Federal Aviation Administration February 9, 2016 – Federal Register Recent Federal Regulation Documents
Results 1 - 9 of 9
Petition for Exemption; Summary of Petition Received; Bowhead Mission Solutions
This notice contains a summary of a petition seeking relief from specified requirements of Title 14 of the Code of Federal Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.
Petition for Exemption; Summary of Petition Received; Sky-Futures USA, Inc.
This notice contains a summary of a petition seeking relief from specified requirements of Title 14 of the Code of Federal Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.
Notice of Intent To Rule on Request To Release Airport Property at the Monroe Regional Airport at Monroe, Louisiana.
The FAA proposes to rule and invite public comment on the release of land at the Monroe Regional Airport at Monroe, Louisiana under the provisions of Section 125 of the Wendell H. Ford Aviation Investment Reform Act for the 21st Century (AIR 21).
Sixty-Seventh Meeting: RTCA Special Committee (135) Environmental Conditions and Test Procedures for Airborne Equipment
The FAA is issuing this notice to advise the public of the Sixty-Seventh RTCA Special Committee 135 meeting.
Seventh Meeting; RTCA Special Committee (229) Aircraft Emergency Locator Transmitters (ELTs) (Joint With EUROCAE WG-98)
The FAA is issuing this notice to advise the public of the Seventh RTCA Special Committee 229 meeting.
Twelfth Meeting; RTCA Tactical Operations Committee (TOC)
The FAA is issuing this notice to advise the public of the Twelfth RTCA Tactical Operations Committee meeting.
Airworthiness Directives; Turbomeca S.A. Turboshaft Engines
We are adopting a new airworthiness directive (AD) for all Turbomeca S.A. ARRIEL 2C, 2C1, 2C2, 2S1, and 2S2 turboshaft engines with modification TU34 or TU34A installed. This AD requires inspecting the torque conformation box (TCB) for correct resistance values and removing TCBs that fail inspection before further flight. This AD was prompted by TCB failures. We are issuing this AD to prevent failure of the TCB, loss of engine thrust control, and damage to the helicopter.
Airworthiness Directives; Rolls-Royce plc Turbofan Engines
We are adopting a new airworthiness directive (AD) for all Rolls-Royce plc (RR) RB211-535E4-37, RB211-535E4-B-37, and RB211-535E4- C-37 turbofan engines. This AD requires recalculating the cyclic life for certain engine life-limited rotating parts and removing those parts that have exceeded their cyclic life limit within specified compliance times. This AD was prompted by a review of operational data that determined certain RR RB211-535E4-37 engines have been operated to a more severe flight profile than is consistent with the flight profile used to establish the cyclic life limits for the rotating parts. We are issuing this AD to prevent failure of life-limited rotating parts, uncontained parts release, damage to the engine, and damage to the airplane.
Airworthiness Directives; Airbus Helicopters Deutschland GmbH Helicopters
We are superseding airworthiness directive (AD) 2014-13-01 for Airbus Helicopters Deutschland GmbH (Airbus Helicopters) Model MBB-BK 117 C-2 helicopters with a certain Goodrich rescue hoist damper unit (damper unit) installed. AD 2014-13-01 required repairing or replacing the damper unit or deactivating the rescue hoist. AD 2014-13-01 was prompted by a report of an uncommanded detachment of a damper unit from the cable. This new AD retains the optional requirement of deactivating the rescue hoist, expands the applicability, and requires either replacing or modifying the damper unit with a newly developed single- piece retainer. These actions are intended to prevent the hoist damper unit detaching from the cable resulting in loss of an external load or person from the helicopter hoist and injury to persons being lifted by the hoist.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.