Clear Zone Easement to Avigation Easement is required to build an Access Road to the Crossing Rivers Health Center and install a sign for the hospital. The conversion from Clear Zone Easement to Avigation Easement will not result in any impact to surfaces protected by Part 77 or airport design surfaces. The Clear Zone Easement was originally purchased to enable the Airport to ensure airport compatible development. The proposed future use of 0.38 acres of the land as an access road will prevent any incompatible development of the surrounding area in the RPZ.
Special Conditions: Textron Aviation Inc. Model 700 Airplane; Operation Without Normal Electrical Power
These special conditions are issued for the Textron Aviation Inc. (Textron) Model 700 airplane. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport-category airplanes. These design features are electrical and electronic systems that perform critical functions, the loss of which could be catastrophic to the airplane. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for these design features. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Agency Information Collection Activities: Requests for Comments; Clearance of Renewed Approval of Information Collection: Commercial Air Tour Operator Reports
In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval for to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on September 19, 2018. The commercial air tour operational data provided to the FAA and the National Park Service will be used by the agencies as background information useful in the development of air tour management plans and voluntary agreements for purposes of meeting the mandate of the National Parks Air Tour Management Act (NPATMA) of 2000.
Airworthiness Directives; Rolls-Royce plc Turbofan Engines
We are superseding airworthiness directive (AD) 2018-13-07 for all Rolls-Royce plc (RR) Trent 1000-A, Trent 1000-C, Trent 1000-D, Trent 1000-E, Trent 1000-G, and Trent 1000-H turbofan engine models. AD 2018-13-07 required initial inspections of the intermediate-pressure compressor (IPC) stage 1 rotor blades, IPC stage 2 rotor blades, and IPC shaft stage 2 dovetail posts, and removing any cracked parts from service. This AD requires initial inspections and adds repetitive inspections of the IPC stage 1 rotor blades, IPC stage 2 rotor blades, and IPC shaft stage 2 dovetail posts, and removing any cracked parts from service. This AD was prompted by the manufacturer determining the need for repetitive inspections of the IPC stage 1 rotor blades, IPC stage 2 rotor blades, and IPC shaft stage 2 dovetail posts. We are issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; The Boeing Company Airplanes
We are adopting a new airworthiness directive (AD) for all The Boeing Company Model 737-8 and -9 airplanes. This emergency AD was sent previously to all known U.S. owners and operators of these airplanes. This AD requires revising certificate limitations and operating procedures of the airplane flight manual (AFM) to provide the flight crew with runaway horizontal stabilizer trim procedures to follow under certain conditions. This AD was prompted by analysis performed by the manufacturer showing that if an erroneously high single angle of attack (AOA) sensor input is received by the flight control system, there is a potential for repeated nose-down trim commands of the horizontal stabilizer. We are issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Pacific Aerospace Limited Airplanes
We are adopting a new airworthiness directive (AD) for Pacific Aerospace Limited Model 750XL airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as insufficient clearance between the pitot tubes and the primary support at the flame arrester intersection. We are issuing this AD to require actions to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
We are adopting a new airworthiness directive (AD) for certain Airbus SAS Model A318, A319, A320, and A321 series airplanes. This AD was prompted by an evaluation by the design approval holder (DAH) indicating that the principal structural elements and certain life- limited parts are subject to widespread fatigue damage (WFD). This AD requires revising the existing maintenance or inspection program to incorporate new or more restrictive airworthiness limitations. We are issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; The Boeing Company Airplanes
We propose to adopt a new airworthiness directive (AD) for all The Boeing Company Model 737-100, -200, -200C, -300, -400, and -500 series airplanes. This proposed AD was prompted by reports of cracks caused by corrosion of the edge of the bore of the spot face and corrosion of the lug bore of certain side-strut support fitting lugs. This proposed AD would require repetitive detailed inspections of the left and right side-strut support fitting lugs with bushings installed for any corrosion, any crack, or any severed lug; repetitive detailed and high frequency eddy current (HFEC) inspections of the left and right side-strut support fitting lugs with bushings removed for any corrosion or any crack; and applicable on-condition actions. We are proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
We propose to adopt a new airworthiness directive (AD) for certain Airbus SAS Model A330-201, -202, and -203, and Model A330-301, -302, and -303 airplanes. This proposed AD was prompted by reports of damaged drain pipes located above the lower aft pylon fairing (LAPF), caused by a contact between the drain pipe and the two u-shape ribs of the LAPF. This proposed AD would require a special detailed inspection for damage and corrective actions, if necessary. We are proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Rockwell Collins, Inc. Flight Management Systems
We propose to adopt a new airworthiness directive (AD) for certain Rockwell Collins, Inc. (Rockwell Collins) flight management systems (FMS) installed on airplanes. This proposed AD was prompted by reports of the flight management computer (FMC) software issuing incorrect turn commands when the altitude climb field is edited or the temperature compensation is activated on the FMS control display unit. This proposed AD would require disabling the automatic temperature compensation feature of the FMS through the configuration strapping units (CSU) and revising the airplane flight manual (AFM) Limitations section. We are proposing this AD to address the unsafe condition on these products.
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
This rule amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide for the safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.