Federal Aviation Administration July 28, 2014 – Federal Register Recent Federal Regulation Documents

Departing IFR/VFR When Weather Reporting Is Not Available
Document Number: 2014-17729
Type: Rule
Date: 2014-07-28
Agency: Federal Aviation Administration, Department of Transportation
This action will permit the pilot in command of a helicopter air ambulance to assess the weather at a departure point where current weather observations are not available and allow the pilot to depart if the observed ceiling and visibility is greater than certain weather minimums. This action will allow a pilot to utilize the minimum takeoff visibilities depicted in a published obstacle departure procedure, or in the absence of such a procedure, when the pilot observed ceiling and visibility is greater than the minimum ceiling and visibility limitations required by specific helicopter air ambulance rules. This change to the current regulation will permit helicopter air ambulance flights to enter the National Airspace System under Instrument Flight Rules when visibilities and ceilings are below Visual Flight Rules, thus increasing the safety of the flight.
Airworthiness Directives; Dassault Aviation Airplanes
Document Number: 2014-17465
Type: Rule
Date: 2014-07-28
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Dassault Aviation Model FALCON 7X airplanes. This AD was prompted by a report of a crew alerting system message caused by an inversion of the wiring in the slats control manifold (SCM). This AD requires an operational test of the SCM, and replacing the affected SCM with a serviceable SCM if necessary. We are issuing this AD to detect and correct inversion of the wiring in the SCM, which could lead to a commanded retraction of the median and outboard slats in flight, and result in reduced controllability of the airplane.
Airworthiness Directives; Bombardier, Inc. Airplanes
Document Number: 2014-17316
Type: Rule
Date: 2014-07-28
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model DHC-8-102, -103, -106, -201, -202, -301, -311, and -315 airplanes. This AD was prompted by reports of a fractured wing-to-fuselage strut attachment joint bolt. This AD requires a torque check of all wing-to-fuselage strut attachment joint bolts, and repair or replacement if necessary. For certain airplanes, this AD also requires a detailed inspection for corrosion, damage, and wear of each wing-to-fuselage strut attachment joint bolt and associated hardware, and replacement if necessary; and a borescope inspection for corrosion and damage of the bore hole and barrel nut threads, and repair or replacement if necessary. We are issuing this AD to detect and correct fractured strut attachment joint bolts, which could result in reduced structural integrity of the wing-to-fuselage strut attachment joint and subsequent loss of the wing.
Airworthiness Directives; Airbus Airplanes
Document Number: 2014-17313
Type: Rule
Date: 2014-07-28
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Airbus Model A310-304, -322, -324, and -325 airplanes. This AD was prompted by reports of insufficient clearance between the fuel quantity indicator (FQI) probes and the adjacent structure and metallic components in the wing fuel tanks. This AD requires a one-time detailed visual inspection for sufficient clearance between FQI probes on both the left-hand side and right-hand side of the trim horizontal stabilizer and the adjacent structure and metallic components in the fuel tanks, and modification if necessary. We are issuing this AD to detect and correct insufficient clearance, which could lead to electrical arcing in a fuel tank during a lightning strike, which could result in ignition and consequent fire or explosion in the fuel tank.
Airworthiness Directives; The Boeing Company Airplanes
Document Number: 2014-17312
Type: Rule
Date: 2014-07-28
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 747-100B SUD, 747-200B, 747-300, 747-400, and 747-400D series airplanes. This AD was prompted by an evaluation by the design approval holder (DAH) indicating that the upper deck tension ties are subject to widespread fatigue damage (WFD). This AD requires repetitive inspections for cracking in the upper deck tension ties, and related investigative and corrective actions if necessary; tension tie replacement; and post-replacement repetitive inspections for cracking in the upper deck tension ties, and related investigative and corrective actions if necessary. We are issuing this AD to detect and correct fatigue cracking of the upper deck tension ties. Severed or disconnected tension ties at multiple locations could result in rapid decompression and loss of structural integrity of the airplane.
Airworthiness Directives; Fokker Services B.V. Airplanes
Document Number: 2014-17297
Type: Rule
Date: 2014-07-28
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for all Fokker Services B.V. Model F.28 Mark 0070 and 0100 airplanes. This AD was prompted by reports that the bracket of the rod in the carbon fiber reinforced plastic (CFRP) main landing gear (MLG) outboard door had detached. In addition, we received reports of broken recessed heads on titanium attachment bolts of the operating rod brackets on the modified CFRP MLG outboard doors. This AD requires a detailed inspection of the CFRP MLG outboard door for play or cracks in the recessed countersunk heads of the operating rod bracket attachment bolts; replacement of the bolt if necessary; and, for certain airplanes, modification of the CFRP MLG outboard doors and attachment to the MLG. We are issuing this AD to detect and correct the affected MLG from moving to the down and locked position, which could result in MLG collapse during landing or roll- out, and consequent damage to the airplane and injury to passengers.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.